An audio amplifier with resistance 7 supplies power to a speaker. In order that maximum power is delivered, what should be the resistance of the speaker? The resistance of the speaker should be ΙΩ.

Q: QUESTION 4 What is the cut-off wavelength (mm) of an air-filled 3.1 cm x 2 cm rectangular waveguide…

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: § 4.3 Fixed-Bias Circuit PROBLEMS 3. Given the information appearing in Fig. 4.75, determine: (a)…

A: Fixed bias circuit is given  it is asked to find collector current( Ic) , supply voltage( Vcc),…

Q: Q5. Figure Q4 How does the electrostatic force between two charges is affected when the distance…

A:

Q: What is the average power of a 2V 10kHz sine wave in dB? Answer in 30 mins or less.

A: We need to find out the power for given signal ,

Q: Consider the circuit below, with C₁ = 1F, C₂ 1F and L=3H, calculate the node voltages V₁ and V₂.…

A:

Q: Question 4 Consider an LTI system with frequency response: 1+e-j2 te -j4w H(ej") = -π<ωΣπ 1+2e-j40…

A:

Q: 2 The rms value of the primary voltage, Vpri of a transformer with centre tapping in Figure 2 is…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: 6. A continuous-space signal sc is given by Sc(X1, Xx2) = 100 + 20cos6лx₁ + 40sin (10¬x₁ +67x²) for…

A: Given: In this question, the given details are, A continuous-space signal SC is given by,…

Q: Why answer has been changed, before it was with Equation Operators. now I see it like this in…

A: It is given that: re=10.71 Ω

Q: 22. For the circuit in Figure Q.2; v₁ = 10sin(wt) mV: ) Find vo if I = 50μA? ) Find I so that the…

A:

Q: The average power density in a wave incident on a building is 3.2 kW/m². If the reflection…

A: Given, The power density of incident wave is  Pdi = 3.2 kW/m2 Reflection coefficient, K = 0.3 We…

Q: Two loads A and B are connected in parallel across a 2000 V-rms 60 Hz source with the specified…

A: Note Only active power will be available in purely R Load Only Reactive power will be available in…

Q: Table 2: Measured Voltage Gain versus Frequency with Vs(p-p) = 0.2 V Frequency (Hz) Voutp-p) (V) Ay=…

A: Given that, we have Vs(p-p)=0.2 V, various frequency &amp; Vout(p-p) We have to find gain Av &amp;…

Q: What are the types of signal degradations that may be encountered in transmission over the channel ?

A: The objective is to determine the the types of signal degradation

Q: Q.1 OpAmp Linear Circuits How fast can the output of an Op-amp change by 20 V if its slew rate is…

A: Given- The sine wave output voltage, V0=20 V Slew rate, S.R.=2 Vμsec   To find- Time taken to change…

Q: a 7223 MI". 32V it is 188 INN MK 11₁ 324 122 b 3822 Find Va, Vb, Vab Is, I,

A: In this question We need to determine the voltage at the node a and b. And also find the Current IS…

Q: Question # 1: A unity feedback system with the forward transfer function G(S) = Do the following: K…

A: Given data OLTF, Gs=Kss+7 Feedback, Hs=1 Peak overshoot, %Mp=15% We need to determine the settling…

Q: GIVEN THE NETWORK BELOW, DERIVE THE TRANSFER FUNCTION BY FILLING ALL VALUES BELOW 10 ka 1kQ + 100 kQ…

A:

Q: 3. The torque applied to move the pointer is 279.8x10-6 N/m-¹ and it creates the 0.859 Wbm-²…

A:

Q: An electric heater is designed to operate at 660W from a 120V source. If the source voltage drops to…

A:

Q: Question 13 Evaluate the Cross product; ax(-2a +3a,) A. -2a-3a, -2a+3a, B. C. D. A B C OD -3 ax-2a,…

A:

Q: a. If you do not go completely around the loop when applying Kirchhoff’s voltage law, then the…

A: Given, a) what will happen If we do not go completely around the loop when applying Kirchhoff’s…

Q: Question 7 amplifiers are ideal. Find the gain (Avvo/v.) of the circuit in Figure 12. You may assume…

A:

Q: In a very long cylinder of radius R flows distributed, distribution a current I. The current is…

A: Given, In a very long cylinder of radius R flows a current I. The current is volumetrically…

Q: Problem 02.034 - Equivalent resistance seen by a source Using series/parallel resistance…

A:

Q: Find the numerical expression for the transter function: Vo(s) Vi(s)

A:

Q: Determine the angle by which v1 lags i1 if v1 = 34 cos (10t + 125°) and it is equal to (a) 5 cos…

A: In the given questions we need to find the phase difference between current and voltage.

Q: For the common emitter transistor amplifier shown below, find the value of the coupling capacitor C₁…

A: To calculate the cutoff frequency due to coupling capacitor C1, we need to draw the small signal…

Q: A transformer, circuit breaker is equipped with 500/5 A CTS connected to a induction type over…

A: Given- A transformer, circuit breaker is equipped with 500/5 A CTs connected to a induction type…

Q: capacitor 3.jpg b ε(cp) Consider a coaxial capacitor of length L, with inner conductor of radius a…

A: Given data Length of the coaxial capacitor is L. Inner radius is a Outer radius is b Relative…

Q: Obtain the Thevenin and Norton equivalent circuit at terminals a-b of the circuit shown

A: Given, We need to determine the Thevenin and Norton equivalent circuit at terminals a-b of the…

Q: entical antennas of gain =4dB operating at 2.4 GHz. the received power if the range =3 m?

A:

Q: A load connected to a transmission line (Zo= 10092) produces a reflection coefficient of 0.5272°.…

A: At each point along the transmission line, the input impedance is fixed and equal to its…

Q: The following traces are taken using an oscilloscope from an RC circuit with a 100 Ω resistor and a…

A: Given, The following traces are taken using an oscilloscope from an RC circuit having  R= 100 ohm C…

Q: Two resistors X and Y and a battery are connected in parallel. The current through the resistor Y is…

A: Given, Two resistors X and Y and a battery are connected in parallel. The current through Y resistor…

Q: E "100 V T= 30 KO === 20 KO S vc (100ms) 10 ko Figure 18: What is the time constant value (TRC) What…

A: Time constant

Q: Cod Re V Cgs Vs ↓ ဆန်းဝင်း ယား gs S roRD RI me high frequency small signal model of a common source…

A:

Q: An electric heater is designed to operate at 660W from a 120V source. If the source voltage drops to…

A:

Q: Consider the circuit shown below. Assuming that the switch is closed at t= 0, calculate v(t) for t >…

A: given circuit problem. we have to calculate voltage

Q: 32. The figure below shows a working surface illuminated by two light sources. What is the total…

A:

Q: Find the output y[n] for the system below. x(t) = 1 + 2cos(20nt + 45³) H(e) = (4 + 2cos(w))e-j²…

A:

Q: Exercise 7 In the circuit of figure 1 below, the diode is characterized by its internal resistor rd…

A: As per the guidelines of bartleby i need to answer first question only if there are multiple…

Q: EX) The normalized radiation intensity of antenna is defined by V(0) = (os (0) Find The HP BW FN BW…

A:

Q: Exercise 2 Plot the Bode diagram of the following open-loop transfer function G(s) = 2000(s +0.5)…

A:

Q: Calculate v, in the circuit 10 cos (10t+ 75°) (+) 0.5 H 10 Q2 -18 F 10+

A:

Q: Example: A 32/4 dipole is radiating into free-space. Input power to the dipole is 100 W. Assuming an…

A: The given problem is from antenna theory. The detailed solution is given in the next step

Q: Draw polar plot for the following open loop ?

A: The given open-loop transfer function is written below. Gs=20s2+s+0.5ss+1s+10. We need to draw the…

Q: A solid cylindrical conductor has a radius of 5mm and a conductivity that varies as a function of…

A: Given: A solid cylindrical conductor with a radius r=5 mm and length l=20 m has a conductivity that…

Q: 2.2 Suppose a sinusoidal voltage of ±10 V with a frequency of 500 HZ is to be displayed on an…

A: The given problem is from measurements and instrumentation.  The detailed solution is given in the…

Q: In the circuit in (Figure 1), the load absorbs 115 VA at a lagging power factor of 0.6. Figure + 1Ω…

A:

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.