An earth dam require a total of 150 cubic meter of soil compacted with a bulk unit weight of 18.5KN/m^3 and moisture content of 10%, the specific gravity of solid particles is 2.55. Choose two out of the three borrow pits, if borrow pit 3 is automatically one of the choice. Choose the most economical choice.

Q: Slope-Deflection Equation Calculate the end moments and joint rotations for the continuous beam show...

A: Use equation of slope deflection.

Q: A reinforced concrete beam has a width of 300 mm and an overall depth of 480 mm. The beam is simply ...

A:

Q: Discuss the primary advantages and disadvantages of bidding for: (a) public work; (b) private work.

A: Tendering Process under development is a course of presenting a proposition to attempt government de...

Q: Calculate the location of the center of pressure, Lp, to in m to the nearest 1000th. Fluid: Orange P...

A: NOTE : as per our guidelines we are supposed to  answer only one question. Kindly repost the another...

Q: The rigid bar AB is supported by two rods made of the same material. If the bar is horizontal before...

A: Length of bar at A, L1 =2ftCross sectional area of bar at A, AA =0.4in2Length of bar at B, LB=3ftCro...

Q: Draw the axial force, shear and moment diagram of the figure shown.

A: If a load is applied to the structure along the length or perpendicular to the cross-section of the ...

Q: Year Annual rainfall Year Annual rainfall (cm) (cm) 1960 130.0 1971 90.0 1961 84.0 1972 102.0 1962 7...

A:

Q: ow the amount of strain gages effect your measurement read ir answer with calculation and show the l...

A:   (2) we know that change in resiatance  in strain gage  ΔR = K. RE Nos we Will draw circuit diagra...

Q: 1. For a given month a 300-acre lake has 15 cfs of inflow, 13 cfs of outflow, and a total storage in...

A:

Q: a pipeline crossing a river is suspended from a steel cable stretched between the posts 100m apart. ...

A:

Q: One of four monthly-read rain gauges on a catchment area develops a fault in a month when the other ...

A:

Q: Derive the following elements of a simple circular horizontal curve completely based on the figure b...

A:

Q: The bolt is made of a material having an allowable tensile stress of 140.44 MPa and an allowable she...

A:

Q: , Explain why codes and regulations are important on designing buildings and structures. (minimum of...

A:

Q: A drainage pipe became completely blocked during/ a storm by a plug of sand, 1.5 m long, followed by...

A: Given data in question  Width Length Heads Permeability  To find out  Pore water pressure of sand.

Q: Given a proposed six-story (12 meters by 18 meters) City Library which is to be constructed in the P...

A: Concrete is very strong in compression and also quite strong in shear, however, the combination of v...

Q: A sample of sand 5 cm in diameter and 15 cm long, was prepared at a porosity of 60% in a constant-he...

A:

Q: (a) the modulus of elasticity in GPa for the Aluminum  B)  the proportional limit in MPa for the Al...

A: Given data in question  Stress strain curve for mild steel and aluminum  Guage length To find out  E...

Q: Structural

A: As there are multiple questions posted, According to the guidelines only the first is being answered...

Q: Transpiration is a physical process not a metabolic process. O True O False

A:

Q: A steel wire 28 ft long, hanging vertically, supports a load of 698 lb. Neglecting the weight of the...

A: Please refer the attached image for complete solution. THANKYOU !

Q: riou wn: s-6 2.8 ing.p 13.5 12 1.3 5.2 12 0.5

A:

Q: The following are basic assumptions about the rational method except: O Rational coefficients are in...

A:

Q: 1. What is the stationing of the end of excavation? 2. Find the volume of fill by end area method. 3...

A:

Q: 2. A cable supports two concentrated loads at B and C, as shown. Determine the sag at B, the tension...

A:

Q: The spacing of the cars moving along the same lane of an expressway is 40m center to center. If the ...

A:

Q: In reference to the figure below, 0.65 9.65 0.65 1cm 1.92 2cm 1.46 2.82 1.92 1.46 2.82 1.92 2.89 1.4...

A: To find mean precipitation by arithmetic mean method

Q: n relation to occupational health and safety, explain, using an example in each case, the meaning of...

A:

Q: The uniform 2200-lb bar BC is supported by a pin at C and the aluminum wire AB. The cross-sectional ...

A: find the vertical displacement of B due to the weight of the bar.

Q: AW 14 x 142 is used as a column having a length of 9 m. long. It is hinged upper end and fixed at th...

A: The given values are as followsUse W14x142Length=9mFy=248MPaEs=200000Mpa=200GpaA=26967.69mm2d=374.65...

Q: contractor needs 403 m3 of aggregate material for a highway construction project. The required dry u...

A:

Q: M 7 m 5m 5 m 7m

A:

Q: The data from a falling head test on a silty clay are : Cross-sectional area= 80cm2, Length of soil ...

A:

Q: Compute the rate of flow in vehicles per hour (two-decimal places) if the space mean speed is 30 mph...

A:

Q: a tank initially contains 100 gal of brine in which 50 lb of salt are dissolved. for the inflow, eve...

A: To determine the amount of salt after 20 minutes.   Given, Initial volume of the tank, say Vo = 100 ...

Q: SAMPLE PROBLEM NO. 4 For the continuous beam shown, determine the values of the moments over the sup...

A:

Q: In the figure shown, the initial velocity is 170 ft/s. Solve for 'd'. 25 5°

A:

Q: Given: A steel rod (A= 150 mm2) is stretched between two fixed points with a tensile load of 5000 N ...

A: Given data:A=150 mm2 Load,P=5000 Nα=11.7×10-6/°CE=200 GPa or 200×103 N/mm2

Q: sump, then pumped back to the roof tank after the experiment (see Fig. Q4 below). The flowrate was 1...

A: According to given data The flow rate was 10 litre /s The tank was 6m above the sump length of the p...

Q: A flat steel plate is of trapezoidal form. The thickness of the plate is 15 mm and it tapers uniform...

A:

Q: P = 80kN 50mm 25mm A 30° A P.

A:

Q: d O2 placed at depths of 200mm and 800mm . in water , Calculate the diameter ratio

A: According to given data Discharge through Orifice , Q=CcaCv2gh                                      ...

Q: As you can see on this equipment, an Engineer design a belts/pulley with 0.03m shaft and a shear key...

A:

Q: Demonstrate the drag force on a sphere of diameter D in Stokes flow by dimensional analysis by Bucki...

A: To find: - Demonstrate the drag force on a sphere of diameter D in Stokes flow by dimensional analys...

Q: The initial rate of infiltration of a watershed is estimated as 2.1 in/hr, the final capacity is 0.2...

A: Given data in question  Initial infiltration  Final infiltration  Time Constant  Horton To find out ...

Q: The compound bar carries the axial forces P and 2P. Find the maximum allowable value of P if the wor...

A: Given data in question  Stresses Elongation  Area Length Modulus of Elasticity  To find out  Maximum...

Q: *Show FBD and geometry of deformation PROBLEM 1 A rigid bar is attached to two vertical rods before ...

A:

Q: 6. A shared three-way pedestrian-bicycle facility has a width of 10 ft and caries a peak pedestrian ...

A: (i). Calculate the bicycle passing events as follows: Fb = Qsb 1-SpSbHere, Qsb is the bicycle flow r...

Q: An aquarium holds 0.5 m³ of water. The weight of the aquarium is 5,900 N when full and 200 N when em...

A:

Q: MN

A:

Pricing Excavation and Backfill

Backfill, in construction, is the activity of returning the soil and gravel that are removed during building construction or using them again to toughen and support the foundation of the building or any other structural component.