An electric circuit was accidentally constructed using a 7.0-µF capacitor instead of the required 28-µF value. Part A Without removing the 7.0-uF capacitor, what can technician add to correct this circuit? O Another capacitor must be added in parallel. O Another capacitor must be added in series. Submit Request Answer Part B Calculate the capacitance of this additional capasitor. Express your answer to two significant figures and include the appropriate units. HẢ ? C = Value Units

An electric circuit was accidentally constructed using a 7.0-µF capacitor instead of the required 28-µF value. Part A Without removing the 7.0-uF capacitor, what can technician add to correct this circuit? O Another capacitor must be added in parallel. O Another capacitor must be added in series. Submit Request Answer Part B Calculate the capacitance of this additional capasitor. Express your answer to two significant figures and include the appropriate units. HẢ ? C = Value Units

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 55P: An ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations...

See similar textbooks

Similar questions

Check Your Understanding In considering the following schematic and the power supplied and consumed by a circuit, will a voltage source always provide power to the circuit, or can a voltage source consume power?
An ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations involtage oversmall time intervals, (a) If the resistance of the circuit (duemostly to that of the patient's chest) is 1.00kTwhat is the maximum capacitance of the circuit?(b) Would It be difficult in practice to limit the capacitance to less than the value found in (a)?
The timing device in an automobile's intermittent wiper system is based on an RC rime constant and utilizes a 0.500F capacitor and a variable resistor. Over whatrange must R be made to vary to achieve time constants from 2.00 to 15.0 s?
Suppose you have a 9.00-V battery, a 2.00F capacitor, and a 7.40F capacitor, (a) Find the charge and energy stored if the capacitors are connected to the battery in series, (b) Do the same for a parallel connection.
Check Your Understanding In an RLC circuit, L = 5.0 mH, C=60F , and R=200 . (a) Is the circuit under damped, critically damped, or overdamped? (b) If the circuit starts oscillating with a charge of 3.0103C on the capacitor, how much energy has been dissipated in the resistor by the time the oscillations cease?
(a) Find the current in each resistor of Figure P18.18 by using the rules for resistors in series and parallel. (b) Write three independent equations for the three currents using Kirchhoffs laws: one with the node rule; a second using the loop rule through the battery, the 6.0- resistor, and the 24.0- resistor; and the third using the loop rule through the 12.0- and 24.0- resistors. Solve to check the answers found in part (a). Figure Pl8.18
A circuit has a 18.8 pF capacitor, a 39.6 pF capacitor and a 33.1 pf capacitor in series with each other. What is the equivalent capacitance (in pico-Farads) of these three capacitors?
A heart pacemaker is designed to operate at 72 beats/minusing a 6.5µF capacitor in a simple RC circuit. What value ofresistance should be used if the pacemaker is to fire (capacitor discharge) when the voltage reaches 75% of maximumand then drops to 0 V (72 times a minute)?
You have a capacitor that's discharging through a resistor toward zero voltage. What fraction of the inital voltage will the capacitor have after time 2RC?
in the curcuit shown in the figure , the S switch is closed at t = 0 and the capacitors, which are completely empty, begin to fill. Here E = 20 V , C = 4uF and R = 30 ohm. a) what is the time constant of the circuit , T in units of microseconds? b)when t=T , what is the total charge , in units of microcloumb accumulated in the capacitors ?
Hi, Here's my question. 26.45: An emf source (e=120 V), a resistor (R=80.0 W), and a capacitor (C=4.00 mF) are connected in series. As the capacitor charges, what is the magnitude of the charge on each plate of the capacitor when the current in the resistor is 0.900 A? Hint: From the information given, first calculate the voltage across the capacitor when the 0.900 A current flows in the circuit. Then use the voltage as a function of the time equation for a charging capacitor in an R-C circuit.
If a constant current of 1.0 mA were to flow into a 200 µF (microfarad) capacitor, what would be the voltage across the capacitor after 3 seconds?