An electric current in a conductor varies with time according to the expression I(t) = 84 sin (120nt), where I is in amperes and t is seconds. What is the total charge passing given point in the conductor from t = 0 tot = 1/240 s?

An electric current in a conductor varies with time according to the expression I(t) = 84 sin (120nt), where I is in amperes and t is seconds. What is the total charge passing given point in the conductor from t = 0 tot = 1/240 s?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter28: Current And Resistance

Section: Chapter Questions

Problem 65PQ

See similar textbooks

Related questions

Q: An electric current can be represented by the function y = 2 cos (27 (I – 0.02)), with time in x…

A: Note: According to the question answer guidelines, the expert suppose to answer the first question…

Q: An electric current in a conductor varies with time according to the expression I(t) = 100 sin…

Q: The speed of propagation of the action potential (anelectrical signal) in a nerve cell depends…

A: Given: distance,d = 1.1 m speed, v = 18 m/s

Q: 50 300 100 Q Which of the following ranks the resistors by the charge that flows through each in a…

Q: The current density is a vector whose magnitude J is the current 1 per unit cross-sectional area A.…

A: I = 3.6 mA A= 7.2 × 10-6 m2

Q: R1 R, R3 A Figure 5.3 The electrical circuit with resistances: R1=2.2, R=3.3 ve R3=4.7 1) Write the…

A: In the given question, We have write the equation for the given circuit by using kirchhoff current…

Q: The figure below is a cross-sectional view of a coaxial cable. The center conductor is surrounded by…

A: (a) Calculate the magnetic field at point a is calculated by using Ampere’s law, Here, µo and Ia…

Q: At a point high in the Earth's atmosphere, He2+ ions in a concentration of 2.5×1012/m3 are moving…

Q: The Emf is equal to ξ=46.1V, R=36.4Ω. What is the current flowing through R1 (in A)?

Q: If instantaneous current is given by I= 4 sin( ωt+ø ) amperes, then the r.m.s. value of current is…

Q: The current in a wire varies with time t according to the relation: I(t) = 3+3t². where the current…

Q: 10 km long copper conductor with a diameter of 2 cm J=8 A/mm^2 has a current density. According to…

Q: In the Bohr model of the hydrogen atom, an electron in thelowest energy state moves at a speed equal…

Q: A. B. C. D. The current I, in amperes, flowing through an alternating circuit, at a time of t…

A: Given:- Current through the alternating circuit is I=30 sin(bt) Period of the function is T=125 s

Q: Ca) Bx = ( i nT v) sin[(i 169 1100000 i 530 1/s b) Number i 571 Units mw c) Number i 190 Units mW…

Q: To measure IR3, the ammeter should be connected at terminals: 4 5 1 2 3 78 R1 10 11, www. R2 R3 R4 6…

Q: V₂ R₁ ww IR2 R₂ + VR2 (1) IS For the circuit shown above: V₁ = 2 V, R₁ = 2 Q2, R₂ = 4 Q2, 1, = 4 A…

Q: An electric current in a conductor varies with time according to the expression I(t) = 110 sin…

A: I(t)=110sin90πttime, is from 0 to 1/180 sec.

Q: A current, i(t) = 50 cos(100πt) enters the input terminal of an electric device. What is the charge…

A: Given Data, Charge at any instant "t" is i(t) = 50 cos(100πt) Time(t)= 5 ms At t=0 ,q=0

Q: The current in a wire varies with time t according to the relation: I(t) = 58-3t². where the current…

Q: 2.2 Exploratory Study of Resistance In this part of the experiment, you will investigate the…

A: SOlution: as the values of current and voltage vs the length of the conductor is given

Q: 20 volts. The slope of the graph In the Potentiometer experiment, let the known emf of the power…

A: A potentiometer is an electric device used to control the EMF and internal resistance of a cell.…

Q: DaA 302 the Sok 20n 202 242 36V

Q: The quantity of charge through a conductor is modeled as Q(t)=(4.7)t4+(−1.2)t+(6.8) C What is the…

Q: A light bulb filament has a rms current of 0.880 A flowing through it. The voltage in the bulb…

A: Given rms current is irms=0.880 A Voltage in the bulb is V=(300 V)sin345 Hzt We have to find the…

Q: In a given circuit calculate the magnitude of total current I,, where R1 = 31 Q, R2 = 95 Q.

A: solution of above question given in below step.

Q: The oscillating current in an electrical circuit is as follows, where I is measured in amperes and t…

Q: How many electrons pass in a given point in 40 seconds in a conductor carrying 10 Amperes?

A: Given data: Time (t) = 40 seconds Current (I) = 10 Amperes Required: Number of electrons passed…

Q: The drift speed of charge carriers in a conductor carrying current / is ngA where n is the number of…

A: given: Drift speed of charge carriers in a current carrying conductor Vd = InqA where n -…

Q: 1.30 The numerical values of the voltages and currents in the interconnection seen in Fig. P1.30 are…

Q: If the current flowing through a circuit is 0.6 A for 6 mins, the amount of electric charge flowing…

Q: Given that a current of I(t)= 7t2+4 (where t is in s) is flowing parallel to the axis of a…

A: The current density is the ratio of current and area. The current is given as

Q: For the dc network in Figure Q1(b) calculate the unknown voltages V2 and V1 using Kirchoff's voltage…

A: Kirchoff's voltage law, always applied to a closed loop Now consider ,I is the total current…

Q: 3V R2 = 252 Im 9V R1 = 92 R3 = 60

Q: The current in a conductor varies in time according to /(t)= 53 e2, where / is in amperes and t in…

Q: 3V Calculate the currents with Kirchoff, Mesh and Nodal analysis 902 802 12 :)) 202 60. II. 602

Q: 224.)An electrician experienced a mild electric shock when he accidentally touched a wire carrying…

A: Given:- i= current= 5 mA= 5×10^-3 A t= time = 2 sec Current can be given as:- i= q/t Where; q=…

Q: In the SI system of units, one coulomb (1 C) is defined to be the charge that passes a point every…

A: Given, I = 2 A t = 5 min = 300 seconds

Q: The current in a conductor varies in time according to /(t)= 63 e-2, where / is in amperes and t in…

A: Necessary formula

Q: A copper conductor has a diameter of 12 inch and it is 104 feet long. Assume that it carriers a…

A: Current density through a wire is given by: J = I/A Where I = Current in the wire A =…

Q: V, =1V R, = 90 L1< By using the given current and loop directions, Find R3 = 3 N R4 = 61 the…

Q: The equations of the currents in two parallel-connected electric devices are i1 = 11.3 sin (377t +…

Q: Time left 1:11:5 The current in a wire varies with time t according to the relation: I(t) = 3+3t2.…

Q: If the battery in the circuit below is 7.16V, resistor R1=331.15ΩΩ, and resistor R2=51.49ΩΩ, what is…

A: Given: V=7.16 VR1 = 331.15 ΩR2 = 51.49 Ω

Q: For the following circuit, determine the Norton current, in mA, through the two terminals. R1 = 8.3…

Q: The current in conductor varies with time t as I = 2t + 3t? where I is in ampere and t in seconds.…

Question

What is the total charge passing a given point in the conductor from t = 0 to t = 1/240 s?

An electric current in a conductor varies with time according to the expression I(t) = 84 sin (120nt), where I is in amperes and t is
seconds. What is the total charge passing a
given point in the conductor from t = 0 tot = 1/240 s?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

The current in a wire varies with time t according to the relation: I(t) = 3+3t². where the current I in Ampere and time t in seconds. How many coulombs of charge pass section of the wire in the time interval between t = 0 andt= 3s? *
The quantity of charge through a conductor is modeled as: q(t)=at4+bt+c If a = 5.02C/s4, and b = -4.36C/s, and c = 1.75μC, then what is the current, in amperes, at t=1.45s?
The current through a conductor is modeled as I(t) = Im sin (2π[60 Hz]t) . Write an equation for the charge as a function of time.
A conductor carries a current that is decreasing exponentially with time. The current is modeled as I = I0 e−t/τ , where I0 = 3.00 A is the current at timet = 0.00 s and τ = 0.50 s is the time constant. How much charge flows through the conductor between t = 0.00 s and t = 3τ ?
A conductor carries a current that is decreasing exponentially with time. The current is modeled as I=I0et/ , where I0= 3.00 A is the current at timet = 0.00 s and =0.50 s is the time constant. How much charge flows through the conductor between t = 0.00 s and =3 ?
A long, straight, solid cylinder, oriented with its axis in the z−direction, carries a current whose current density is J⃗. The current density, although symmetrical about the cylinder axis, is not constant but varies according to the relationship J⃗=2*I0/πa^2 *[1−(r/a)^2]k for r≤a=0 for r≥a where a is the radius of the cylinder, r is the radial distance from the cylinder axis, and I0 is a constant having units of amperes. Part A Using Ampere's law, derive an expression for the magnitude of the magnetic field B⃗ in the region r≥a. Part B Obtain an expression for the current I contained in a circular cross section of radius r≤a and centered at the cylinder axis. Part C Using Ampere's law, derive an expression for the magnitude of the magnetic field B⃗ in the region r≤a.
The magnitude J of the current density in a certain wire with a circular cross section of radius R = 2.21 mm is given by J = (3.18 × 108)r2, with J in amperes per square meter and radial distance r in meters. What is the current through the outer section bounded by r = 0.927R and r = R?
The magnitude of the current density in a certain lab with a circular cross section of radius R=4.00 mm is given by J= (3.00 × 10^8) r^2, with J in amperes per square meter and radial distance r in meters. What is the current through the outer section bounded by r = 0.500R and r = R ?
The quantity of charge through a conductor is modeled asQ(t)=(4.7)t4+(−1.2)t+(6.8) C What is the current at time t= 4 s?
The total amount of charge that has entered a wire at time tt is given by the expression Q=(20C)(1−e−t/(2.0s)), where t is in seconds and t≥0 1.Find an expression for the current in the wire at time t. 2.
a wire of radius R carries uniform current denisty J. what is the total current in the wire 1.2 what is the total current in the wire if it carries current denisty with magnitude J=kr(r is the radical distance from the axis and k is a constant with the appropiate units)
The quantity of charge Q that has passed through a surface of area 6.00 mm2 varies with time according to the equation Q = 2t2 + 10, where t is in seconds. What is the instantaneous current through the surface at t = 2.6 s?