Answered: An electric heater carries 12A at 110V,…

An electric heater carries 12A at 110V, is submerged in 22.5 lbs of water for 30 minutes. What will be the final temperature of water if its initial temperature is 35 degrees Fahrenheit

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter29: Service-entrance Calculations

Section: Chapter Questions

Problem 6R: What load may be used for an electric range rated at not over 12 kW? (Table 220.55) _____

See similar textbooks

Related questions

Q: What is the Carnot efficiency of a typical geothermal plant and its power capacity in MW? The…

A: Given in the question: The average temperature is: TAVG = 210 C Ambient temperature is: TAMB = 880C.…

Q: A light source producing 1500 candela is suspended 2.2m above a horizontal surface. Calculate the…

A: We have given an light source of , Luminous Intensity = 1500 Candela We have been asked to find…

Q: An industrial load is known to be inductive and consumes 60 KW. The ammeter reading is 260 A ms, and…

A: P= 60kW Vrms = 480 v Irms = 260 A

Q: An industrial load is known to be inductive and consumes 90 KW. The ammeter reading is 260 A ms, and…

Q: Consider the following waveform. Volts 4 18 12 t (sec)

A: Given waveform shown

Q: 11 The following diagram shows an analogue waveform that is powering a device. If the power rating…

Q: A copper coil has a resistance of 200 ohms when its mean temperature is 0 degree centigrade.…

A: Given: Resistance of the copper coil at 0 degree centigrade, R0=200 Ω T1=0° CT2=80° Cα=0.004041 C-1

Q: A 250 W sodium vapour street lamps emits a light of 20500 cd and is situated 4.2 m above the road.…

Q: A coffeemaker has a rated power of 1,000W at 240 V rms. Find the resistance of the heating element.

A: Let P be the rated power of the coffeemaker, V be the RMS voltage across heat, R be the resistance…

Q: Calculate the electric field intensity in millivolts per meter (mV/m) at 30kW from a 5 km source.…

Q: A heater is rated as 220V,5KW, A.C. The value 220V refers to Select one: O a. DC value O b. R.M.S…

A: given, 220V,5kW ac, electric heater

Q: A) An energymeter has meter constant is 3153 revolutions per kWh. When this

A: Given, K= energy meter constant = 3153 rev per kWh I = 5.5A V = 230V cos ∅=1 t = 58 sec =5860×60…

Q: Q6/An air conditioner removes heat steadily from a house at a rate of 750 kJ/min while drawing…

Q: QUESTION 7 An industrial heater has a nameplate that reads: 166 Vrms 50 Hz 106 KVA 0.88 lagging What…

Q: Question 7 Solve for the value of inductive reactance if R1 = 470 ohms, R2 = 10 ohms and L3 = 4.7…

A: The solution is given below

Q: ii, The electric current flowing in a resistor is given by 1= 20 sin(100t) where I is in Amperes…

Q: The value of the total charge entering a circuit terminal is given as Q=5 sin(30t) C What will be…

Q: Q.The electric current flowing in a resistor is given by I = 20 sin(100t) where I is in Amperes and…

Q: Electrical Engineering help. fundamental btw For the circuit of Figure 2.41, determine the…

A: the solution is given below

Q: Find the reading of the ac ammeter if it is in series with a 270 ohm resistor that has a peak power…

A: AC ammeter measures only rms value. Given is the Peak power dissipation. From Ppeak= Ipeak2R which…

Q: An industrial load is known to be inductive and consumes 90 KW. The ammeter reading is 260 A ms, and…

A: Given Power 90 Kw, Voltage V =480Vrms, current I=260 A

Q: A coil developes heat of 800 cals/sec. When 20 V is supplied across it. The resistance of the coil…

A: Given, A coil develops heat of 800 cals/sec. Supply voltage, V = 20 V

Q: An electric heater Consunes 1.8MJ when Connected to a 25oV Supply or 3ominutes. Find the poukr…

Q: Three coils each having resistance of 26 Q are connected in star across 438 V, 50 Hz supply. Then…

A: Need to find power

Q: Consider the resistor in the figure, whose current is represented by the diagram on the right.…

A: As per company guidelines we can solve only first question post another question separately

Q: Find the average rate of co sumtpuonif a 160 ah battery was evenly discharged over 30hrs

A: Given: Battery capacity, C=160 Ah Discharge time, t=30 hr

Q: An industrial load is known to be inductive and consumes 60 KW. The ammeter reading is 260 A ms, and…

Q: :An industrial heater has a nameplate that reads Vrms 233 Hz 59 kVA 104 lagging 0.70 ?What is the…

A: Given data, Vrms=233 Vf=59 HzKVA rating 104Power factor cosϕ = 0.7

Q: A 110-V, 50 Hz supply is connected across 15 ohm resistor. Determine the instantaneous current after…

A: By ohms law current through the resistor = voltage across resistor/resistance.

Q: SITUATION NO. 1- A specific circuit element has a charge of q = 10e^(2t ) coulomb and a voltage…

A: It is given that: q=10 e2t Cv=10 e-t V

Q: what is the depth of discharge of battery 12V, 8AH/20HR

A: The batteries are voltage source elements of DC circuits. These consists of many smaller charge…

Q: Silicon 5 R1 V1 AC 10 V3 2 Vout

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: :An industrial heater has a nameplate that reads Vrms 130 Hz 49 kVA 95 lagging 0.75 ?What is the…

Q: ww IT 12 3Ω 32 ww 12 100V 22 22 ww 12 ww

A: Here we have used the the delta to star conversion. And we also used the ohm's law to calculate the…

Q: An industrial load is known to be inductive and consumes 90 KW. The ammeter reading is 260 A ms, and…

A: In this answer let us try to estimate the power factor of the circuit as shown below.

Q: As an electric charge of 0.036 C flows through a copper wire in 5 minutes; Calculate the average…

Q: Energy densities of biofuels are that of fossil fuels O a. higher than O b. lesser than O c. may be…

Q: What is the instantaneous maximum value of power

A: The incandescent lamp act as a resistive load. So, its power factor is unity. The rms current…

Q: 1. Compare the power in watts with the apparent power in volt-amperes for the following apparatus in…

A: Given: Power comparison

Q: Find the regulation of an AC g voltage of 3240 V at 80 percen 20 % 27 % 35 % none of the above Will…

A: 6 A) The no load voltage is 3240V. Full load voltage is 2400V. The power factor is 80% lagging The…

Q: noninductive heater element with a resistance of 5 №2 is connected across a 60 Hz urce. The supply…

Q: An energy meter measure the amount of power consumed by the load with respect to time. It is…

A: In this question , we will find percentage error in energy meter..

Q: A 100 watt light bulb emits a total luminous flux of 1500 lumens, distributed uniformly over a…

A: Given Total luminous is 1500 lumens Find illuminance at r= 2 m distance

Q: Q5: Determine the COP of a refrigerator which removes heat from the food compartment at a rate of…

A: Determine the COP of refrigerator with the given values. Option D(1.38 ) is correct.

Q: A moving iron voltmeter reads 250v when connected to 250v dc if connected to 250v 50 Hz .the…

Q: :An industrial heater has a nameplate that reads Vrms 235 Hz 64 kVA 75 lagging 0.81 ?What is the…

A: Given data, Vrms = 235 volts frequency = 64 Hz Apparent power (S) = 75 kVA Power factor = 0.81…

Q: A suspension string has 3 units. Each unit can withstand a maximum peak voltage 11kB. The…

A: Line voltage is the conductor between a load and source of the current and the voltage between two…

Q: a voltage waveform is shown below, where Vmax and Vmin are the maximum and minimum voltage values.…

A: Given data, Vmax = 8 V. Vmin = -5 V.

Q: 102 200pF 200 10 sin(100t-40) V 3100MH 302

A: Evaluating the equivalent impedance of the circuit:

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

An electric heater carries 12A at 110V, is submerged in 22.5 lbs of water for
30 minutes. What will be the final temperature of water if its initial
temperature is 35 degrees Fahrenheit

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data

VIEW

Step 2: Final temperature

VIEW

Step 3: The answer

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Two heating elements which is 500 ohms and 250 ohms are connected in series with temperature coefficients of 0.001 and 0.003 ohms per °C, respectively at 20°C and heated at 50°C, Calculate the effective temperature coefficient of the combination at 20°C
Two heating elements which is 500 ohms and 250 ohms are connected in series with temperature coefficients of 0.001 and 0.003 ohms per ⁰C, respectively at 20⁰C. Calculate the effective temperature coefficient of the combination.
The amount of current the battery can produce for a period of 20 hours at 80 degrees Fahrenheit is known as what? Select one: A. AMPACITY B. AMP HOURS C. AMPERAGE D. INTENSITY OF CURRENT
A suspension string has 3 units. Each unit can withstand a maximum peak voltage 11kB. The capacitance of each joint and metalwork 20 % of the each disc. Fin the (a) maximum line voltage for which the string can be used. (b) String efficiency.
An aluminum wire has resistance of 80 ohms at 30 degree Celsius. And determine its resistance when its temperature is lowered to10C.
Calculate the electric field intensity in millivolts per meter (mV/m) at 30kW from a 5 km source. (Use 2 decimal places for the final answer)
Q.The electric current flowing in a resistor is given by I = 20 sin(100t) where I is in Amperes and t is in seconds. A, What is the maximum current? B, What is the frequency of the current? C, What is the time taken to change from zero to maximum current in each cycle?
An inductance of 2 Henries and a resistance of 20 ohms is connected in series with an emf of E volts. If the current is zero at time t = 0, find the current at the end of 0.01 sec if (a) E = 100V and (b) 100 sin 150t V.
Find the average rate of co sumtpuonif a 160 ah battery was evenly discharged over 30hrs
The power drawn by a resistive coil made of copper wire is 220W at 100V and 20°C. Calculate the power consume by the coil at 115V and 100°C. *Draw the diagram
which one of the following is The rate at which solar energy arrives at the top of the atmosphere a. solar contact b. solar radiation c. solar constant d. solar coordination
The maximum values of voltage and current outputs of an alternator are 300V and 20A, respectively. What is the power output in watts if the voltage leads the current by 30 degrees? THE ANSWER SHOULD BE 2598 W.