What is the Carnot efficiency of a typical geothermal plant and its power capacity in MW? The average heat supply from the geothermal production well is around 1. 92 x 107 kW. The average ambient temperature and maximum temperature are 21 "C and 88 "C, respectively. power

What is the Carnot efficiency of a typical geothermal plant and its power capacity in MW? The average heat supply from the geothermal production well is around 1. 92 x 107 kW. The average ambient temperature and maximum temperature are 21 "C and 88 "C, respectively. power

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter29: Service-entrance Calculations

Section: Chapter Questions

Problem 6R: What load may be used for an electric range rated at not over 12 kW? (Table 220.55) _____

See similar textbooks

Related questions

Q: A steam power station spends 83916 OMR per annum for coal used in the station. The coal has a…

Q: Wind-turbine units are rated at 8 KW in a rated wind speed of 14 m/s. The stage efficiencies are Cp…

A: Find the diameter of the wine turbine Output power P= 8kW Wind speed 14m/s Find the turbine…

Q: Find the average power delivered by the ideal current source in the circuit if ig = 4 cos 5000t mA…

A: To calculate average power equivalent impedance Zeq of the circuit is required. Average power is…

Q: 3. An automobile tire is inflated to 30 psig pressure at 50 deg. Fahrenheit, after being driven the…

A: Given: P1=20 psigT1=50°FT1=50°F-32×59+273.15T1=283.15 KT2=90°FT2=90°F-32×59+273.15T2=305.372K

Q: By how much the velocity of wind turbine will be multiplied, if its wind power is tripled?

Q: 7. A purely resistive lamp is rated at 200V (rms), 120 W (i.e., it dissipates 120 W power when…

Q: Find the total average power absorbed and the total average power supplied in the network from the…

A: Fig: Given circuit calculate z1…

Q: A 4 HP motor with a power factor of 0.8(-) operating at 100 Vrms. How much is the reactive power in…

A: A 4 HP motor with a power factor of 0.8(-) operating at 100 Vrms. To find the reactive power…

Q: An industrial heater has a nameplate that reads: 200 V, 60 Hz, 12 kVA, o.788 pf lagging Determine…

A: Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If…

Q: What is the effective isotropic radiate power (EIRP) in W? (Use two decimal places for the final…

Q: A coffeemaker has a rated power of 1,000W at 240 V rms. Find the resistance of the heating element.

A: Let P be the rated power of the coffeemaker, V be the RMS voltage across heat, R be the resistance…

Q: In a typical power system in Oman, Power stations has . . Which converts to and the generated…

A: In a typical power system in Oman , power stations has alternators which converts mechanical energy…

Q: Calculate for the value of VL(peak). Please show your complete solution. Thank you.

Q: A hydropower station has a gross head of 13.8 meter Head loss in water conductor system is 1.1…

A: Given: A hydropower station has a gross head of 13.8 meters Head loss in a water conductor system is…

Q: Q6/An air conditioner removes heat steadily from a house at a rate of 750 kJ/min while drawing…

Q: Q1 / A steam power plant with a power output of 150 MW consumes coal at a rate of 60 tons/h. If the…

Q: A medium-rise building with inductive loads has an average consumption of 40 kW and 26 KVAR. At the…

A: In this question we need to find average current , effective impedance and surcharge

Q: 15. A residential AC power line voltage is 230 V. What are the average and peak-to-peak voltages? a.…

A: In this question we will find average voltage and peak to peak value for given wave with line…

Q: 1) A. a heater is connected to voltage source of 250 V and absorbs P= 1000 W.S= 1400 VA .What is the…

A: The heater is connected to a voltage source of 250 Volts. The real power absorbed by the heater is…

Q: 3. Find Pa, the average power absorbed by the 4-2 resistor c absorbed by the same elements due to vw…

Q: Which renewable energy source is not from the sun? O a. geothermal O b. wind O c. biomass O d. wave

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: 4. The power input to a television station transmitter is 125 kw and the output is 100 kw which is…

A: 4) Given, power input to a television station transmitter is 125 kw and output is 100 kw . Remaining…

Q: An industrial load is known to be inductive and consumes 90 KW. The ammeter reading is 260 A ms, and…

A: Given Power 90 Kw, Voltage V =480Vrms, current I=260 A

Q: A medium-rise building with inductive loads has an average consumption of 40 kW and 26 KVAR. At the…

A: In this question we need to find a minimum KVAR the capacitor should produce so that the surcharge…

Q: In a cold country, an apartment needs 48 kWh of heat to maintain their interi whose temperature is…

Q: A medium-rise building with inductive loads has an average consumption of 40 kW and 26 KVAR. At the…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: :An industrial heater has a nameplate that reads Vrms 175 Hz 65 kVA 117 lagging 0.83 ?What is the…

Q: The voltage applied to a circuit having a resistance of 12 ohms is 150 sin 377t volts. Determine:…

A: Given data, The value of resistance is R = 12 ohm. The value of voltage is V = 150 sin 377t V. a)…

Q: :An industrial heater has a nameplate that reads Vrms 233 Hz 59 kVA 104 lagging 0.70 ?What is the…

A: Given data, Vrms=233 Vf=59 HzKVA rating 104Power factor cosϕ = 0.7

Q: A medium-rise building with inductive loads has an average consumption of 40 kW and 26 KVAR. At the…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: Wind-turbine units are rated at 8 KW in a rated wind speed of 22 m/s. The stage efficiencies are Cp…

Q: Given the two loads with the power rating: a.) Incandescent light bulb = 100 W b.) LED lamp = 9 W…

A: Given, Two loads are Incandescent light bulb power rating (P1)=100W per hour LED lamp power rating…

Q: Task Il: You were assigned to a team conducting an energy audit in hotel facility. After several…

A: Peak power, often called peak surge power, is the maximum power that a power source can deliver for…

Q: :An industrial heater has a nameplate that reads Vrms 130 Hz 49 kVA 95 lagging 0.75 ?What is the…

Q: Estimate the power required in the United States during the year 2050, in GW, and the energy…

Q: Two heating elements which is 500 ohms and 250 ohms are connected in series with temperature…

A: Given: At temperature, T=20°C The resistances of heating elements are R1=500 Ω and R2=250 Ω The…

Q: An electric heater carries 12A at 110V, is submerged in 22.5 lbs of water for 30 minutes. What will…

A: For an electric heater Current I=12 A Voltage V=110 V Time t=30 minutes Mass of water = 22.5 lbs…

Q: Energy densities of biofuels are that of fossil fuels O a. higher than O b. lesser than O c. may be…

Q: Wind-turbine units are rated at 6 KW in a rated wind speed of 8 m/s. The stage efficiencies are Cp =…

A: The efficiencies are cp = 0.32 ngb = 0.90 ng = 0.92 V = 8 m/s

Q: The maximum power demand of a consumer is 2 kW and the corresponding daily energy consumption is 30…

Q: A 230 V, single phase energymeter has a constant load of 4 A passing through it for 6 hours at unity…

Q: During a weather storm, an atmospheric discharge hits a lightning pole that is grounded through a…

A: Given, The current that passes through the person, I = 0.3 A The man's body resistance (between his…

Q: If the effective voltage of an ac power supply is 130 V, what is the peak-to-peak voltage? enter…

Q: The water in a large lake is to be used to generate electricity by the installation of a hydraulic…

Q: An energy meter measure the amount of power consumed by the load with respect to time. It is…

A: In this question , we will find percentage error in energy meter..

Q: Q5: Determine the COP of a refrigerator which removes heat from the food compartment at a rate of…

A: Determine the COP of refrigerator with the given values. Option D(1.38 ) is correct.

Q: :An industrial heater has a nameplate that reads Vrms 235 Hz 64 kVA 75 lagging 0.81 ?What is the…

A: Given data, Vrms = 235 volts frequency = 64 Hz Apparent power (S) = 75 kVA Power factor = 0.81…

Q: A hydropower station has a gross head of 13.2 meter Head loss in water conductor system is 0.86…

Q: Energy produced in a power station is 1440 MWh per day. What is the maximum demand of the station if…

A: Given data: Energy produced in power station = 1440 MWh per day Time period = 1 day = 24 hour Load…

Q: A medium-rise building with inductive loads has an average consumption of 40 kW and 26 KVAR. At the…

Question

Solve it quickly please

What is the Carnot efficiency of a typical geothermal plant and its power capacity in MW? The average heat
supply from the geothermal production well is around 1. 92 x 10 7 kW. The average ambient temperature and
maximum temperature are 21 °C and 88 "C, respectively.
power =

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the maximum allowable capacitance between a 480Vac 60 Hz industrial power supply and the surrounding metal cabinet so that a person with 3 kOhm resistance through their body to ground will not experience more than 10 mA of current if they touch the cabinet?
An automotive alternator is rated 500 VA and20 V. It delivers its rated voltamperes at a powerfactor of 0.85. The resistance per phase is 0.05Ω , andthe field takes 2 A at 12 V. If the friction and windageloss is 25 W and the core loss is 30 W, calculate thepercent efficiency under rated conditions.
An industrial assembly hall is continuously lightedby one hundred 40-W mercury vapor lamps suppliedby a 120-V and 60-Hz source with a power factor of0.65. Due to the low power factor, a 25 percent penaltyis applied at billing. If the average price of 1 kWh is$0.01 and the capacitor’s average price is $50 permillifarad, compute after how many days of operationthe penalty billing covers the price of the power factorcorrection capacitor. (To avoid penalty, the powerfactor must be greater than 0.85.)
A wind turbine system has an average overall efficiency of 25%, what is the size of wind rotor is required if 100 watt DC generator will be driven? The average expected wind velocity at the rotor is 8 m/s.
A 55000 kW thermal plant of National Power Corporation delivers an annual output of 238000000 kw-hr with a peak load of 44 MW. What is the capacity factor? a. 49.4% b. 42.4 % c. 48.2% d. 44.6%The Answer is not 63.74.
Two heating elements which is 500 ohms and 250 ohms are connected in series with temperature coefficients of 0.001 and 0.003 ohms per °C, respectively at 20°C and heated at 50°C, Calculate the effective temperature coefficient of the combination at 20°C
A steam turbine generator is designed to generate 5.5MW of electrical power at a 6300V, 50HZ and 0.95 lag. The steam turbine requires 28 tons per hour of a high-pressure steam of temperature and pressure of 4000C and 40 bar. The steam turbine is a condensing type. If the temperature of the exhaust steam is 400 C (a).Calculate the efficiency of the steam turbine (b)What are the three (3) major advantages and disadvantages of the steam turbine? (c )What are the methods of improving efficiency of the Brayton cycle?
Q 03: Briefly discuss, how the energy consumptions for operations of a fork lifter could be justified. Suppose that a fork lifter has a total energy consumption of 150 W.Hr. The total trips of the vehicle are 375. How the battery duty cycle may be calculated in this case?
An electric water heater has a rating of 1 kW, 230 V. The coil used as the heating element is 10 m long and has a resistivity of 1.724 x 10-6 ohm - cm. Determine the required diameter of the wire in mils?
A wind turbine gives maximum output power of 1MW at a wind speed of 15m/s. Refer to the above wind turbine choose the correct statement a. The wind rotor swept area is 400square meters. b. The wind rotor swept area is 835 square meters. c. The wind rotor swept area is 700 square meters d. The wind rotor swept area is 638 square meters.
Q: Suppose that a fork lifter has a total energy consumption of 150 W.Hr. The total trips of the vehicle are 375. How the battery duty cycle may be calculated in this case?
A 240-V rms 60-Hz supply serves a load that is 10 kW (resistive), 15 kVAR (capacitive), and 22 kVAR (inductive). What is the current drawn from the supply in amperes? And what is the required capacitor rating in microfarads required to improve the power factor to 0.96 ?