An electrical home appliance rests on four rubber pads, each one having a height of 0.62 cm and a radius of 0.34 cm. A 339-N horizontal force is applied to the appliance. How far does it move sideways due to the deformation of the rubber pads if the pads do not slide on the floor? The shear modulus of these rubber pads is 2.6 × 10^6 Pa. Give your answer in mm

Q: A golf ball of mass 50 grams is struck and has a velocity of 70 m/s when it leaves the tee. The golf…

A: Given data:  Mass (m) = 50 g = 0.050 kg Velocity (v) = 70 m/s Time (t) = 0.02 s Required: The…

Q: 2. A ship leaves port and travels 80 km along a heading of 230°, then 130 km along a 90-degree…

A: Given that, after leaving port, a ship sails d1=80 km along a heading of θ1=230°, d2=130 km along a…

Q: (Not graded) Consider a simple hydrogen atom where an electron orbits around a proton. Suppose a…

A: According to Faraday's law, an EMF (electromotive force) is generated in a conductor if it is placed…

Q: An oscillator consists of a block of mass 0.500 kg connected to a spring. When set into oscillation…

A:

Q: Review Conceptual Example 2 before attempting this problem. The moon has a diameter of 3.48 x 106 m…

A:

Q: 17) The moment of Inertia of a solid uniform sphere of ma given by the equation 1 = (2/5) mR2. Such…

A:

Q: QUESTION 22 What is the focal length of the spherical lens diagrammed below? The index of refraction…

A:

Q: Diagram shows four long straight wires (fixed in place) each carrying a 2A current. Left wire and…

A:

Q: eign and come back (round-trip). 2. A half wave lantenna has the best reception when its length is…

A: Given value--- length of TV antenna = 40 cm. We have to find--- frequency of signal ?

Q: Determine the Young's modulus of a 1.50 x 10^-1 m long tendon if it is stretched by 3.70 x10^-3 m by…

A:

Q: This time, V = 56.5 V; R1 = 130 Ohms; R2 = 94 Ohms; R3 = 160 Ohms; R4 = 154 Ohms; R5 = 145 Ohms; and…

A:

Q: You have a metal plug that is a mixture of Aluminum and Silver. Aluminum makes up 25% of the…

A: The amounts of Aluminum and Silver in the mixture are n1=25%=0.25 and n2=75%=0.75 respectively while…

Q: A simple pendulum has a period of 4.40s . Determine the length of the pendulum (assuming that g…

A: Given value--- Time period = 4.4 s. We have to find---  length of rod ?

Q: What change occurs to the atomic number and mass of a nucleus during each of the following decay…

A:

Q: 13. A uniform 8.00 m, 580 N beam is hinged to a wall and supported by a thin cable attached 2.00 m…

A:

Q: A 1.75 kg mass is attached to the end of a horizontal spring of spring constant 60 N/m and set into…

A: Write the given values with the suitable variables. m=1.75 kgk=60 N/mx=0.4 m Here, m, k, and x are…

Q: On one side of a diverging lens of focal length 59.0 cm, you position an object of height 3.92 cm…

A:

Q: is attached to a massless spring with a force constant 500 N/m. na horizontal frictionless surface.…

A: given mass  m=3kgspring constant K=500N/mdistance of compression=30 cm=0.3melastic potential…

Q: The dot product of two vectors is negative while the magnitude of its cross product is positive.…

A:

Q: Question 5 Two vectors have a magnitude of 3 and 2 and their dot product has a value of -5. Which of…

A:

Q: Please refer to Figure 2. A light beam shines through air and then strikes a mirror, making an angle…

A:

Q: 6) A mass of 3 kg is attached to a massless spring with a force constant 500 N/m. The mass rests on…

A:

Q: Most automobiles have a coolant reservoir to catch radiator fluid that may overflow when the engine…

A: Given data, Volume V=17 L Coefficient of volume expansion of copper βc=5.1×10-5 /°C Coefficient of…

Q: Question 23 Two frisky otters slide down frictionless hillsides of the same height but different…

A: height of hill for both the otters = h θ1 = 30oθ2 = 60oLet the mass = m

Q: This time, V=59.9 V; R1 = 134 Ohms; R2 = 153 Ohms; R3 = 130 Ohms; R4 = 186 Ohms; R5 = 121 Uhms, and…

A:

Q: 22 A particle is confined to the one-dimensional infinite poten tial well of Fig. 39-2. If the…

A:

Q: PLE 22. A certain object has a density of 440 kg/m³. It's pushed under water, then released. What is…

A: density of object = 440 kgm3density of water = 1000 kgm3Let the volume of object = V

Q: An electrical circuit has a 4.65-V battery wired to two resistors, 3.63 Ohms and 6.29 Ohms, in…

A: Given value--- V = 4.65 V. R1 = 3.63 Ohm. R2 = 6.29 Ohm. We have to find--- total current?

Q: Recall that the Range equation gives the horizontal distance a projectile can be launched. Suppose…

A: Given:- The equation of the range of the projectile. R(θ) = v02gsin2θ-0.80v02gsinθ5 The figure of…

Q: 1. A ball is thrown upward from the top of a 50 meter high building with an initial speed of 25 m/s.…

A: Solution:- 1) In motion along one dimension, the relationship between initial velocity, final…

Q: A ball is thrown upward from the top of a 50 meter high building with an initial speed of 25 m/s.…

A: Given Height of the building is h=50 m Initial velocity of the ball is v0=25 m/s   We have to find…

Q: N5  A jet plane flies at a high speed of 400 m/s at the altitude of 1000 meters. A camera crew on…

A:

Q: 4. A 212 Bi (bismuth) nucleus undergoes alpha decay, resulting in a 208TI (thallium) nu- cleus and a…

A:

Q: 12) A solid cylinder consisting of an outer radius R₁ and an inner radius R₂ is pivoted on a…

A: Given: R1=0.75 mR2=0.35 mF1=3 NF2=5 N

Q: Two radioactive isotopes, X and Y, both decay to stable products. The half-life of X is about a day,…

A: The term "half-life" is used in the areas of physics and chemistry that deal with radioactivity and…

Q: 1. Which of the following quantities has units of a velocity? (There are two answers) A) 10 km…

A: Given data:  Four physical quantities are given Required: The quantity that has the unit of velocity…

Q: Scott Moir (50-kg) sees Tessa (40 kg) skating at the local skating rink. He skates at 4.0 m/s to…

A:

Q: Suppose you have an electric field as a result of superposition of two waves given by "E(z, t) = Eo…

A: Given: Electric field- E→ z,t = E0coskz-ωtx^ + E0coskz+ωt x^ To Find: Instantaneous and time average…

Q: Consider a triangular plate. F₁ = 9.4 N, F₂ = 10 N, and F3 = 9.8 N. Consider the counterclockwise…

A:

Q: For the vectors  A and Bin the figure (Figure 1), use a scale drawing to find the magnitude of the…

A: Given value-- all values are given in diagram.  We have to find--- find the magnitude of the…

Q: In the figure below on single slit diffraction, what is the distance of the third dark band from the…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: An object was left in a room of unknown surrounding temperature. The temperature of the object was…

A:

Q: 13. The objects below collide inelastically. What is the speed v2 (in m/s) of the 4.0-kg object…

A: Given data- The objects collide inelastically. Before collision- mass m1=4.0 kg, speed v1=4.5 m/s…

Q: 14. The objects shown in the figure collide elastically. What is the velocity (in m/s) of the 8-kg…

A: Elastic collision: An elastic collision is one in which the system does not experience a net loss of…

Q: What are the categories of the mode of propagation of electromagnetic waves in the atmosphere as…

A:

Q: A tennis ball, starting from rest, rolls down the hill in the figure. At the end of the hill the…

A:

Q: and during this time the wheel's displacement is 300 rad. What was the wheel's initial angula…

A:

Q: What is the resistance of a 4.00x10³, a 2.00x10³, and a 3.00x10³ resistor connected in series?…

A:

Q: J: The electric field of a plane wave propagating in a nonmagnetic material is given by E = [y3…

A: Solution - An electric field (sometimes E-field) is the physical field that surrounds electrically…

Q: An object moving in the zy-plane is subjected to the force F = (2xyî +x²j) N, where x and y are in…

A:

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).