An electromotive force of 200 volts is applied to a series RC circuit with a resistance of 1000 ohms and a capacitance of 5x10-6 farads. Find the charge q (t) on the capacitor if i (0) = 0.4. Determine the load and current at t = 0.005 s. Determine the faceg of the as t → ∞

An electromotive force of 200 volts is applied to a series RC circuit with a resistance of 1000 ohms and a capacitance of 5x10-6 farads. Find the charge q (t) on the capacitor if i (0) = 0.4. Determine the load and current at t = 0.005 s. Determine the faceg of the as t → ∞

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 55P: An ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations...

See similar textbooks

Related questions

Q: A capacitor bank is designed to discharge 5.00 J of energy through a 10.0-kΩresistor array in under…

Q: Consider the series RC-circuit shown below for which R = 40.0 k2, C = 35.0 µF, and & = 27.0 V. Find…

A: problem related to RC circuit R =40 KΩ C=35 μF ε = 27 VOLT

Q: A simple RC circuit consists of a 1-μF capacitor in series with a 3000-Ω resistor, a 6-V battery,…

Q: A 2.00- and a 7.50- Fµ capacitor can be connected in series or parallel, as can a 25.0- and a100-kΩ…

Q: The RC charging circuit in a camera flash unit has a voltagesource of 275 V and a capacitance of 125…

A: Calculating the time-constant:

Q: The charge of the capacitor, the current in the circuit, and, correspondingly, the voltages across…

Q: An RC circuit is wired using a 6.16 V emf battery, a 500 ohm resistor, and an initially empty 1.5…

A: A) The current at the moment it is wired. The formula used for current is

Q: Consider the RC circuit shown in the figure below. If the resistance of the circuit is R=7kO and the…

A: Answer: 74.4 ms

Q: Using the exact exponential treatment, find how much time is required to discharge a 270 µF…

Q: The time needed for fully charging of the capacitor is 50ms for an RC charging circuit. If the…

A: Time , T = 50 ms = 50 x 10-3 s Capacitance , C = 17 x 10-6 F To find = resistance

Q: Consider a series RC circuit as in Figure below for which R =6.5 MQ, C=4.3 µF, and ɛ=30.0 V. Find…

A: After a very long period of time the capacitor starts to behave as an open switch. Therefore the…

Q: A RC circuit has an emf of 10 sin t volts, a resistance of 100 ohms, a capacitance of 0.005 farad,…

Q: In an RC series circuit, & = 16.0 V, R = 1.60 M2, and C = 1.80 µF. (a) Calculate the time constant.…

Q: Consider the RC circuit shown in the figure below. If the resistance of the circuit is R=2kN and the…

A: A charged object is one that has an excess of either the positive or the negative charges. The…

Q: Consider a series RC circuit as in Figure below for which R =7.3 MO, C=11.5 µF, and &=30.0 V. Find…

Q: Solve using mathematical model of L-R ELECTRICAL CIRCUIT IN SERIES: L di/dt + Ri =E(t) To a…

Q: A simple RC circuit is composed of resistor and capacitor which is connected in a series to a…

Q: Consider a capacitor of capacitance C that is being discharged through a resistor of resisiance Ras…

A: Given,

Q: An RC circuit with a 1-2 resistor and a 0.000001-F capacitor is driven by a voltage sin 100t V. If…

Q: An initially uncharged 3.03 x 10- F capacitor and a 8030 2 resistor are connected in series to a…

Q: A 200 – volt electromotive force is applied to an RC – series circuit in which the resistance is 300…

Q: Consider a series RC circuit for which R = 1.00 MQ, C = 5.00 µF, and ɛ = 20.0 V. Find the %3D…

Q: In an RC series circuit, ε = 12.0 V, R = 1.71 MΩ, and C = 2.18 µF. (a) Calculate the time constant.…

Q: Consider a series RC circuit as in Figure below for which R =2.2 MQ, C=5.8 µF, and ɛ=30.0 V. Find…

Q: The time, in seconds, for the current through a 652-ohm resistor in an RC circuit, with an initially…

Q: A simple RC circuit consisting of a 10.0-µF capacitor in series with a resistor. Initially, the…

A: Given data according to question C = 10 t = 2s V = 37%V0 We have to calculate resistance

Q: Consider the multi loop circuit shown in Figure 9. Directions of the currents and the numerical…

A: Apply KVL on the left loop. Similarly, apply KVL on the right loop.

Q: Consider an RC circuit with E= 12.0 V ,R= 175 Ω , and C= 45.5 μF. Find the time constant for the…

Q: What multiple of the time constant T gives the time taken by an initially uncharged capacitor in an…

A: We know that the charge on the capacitor while charging is given by q = qo(1- e-tτ) where q is the…

Q: A simple RC circuit consisting of a 10.0-µF capacitor in series with a resistor. Initially, the…

A: GIVEN Capacitor = 10 μF The potential difference between plates = 100 V at t= 0 sec Potential…

Q: A resistor with value 2-ohm is connected in series with a capacitor that has a capacitance rating of…

Q: The RC charging circuit in a camera flash unit has a voltage source of 265 V and a capacitance of…

A: (a) Find the time constant of the circuit. Q=Q01-e-tτ0.90Q0=Q01-e-tτ0.90=1-e-tτ0.90-1=-e-tτ Solve…

Q: A 3.33@kΩ resistor is connected to a generator with a maximumvoltage of 241 V. Find (a) the average…

A: The rms voltage can be obtained as Vrms=Vmax2=241V2=170.41V

Q: In the circuit shown, R,=R2=R, and ɛ, =. The power dissipated in R, is 40 W. Does battery ɛ, supply…

A: For the given circuit we need to find the power absorbed or supplied by the battery ε2.

Q: A 200-volt electromotive force is applied to an RC-series circuit in which the resistance is 1000…

Q: If you wish to take a picture of a bullet traveling at 505 m/s, then a very brief flash of light…

A: Velocity , v = 505 m/s Distance , d = 1 mm = 1 x 10-3 m Capacitance , C = 610 μF = 610 x 10-6 F To…

Q: If a spherical capatictor, filled with Mica, is in a connected series with a resistor of 600kohms…

A: The dielectric constant (k) of mica is 6. If a and b are the inner and outer radii of the spherical…

Q: Using the exact exponential treatment, find how much time (in s) is required to charge an initially…

Q: The figure shows a circuit containing an electromotive force, a capacitor with a capacitance of C…

Q: Consider an initially uncharged capacitor in an RC circuit. The resistance is 25,957 Ohms and the…

A: R = 25957 ohm C = 555×10-6 F V = 14.8 volts

Q: Find the value of R so that the power of 10k2 load resistor is 10mW, by assuming the source voltage…

A: This is an op-amp and the given circuit is a noninverting amplifier. Given(s): The input voltage,…

Q: Consider an initially uncharged capacitor in an RC circuit. The resistance is 20,000 Ohms and the…

Q: Consider the RC circuit shown in the figure below. If the resistance of the circuit is R=4kN and the…

A: Given: Circuit resistance, Capacitance, Battery emf,

Q: Consider a series RC circuit as in Figure below for which R =1.9 MQ, C=1.9 µF, and ɛ=30.0 V. Find…

Q: The capacitance in the curcuit is C = 0.3μF, the total resistance is R=20kQ and the battery emf is…

A: Capacitance of the capacitor (C) = 0.3 μFResistance (R) = 20000 ohm Emf (E) = 12 volts Initial…

Question

100%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The timing device in an automobile’s intermittent wiper system is based on an RC time constant and utilizes 0.5.00F capacitor and available resistor. Over what range must R be made to vary to achieve time constants from 2.00 to 15.0 s?
A 160F capacitor charged to 450 V is dischargedthrough a 31.2k resistor, (a) Find the time constant.(b)Calculate the temperature increase of the resistor, given that its mass is 2.50 g and its specific heat is 1.67kJ/kg °C,noting that most of the thermal energy is retained in the short time of the discharge, (c) Calculate the new resistance, assuming it is pure carbon. (d) Does this change in resistance seem significant?
In this chapter, most examples and problems involved direct current (DC). DC circuits have the current flowing in one direction, from positive to negative. When the current was changing, it was changed linearly from I=ImaxtoI=+Imax and the voltage changed linearly from V=Vmax to V=+Vmax where Vmax=ImaxR .Suppose a voltage source is placed in series with a resistor of R = 10 that supplied a current that alternated as a sine wave, for example, I(t)=(3.00A)sin(24.00st) . (a) What would a graph of the voltage drop across the resistor V(t) versus time look like? (b) What would a plot of V(t) versus I(t) for one period look like? (Hint: If you are not sure, try plotting V(t) versus I(t) using a spreadsheet.)
The timing device in an automobile's intermittent wiper system is based on an RC rime constant and utilizes a 0.500F capacitor and a variable resistor. Over whatrange must R be made to vary to achieve time constants from 2.00 to 15.0 s?
A capacitor with initial charge Q0 is connected across a resistor R at time t = 0. The separation between the plates of the capacitor changes as d = d0/(1 + t) for 0 t 1 s. Find an expression for the voltage drop across the capacitor as a function of time.
An ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations involtage oversmall time intervals, (a) If the resistance of the circuit (duemostly to that of the patient's chest) is 1.00kTwhat is the maximum capacitance of the circuit?(b) Would It be difficult in practice to limit the capacitance to less than the value found in (a)?
Show that the power dissipated by the load resistor is maximum when the resistance of the load resistor is equal to the internal resistance of the battery.
Consider a power plant is located 60 km away from a residential area uses Q-gauge (A=42.40mm2) wire ofcopper to transmit power at a current of I = 100.00 A.How much more power is dissipated in the copper wires than it would be in superconducting wires?
Consider a circuit that consists of a real battery with an emf and an internal resistance of r connected to a variable resistor R. (a) In order for the terminal voltage of the battery to be equal to the emf of the battery, what should the resistance of the variable resistor be adjusted to? (b) In older to get the maximum current from the battery, what should the resistance variable resistor be adjusted to? (c) In order for the maximum power output of the battery to be reached, what should the resistance of the variable resistor be set to?
Ralph has three resistors, R1, R2, and R3, connected in series. When connected to an ideal emf source E1, current I1 flows through the resistors. a. If the resistors are instead connected to a second source with E2=2E1, what is the new current through the resistors in terms of the first current? b. Show that, if each resistance is doubled and the resistors are connected in series to the second emf source, the current through the resistors is equal to I1.
Consider an initially uncharged capacitor in an RC circuit. The resistance is 20,000 Ohms and the capacitance is 500 x10• F. If the source potential being used to charge the capacitor is 15 V, how long after charging begins will the power delivered to the resistor be 25 % of its maximum value?
Consider an RC circuit in which R = 0.5 Ω, C=0.1 F, and Eo = 20 V. Given that the capacitor haszero initial charge, determine the current in the circuit after 0.25 seconds.