An electron (m = 9.11x1031 kg) accelerates in a uniform electric field E = 1.45 x 104 N/C. What is the acceleration of the electron after it traveled 10 cm in the electric field? O A. 2.55 x 1015 m/s2 O B. None 1.5 x 1014 m/s2 OD. 2.55 x 1014 m/s? O E. 1.5 x 1015 m/s?

An electron (m = 9.11x1031 kg) accelerates in a uniform electric field E = 1.45 x 104 N/C. What is the acceleration of the electron after it traveled 10 cm in the electric field? O A. 2.55 x 1015 m/s2 O B. None 1.5 x 1014 m/s2 OD. 2.55 x 1014 m/s? O E. 1.5 x 1015 m/s?

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 7P

See similar textbooks

Similar questions

4. A torsion prescription balance has a sensitivity requirement of 0.004 g. Explain how you would weigh 0.008 g of a substance with an error not greater than 5%.
Question 2: #52 An 80 kg construction worker sits down 2.0 m from the end of a 1450 kg steel beam to eat his lunch, as shown in Figure below. The cable supporting the beam is rated at 15,000 N. Should the worker be worried?
a) What is the mechanical advantage of a wheelbarrow, such as the one in Figure 9.24, if the center of gravity of the wheelbarrow and its load has a perpendicular lever arm of 5.50 cm, while the hands have a perpendicular lever arm of 1.02 m? (b) What upward force should you exert to support the wheelbarrow and its load if their combined mass is 55.0 kg? (c) What force does the wheel exert on the ground? Figure 9.24 (a) In the case of the wheelbarrow, the output force or load is between the pivot and the input force. The pivot IS the wheel's axle. Here, the output force is greater than the input force. Thus, a wheelbarrow enables you to lift much heavier loads than you could with your body alone. (b) In the case of the shovel, the input force is between the pivot and the load, but the input lever arm is shorter than the output lever arm. The pivot is at the handle held by the right hand. Here, the output force (supporting the shovel's load) is less than the input force (from the hand nearest the load), because the Input is exerted closer to the pivot than is the output
A person balances a meterstick in a horizontal position on the extended index fingers of her right and left hands. She slowly brings the two fingers together. The stick remains balanced, and the two fingers always meet at the 50-cm mark regardless of their original positions. (Try it!) Explain why that occurs.
Two children of mass 20.0 kg and 30.0 kg sit balanced on a seesaw with the pivot point located at the center of the seesaw. If the children are separated by a distance of 3.00 m, at what distance from the pivot point is the small child sitting in order to maintain the balance?
A device for exercising the upper leg muscle is shown in Figure 9.39, together with a schematic representation of an equivalent lever system. Calculate the force exerted by the upper leg muscle to lift the mass at a constant speed. Explicitly show how you follow the steps in the Problem-Solving Strategy for static equilibrium in Applications of Statistics, Including Problem-Solving Strategies
. Give two everyday examples of objects that are not in static equilibrium.
A weightless rod, 4.0 m long, supports three weights as shown. Where is its center of gravity? xCM = in m
The mass center G of the 1455-kg rear-engine car is located as shown in the figure. Determine the normal force under each tire when the car is in equilibrium. State any assumptions. Answers: 1381 mm 996 mm Normal force under each of the front tires: N;= Normal force under each of the rear tires: N₁ = i i N -/10 I N
How do you do this? A hungry bear weighing 700 N walks out on a beam in an attempt to retrieve a basket of goodies hanging at the end of the beam (see figure below). The beam is uniform, weighs 200 N, and is 6.00 m long, and it is supported by a wire at an angle of ? = 60.0°. The basket weighs 80.0 N. a) When the bear is at x = 1.00 m, find the tension (in N) in the wire supporting the beam and the components of the force exerted by the wall on the left end of the beam. b) If the wire can withstand a maximum tension of 875 N, what is the maximum distance (in m) the bear can walk before the wire breaks?
A double-decker London bus (Figure 1) might be in danger of rolling over in a highway accident, but at the low speeds of its urban environment, it's plenty stable. The track width is 2.05 m. With no passengers, the height of the center of gravity is 1.45 m, rising to 1.73 m when the bus is loaded to capacity. What is the critical angle for the unloaded bus? What is the critical angle for the loaded bus?
A man holds a 192-N ball in his hand, with the forearm horizontal (see the figure). He can support the ball in this position because of the flexor muscle force M→, which is applied perpendicular to the forearm. The forearm weighs 24.2 N and has a center of gravity as indicated. Find (a) the magnitude of M→ and the (b) magnitude and (c) direction (as a positive angle counterclockwise from horizontal) of the force applied by the upper arm bone to the forearm at the elbow joint. Please show how the angle in c was found