An elevator cab that weighs 24.5 kN moves upward. What is the tension in the cable if the cab's speed is (a) increasing at a rate of 1.06 m/s2 and (b) decreasing at a rate of 1.06 m/s²? (a) Number i Units

An elevator cab that weighs 24.5 kN moves upward. What is the tension in the cable if the cab's speed is (a) increasing at a rate of 1.06 m/s2 and (b) decreasing at a rate of 1.06 m/s²? (a) Number i Units

Name: An elevator cab that weighs 24.5 kN moves upward. What is the tension
Uploaded: 2024-03-20T06:57:57.000Z
Channel: Bartleby
Description: An elevator cab that weighs 24.5 kN moves upward. What is the tension in the cable if the cab's speed is (a) increasing at a rate of 1.06m/s2 and (b) decreasing at a rate of 1.06 m/s²?(a) NumberiUnits(b) NumberiUnits

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter4: The Laws Of Motion

Section: Chapter Questions

Problem 23P: A bag of cement weighing 325 N hangs in equilibrium from three wires as suggested in Figure P4.23....

See similar textbooks

Similar questions

A worker pulls a 15-kg crate in a straight line on a level surface by imparting a horizontal tension of 80 N to the free end of a cable whose other end is attached to the crate. If the coefficient of static friction is 0.40, what is the acceleration of the crate?
A box of mass 15.7 kg slides down an inclined plane without friction. If the acceleration, a, of the box along the direction of the plane is 4.1 m/s2, what is the angle θ (in degrees) of the plane with respect to the horizontal?
In Fig, a slab of mass m1 =40 kg rests on a frictionless floor, and a block of mass m2 =10kg rests on top of the slab. Between block and slab, the coefficient of static friction is 0.60, and the coefficient of kinetic friction is 0.40. A horizontal force of magnitude 100 N begins to pull directly on the block, as shown. In unit-vector notation, what are the resulting accelerations of (a) the block and (b) the slab?
A painting with a mass of 20 kg is suspended by two wires from a ceiling. If the wires make angles of 300 and 450 with the ceiling, find the tension in each wire.
A picture frame hung against a wall is suspended by two wires attached to its upper corners. If the two wires make the same angle with the vertical, what must this angle be if the tension in each wire is equal to 0.75 of the weight of the frame?
A 5kg crate is simultaneously acted upon by a force of 60N acting to the right that is parallel to the surface, and a force of 10N acting to the left, which makes a 30 degree angle with the horizontal. If the coefficient of kinetic friction is 0.15, then the magnitude of the acceleration of the crate is about _____ m/s2.
The cable supporting a 2105 −kg−kg elevator has a maximum strength of 23260 N. What maximum upward acceleration can it give the elevator without breaking?
The masses of the red and blue wagons are 6.09 kg and 2.63 kg, respectively. If the red wagon is pulled by 18.9 N force, the tension (N) in the cable connecting the two wagon of the system is:
There are two forces on the 1.19 kg box in the overhead view of the figure but only one is shown. For F1 = 15.7 N, a = 14.7 m/s2, and θ = 34.1°, find the second force (a) in unit-vector notation and as (b) a magnitude and (c) a direction. (State the direction as a negative angle measured from the +x direction.)
A student, crazed by final exams, uses a force of magnitude 80 N and angle u =70 to push a 5.0 kg block across the ceiling of his room ). If the coefficient of kinetic friction between the block and the ceiling is 0.40, what is the magnitude of the block’s acceleration?
What is the tension acting vertically in an a chilled of a heel, for a person standing still on horizontal ground on the ball of one foot and lifting the heel just off the ground? Take the weight of the person to be 600 N, the displacement
Two blocks, of masses m1=300g and m2=500g, are pushed by a force P. The coefficient of friction between each block and the table is 0.4. a. What must be the value of P? If the blocks are to have an acceleration of 200cm/s^2 b. How large a force m1 and then exert of m2?