An embankment consists of clay fill for which c=25 kPa and angle of internal friction is 260 9from consolidated undrained test with pore pressure measurement) The weight of fill per unit volume is 18.64 kN/m3. Compute the stress in kPa at depth of 20 m. Show free body diagram a.21.6 b.372.8 c.192.8 d.62.5

An embankment consists of clay fill for which c=25 kPa and angle of internal friction is 260 9from consolidated undrained test with pore pressure measurement) The weight of fill per unit volume is 18.64 kN/m3. Compute the stress in kPa at depth of 20 m. Show free body diagram a.21.6 b.372.8 c.192.8 d.62.5

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter15: Braced Cuts

Section: Chapter Questions

Problem 15.5P

See similar textbooks

Similar questions

An embankment consists of clay fill for which c=25 kPa and angle of internal friction is 260 (from consolidated undrained test with pore pressure measurement) The weight of fill per unit volume is 18.64 kN/m3. Compute the effective stress in kPa at a depth of 20 m. If the pore pressure at this point is shown by a piezometer to be 180 kPa. a. 62.5 b. 372.8 c. 192.8 d. 21.6
An embankment consists of clay fill for which c=25 kPa and angle of internal friction is 260 9from consolidated undrained test with pore pressure measurement) The weight of fill per unit volume is 18.64 kN/m3. Compute the stress in kPa at depth of 20 m. a. 192.8 b. 62.5 c. 21.6 d. 372.8
45.) A retaining wall supports a horizontal backfill that is composed of two types of soil. First layer: 5.91 meters high, Unit weight of 17.26 kN/m3, coefficient of active pressure of 0.291 Second layer: 5.36 meters high, Unit weight of 18.85 kN/m3, coefficient of active pressure of 0.301 Determine the distance of the total active force measured from the bottom of the wall. Round off to three decimal places.
A retaining wall 8 m high supports a cohesionless soil having a dry density of 1600 kg/m^3, angle of shearing resistance is 33 degrees and void ratio of 0.68. The surface of the soil is horizontal and level with top of the wall. Neglect wall friction and use Rankine’s formula for active pressure of a cohesionless soil. Determine the value of earth thrust on the wall per meter length if the soil is dry. a. 121 kN b. 186 kN c. 148 kN d. 137 kN determine the value of earth thrust on the wall if water level is 3.5 m below the surface. a. 230 kN b. 250 kN c. 180 kN d. 210 kN find the height above the base of the wall where the thrust acts during the water logged condition. a. 3.50 m b. 2.67 m c. 1.75 m d. 2.25 m
SOLVE FOR THE LOCATION AND MAGNITUDE OF THE PASSIVE AND ACTIVE THRUST OF THE RETAINING WALL. Along the passive side, the soil has the following properties: unit weight: 16 kN/m3, cohesion = 30 KPa, angle of internal friction = 25 degrees. and along the active side: sand: unit weight = 15 KN/m3, angle of internal friction = 30 degrees, and for clay: dry unit weight = 16.5 KN/m3, saturated unit weight = 19 kn/m3 , unconfined compressive strength = 48 KPa, angle of inter friction is 25 degrees. The height
A 4-m high embankment is to be constructed as shown in the Fig. 3 below. If the unit weight of soil used in the embankment is 19.0 kN/m3, calculate the vertical stress due to the embankment loading at points P1, P2 and P3. Use the Straight Line Law of Osterberg, 1957.
A rectangular channel with width = 10 meters and depth = 2 meters has a flow slope of 0.001 and roughness n = 0.025. The flow rate is 90 m3/s. Determine the shear stress on the channel in Pascals.
A concrete gravity dam with a trapezoidal section is holding water as shown in the figure. A distance of 15 meters from the toe, a drain is located. The drain has a pressure due to uplift of zero and increasing uniformly to full hydrostatic at the heel. Upstream face 1H:5V, while downstream face is inclined 1H:2V. Which of the ff nearly gives the maximum foundation pressure on the base of the dam in kilopascal ? Assume 23.54 kN/m3 for the unit weight of concrete. a. 3114 b. 1095 c. 4115 d. 964 e. 680
A retaining wall 6 m high supports cohesionless soil having a dry density of 1600 kg/m³, angle of resistance 32 and void ratio of 0.68. The surface of the soil is horizontal and level with the top of the wall. Neglecting wall friction and using Rankine’s formula for active pressure of a cohesionless soil. 1. Determine the nearest value of the total earth thrust on the wall in KN per lineal meter if the soil is dry. a. 73.1 b. 86.7 c. 62.4 d. 98.1 2. Find the nearest value of the thrust on the wall in KN per lineal meter if owing to inadequate drainage, it is waterlogged to a level of 3.5 m below the surface. a. 112 b. 171 c. 147 d. 153 3. Find at what height above the base of the wall the thrust acts during the waterlogged condition. a. 2.21 m b. 2.00 m c. 1.74 m d. 1.42 m
If the water table was found in the interface of clay and sand instead (at 5m depth), graph the effective stress diagram of the profile. Consider a 2.5m capillary rise and S = 85% in that capillary zone. The properties of the first clay layer apply to the entire zone above the capillary zone. For specific gravity, Gs = 2.68.
It is required to design a cantilever retaining wall to retain a 5.0 m high sandy backfill. The dimensions of the cantilever wall are shown in Figure 15.52 along with the soil properties. Check the stability with respect to sliding and overturning, based on the active earth pressures determined, usinga. Coulomb's earth pressure theory (δ' = 24°), andb. Rankine's earth pressure theory.The unit weight of concrete is 24 .0 kN/m3
A 10-m-thick layer of stiff saturated clay is underlain by a layer of sand (Figure 9.28). The sand is under artesian pressure. A 5.75-m-deep cut is made in the clay. Determine the factor of safety against heaving at point A.