An FM transmitter is medu lated with asingletone 75 Cos (2* 221014) and acarrier amplitudeof 68 volte The out put resistive load fornomodulation is 445 f and the modulation Constatkp - 321 Hzvolt for the given Purumetersgdetermine the fuillow ing- The average power in all'sidebands.2- The Carrier powerif the a mplitude of modulationSignalisreduced by 5 voltsa

Answered: Image /qna-images/answer/94744ded-3354-4be6-8297-b421164b8c89.jpg

An FM transmitter is medu lated with asingle tone 75 Cos (2* 2210lt) and acarrier amplitude of 68 Volte The out put resistive load forno modulation is 445e and the modulation Constat kf=321 Hz/volt for the given porumetersy %3D determine the fillowing= - The average power in allsidebands 2- The Carrier powerif the aL buplitudeof modelation Signalisreduced by 5 volts.

An FM transmitter is medu lated with asingle tone 75 Cos (2* 2210lt) and acarrier amplitude of 68 Volte The out put resistive load forno modulation is 445e and the modulation Constat kf=321 Hz/volt for the given porumetersy %3D determine the fillowing= - The average power in allsidebands 2- The Carrier powerif the aL buplitudeof modelation Signalisreduced by 5 volts.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A given FM transmitter is modulated with a single sinusoid, the output for no load power is 100W into50Ω resistive load. Then, the frequency of the modulating signal is carefully adjusted from zero untilthe modulated carrier encountered its zero amplitude as observed in spectrum analyzer. Under theseconditions, determine the: (Use the provided Bessel table)a. the modulation index and the number of significant sideband. b. total power on its significant sidebands. c. relative total power of the carrier and each of sideband. Ans. (a) Mf =2.4, N=5; (b) 99.86 W; b Pc=0W, P1=27.04W, P2=18.49W, P3=4W,
An Amplitude Modulation (AM DSBFC) radio broadcasting station with its carrier frequency of 750 kHz is amplitude-modulated by a 4 kHz audio signal to produce an AM envelope. The maximum and minimum peaks voltages of the envelope are 180Vp and 70Vp respectively. The equivalent resistance of the transmitting antenna is 60 Ω. Determine: (i) The peak amplitudes of the audio, carrier sideband voltages and modulation index. (ii) Using the above results, write the complete AM mathematical representation to express the waveform, showing its carrier, lower sideband and upper sideband parameters. (iii) The power of the carrier signal, total sidebands power and the bandwidth of the modulated signal. Then sketch and label the power spectrum of the modulated ( i v ) If the transmission is changed to Single-Side Band Suppressed Carrier (SSBSC), calculate the percentage power saving in comparison to the original AM DSBFC
A carrier (fc = 100 MHZ, A, = 25V) is frequency modulated by the sine wave (fm = 8 kHz, Am = 3V) using a frequency modulator with frequency deviation of 58kHz. Determine: (a) Carrier swing frequency of the output FM signal. (b) Highest and lowest sidebands' frequencies generated by the modulated signal. (c) The bandwidth of the FM signal. (d) The transmitted power through a 502 load. Ignore UnB < 0.1
A 1500 KHz carrier with amplitude of 50 V is amplitude modulated by 2 –KHz sine wave tone with a peak voltage of 15 V. Determine the modulation index, percent modulation, the upper and lower sideband frequencies, bandwidth of the wave, and write the AM equation.
A conventional amplitude modulated signal is generated using a carrier signal with frequencyfc = 20 kHz and a message signalm(t) = sin (3000πt) + 2cos (4000πt)The modulated signal is given as;xam(t) = 5[ 1+m(t)]cos (2π*fc*t)a) Determine and sketch the magnitude spectrum of the modulated signal.b) Determine the average power in the carrier and in the sidebands.
The SNRi of an FM transmitter is determined to be 24.093dBV. Solve for the peak frequency deviation caused by the noise if the transmitter sensitivity is determined to be 368.903Hz/V, and a modulating signal of 13.926V and the modulating index is kept at 4
Problem1: the figure shows multiple modulation schemes for the signal that is given by the dashed line sinusoidal function, the X-axis is the time axis is seconds and the Y-axis is the amplitude. Answer the following: 1. What is the modulation scheme in A? 2. What is the modulation scheme in B? 3. What is the sampling frequency? 4. What is the value of the duty cycle in A?
A sinusoidal carrier voltage of frequency 1 MHz and amplitude 100 volts is amplitude modulated by the sinusoidal voltage of frequency 5 kHz producing 50% modulation. Calculate the frequency and amplitude of lower and upper sideband terms. Draw the AM Spectrum.
A signal given by m(t) = 3cos(20πx103t) frequencymodulates a 1MHz carrier signal to produce a frequency deviation of 40KHz. Assume the carrier amplitude is 5V. a) Determine the modulation index. b) Write the time domain expression for the resulting FM signal ΦFM(t). c) What is the bandwidth of the signal.
In Amplitude modulation, Vestigal Side Band (VSB) is one of the technique used to overcome its limitations in terms of power and bandwidth. With this in mind; a. Explain how a VSB signal is generated in the transmitter. b. Draw and compare the frequency spectrum of the original message signal and the spectrum of the VSB signal in a frequency domain. c. Show how the bandwidth of VSB is calculated by writing the equation. d. Give one application of VSB in broadcasting.
Problem: The output signal from AM modulater la Scon(1800m) + 20 cox (2000) + 5com(2200x) Derive and find: Message signal and Carrier signal in time domain. Determin: Frequency of the message signal (Hz):.......... Determin: Frequency of the carreir signal (Hz):........... termin: Modulation index:...............….......... termin: Ratio of the power in the sidebands to power in the carrier, Paidebands/ Pearier:
Q 2 :J An audio signal given by 15sin(4000pi * t) + 20sin(8000pi * t) amplitude modulated(DSB-FC) a sinusoidal carrier wave 60sin(100, 000pi * t) a. Derive an expression for the modulated signal. b. Find the modulation index. c. Find the spectrum of the modulated signal. d. Sketch the spectrum of the modulated signal e. Which type of demodulation method you propose to reconstruct the audio at receiver. Why? to