An ideal gas, initially at 30°C and 100 kPa, undergoes the following cyclic processes in a closed system: (a) In mechanically reversible processes, it is first compressed adiabatically to 500 kPa, then cooled at a constant pressure of 500 kPa to 30°C, and finally expanded isothermally to its original state. (b) The cycle traverses exactly the same changes of state, but each step is irreversible with an efficiency of 80% compared with the corresponding mechanically reversible process. Note: The initial step can no longer be adiabatic. Calculate Q, W, ∆U, and ∆H for each step of the process and for the cycle. Take CP = (7/2)R and CV = (5/2)R.

Q: Q2/ One mole of an ideal gas, initially at 303.15 K (30°C) and I bar, is changed to 403.15 K (130°C)…

A:

Q: the isentropic efficiency of the turbine, b) the power produced by this turbine

A: Given: Inlet conditions P1=80 bar= 8 MPa T1=450oC Exit conditions P2=1 bar=100 kPa T1=150oC mass…

Q: Draw the Pressure-Volume Diagram and Temperature-Entropy (T-S) Diagram when a carnot engine operates…

A:

Q: A quantity of an ideal gas in an isolated system expanded isothermally and reversibly at 400 K from…

A:

Q: During a reversible process, 457 kJ of heat is added to 0.854 kg of a certain gas while the pressure…

A: Given: The heat added to the system is Q=457 kJ. The mass of the gas is m=0.854 kg. The constant…

Q: Air in a closed system undergoes the following reversible three-step cycle: 1-2 Isothermal…

A:

Q: Steam enters a turbine operating at a steady state at a pressure of 4 MPa, at temperature of 400…

A: Write the energy balance equation for the steady flow turbine as given as follows:

Q: An oxygen gas R = 0.2598 KJ/kg°k and k = 1.395. If 4 kg of oxygen undergo a reversible non flow…

A: Given Data: Process : Reversible Non Flow Constant Pressure Gas Constant R = 0.2598 KJ/Kg °k  k =…

Q: . Water flows through a horizontal coil heated from the outside by high temperature flue gases. As…

A: Given data as per question The initial pressure of water =200 kpa The initial temperature of water =…

Q: 0.05 kg of a certain gas in a piston and cylinder is compressed reversibly until the pressure…

A: Given: Mass of the gas (m)=0.05kg Initial pressure of the gas P1=0.1025MPa Initial volume of the gas…

Q: Q3/ One mole of an ideal gas, initially at 40°C and 1 bar, is changed to 120°C and 15 bar by three…

A:

Q: Aargon is compressed adiabatically in a steady-flow compressor from 101 kPa and 25 ∘C to 505 kPa. If…

A: Data given-  R = 208.14 J/kg-K  Wcompression = 475 kJ  P1 = 101 kPa  P2 = 505 kPa  T1 = 25°C = 298 K…

Q: 2. Steam enters an adiabatic turbine steadily at 5 MPa, 350°C, and 25 m/s, and leaves at 200 kPa and…

A:

Q: For a closed system, show that the total work for a reversible adiabatic process, (PV^k = C) is…

A:

Q: A 0.100 kg piece of ice at initial temperature −5.00 ◦C is placed in a perfectly insulated container…

A: Since you have put a multi-part question, we are providing the solutions to only first three parts…

Q: In order to analyze an internal combustion engine, consider an ideal gas with constant specific…

A:

Q: Q2/ One mole of an ideal gas, initially at 303.15 K (30°C) and 1 bar, is changed to 403.15 K (130°C)…

A: Given Initial temperature = 30o C = 303.15 K Final temperature = 130o C = 403.15 K Initial pressure…

Q: For adiabatic steady-flow devices, the vertical distance Δh on an h-s diagram is a measure of work,…

A: In adiabatic steady-flow devices, the enthalpy remains constant, and the process is called as…

Q: A fluid, flowing at 500 kg/h, goes through a reversible process. During the steady process, the…

A: Given Data: Mass flow rate, m=500 kg/h Heat rejected, Q=-60 kJ/s

Q: A 50-kg iron block and a 20-kg copper block, both initially at 80°C, are dropped into a large lake…

A:

Q: Discuss the during an internally reversible, adiabatic (isentropic) process, the entropy remains…

A: The total entropy of the system is the summation of entropy change due to internal reversibility and…

Q: steam enters a turbine with P= 4778 kpa and h 322.34 kj/kg with a flow of 6.996 kj/kg. and P= 2- kpa…

A: Given data :- h1=322.34 kj/kg h2= 6.996kj/kg Heat loss = 26.17 kj/kg

Q: An adiabatic device looks like an inverted T with 3.03 kg/s of steam at 4MPa and 600 ⁰C entering…

A:

Q: 4. Air is compressed steadily in an adiabatic compressor from 100 kPa and 25°C to 500 kPa and 167°C…

A:

Q: Q1: The gases in the cylinder of an internal combustion engine have a specific internal energy of…

A: Step by step solution is given below

Q: Helium (He) is compressed in an adiabatic compressor from an initial state of 0.9653 bar and 10°C to…

A:

Q: 7: The heat transfer explicitly for the reversible steady flow process 1-2-3-4-5-3 is shown in the…

A:

Q: Heat is lost through a plane wall steadily at a rate of 1500 W. If the inner and outer surface…

A: Given: The rate of heat lost through a plane wall steadily is Q=1500 W. The temperature of the inner…

Q: Determine net entropy change of the engine from Clausius inequality and thermal efficiency of the…

A: First of all, derive the net entropy change of the engine from the Clausius inequality, From the…

Q: Air initially at P1=920 kPa and T1=800K and V1=0.13m^3, expands isentropically, if the work produced…

A:

Q: Example 3.5 If the processes of Ex. 3.4 are carried out irreversibly but so as to accomplish exactly…

A:

Q: 0.5 kg of air in an insulated closed system is heated from 17°C to 427°C at constant pressure with…

A:

Q: reversible non-flow process occurs from which the work is 9.4 BTU. If the pressure varies as P = -V²…

A:

Q: During an isothermal process at 88°F, the pressure on 8 lbm of air drops from 80 psia to 5 psig. For…

A:

Q: Refrigerant 134a enters a compressor at 1.0 bar as a saturated vapor with a mass flow rate of 0.9…

A: Given that :-                                 p1=1 bar  m˙ =.9 kgminp2=8 bar Qr=140 kJminwc=3 Kw…

Q: A quantity of an ideal gas in an isolated system expanded isothermally and reversibly at 400 K from…

A:

Q: YES OR NO ? It is well known that the actual work between the two specified states depends on the…

A: Given: YES OR NO ? It is well known that the actual work between the two specified states depends on…

Q: air in a piston cylinder is expanded reversibly and adiabatically from P1= 400kPa V1=5L T1= 130C to…

A:

Q: Q3/A cylinder fitted with a frictionless piston contained an ideal gas, with a volume of 23 m³, a…

A:

Q: A cylinder fitted with a frictionless piston contained an ideal gas, with a volume of 23 m³, a…

A: Given: Initial volume of the gas: →V1=23 m3 Initial temperature of the gas: →T1=17°C=290 K Initial…

Q: Water steam flows steadily through an adiabatic turbine. The inlet conditions of steam are 1.0 x 106…

A:

Q: A driver applies the brakes on 1,000 kg automobile to stop from a speed of V = (70 + y/2) km/hr.…

A:

Q: A quantity of an ideal gas in an isolated system expanded isothermally and reversibly at 400 K from…

A:

Q: A closed system executed a reversible cycle 1-2-3-4 consisting of four processes. During processes…

A: Entropy of a system is the measure of degree of randomness of particles in the system. It is a…

Q: A Carnot engine operates between 37°C and 347°C. If the engine produces 620 kJ of work, the entropy…

A: Entropy is the measure of disorderness of any system. If heat flow occurs through any system, then…

Q: Define Reversible and Irreversible Processes for entropy ?

A: To define. The reversible and irreversible process. Concept used: Reversible process: A reversible…

Q: brought to a final temperature of 200 deg. F by a reversible non-flow process in each case and find…

A:

Q: A cylinder that contains 0.067 kg of carbon dioxide (with molar mass 44 kg/kmol), occupying a volume…

A:

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.