An inclined beam is supporting a concentrated load P-541 kN. Determine the absolute value of the vertical reaction at A (in kN). 4m 300 6m

Q: For the hydraulic structure shown below, draw a flow net for flow through the permeable layer and…

A: Given:  Coefficient of permeability Total head  Number of flow lines Number of equipotential lines…

Q: ect is attached to two strings with tensional force where T1= A angled at θ and T2= B angled at φ.…

A: given:mass of object taken is 'm'Angle of tension in wire 1 from x-axis=θAngle of tension in wire 2…

Q: The beam loaded shown in figure , find the spacing of Nail and the shear stress in the two glued…

A: Given Data:Nail resistance v= 8kg

Q: Poisson's ratio of a soil sample is 0.4. Using theory of elasticity, the estimated value of the…

A:

Q: The truss shown is acted upon by two forces. The 223 kN force acting at Joint A and the 100 kN force…

A:

Q: Q2: Draw Shear Force (S.F.D) and Bending moment diagram (B.M.D) for the beam as shown in figure.…

A: Given data in question  Load Moment  Span member length  To find out  SFD BMD

Q: ANALYZE THE STRUCTURE USING PORTAL FRAME METHOD. COMPUTE: RECUNDED. AXIAL LOAD OF AD AINT ALL MOMENT…

A:

Q: Q1:If allowable stresses are o, 165MPa.0, 100MPa = 70MPa determine max. value of W. M 300mm 100mm Im…

A:

Q: Q1) Water flows through a vertical contraction (venturi) section. Piezometers are attached to the…

A:

Q: 4500mm 4000mm 5500mm Bed only estimate volume of beam 1 5500mm -4500mm 6000mm Straight bottom ba #12…

A:

Q: A circular footing with a 1.5 m diameter is to be constructed 1.22 m below the ground surface. The…

A: Given:Diameter of the footing, D=1.5 mAngle of friction=25oFooting depth, df=1.22…

Q: measures the Gravity Field to determine

A: True (T)

Q: Q2/ Draw the influence lines for the vertical reaction at support A, the reaction moment at support…

A: Given data:- Beam show in figure;

Q: The section of a prestressed box girder is shown. Unit weight of concrete is 20 kN/m3. The total…

A: Given unit weight of concrete 20kn/m2 prestressing force,P = 3400 kN loss of prestress=15% length of…

Q: 1. Is normal fault affects and influence the tunnels? 2. Is reverse fault affects and influence the…

A:

Q: Q2) Water at 20°C flows at 30 m³/s in a rectangular channel that is 10 m wide. The flowing water…

A:

Q: An oil of viscosity 10 1 pipe (d = 80 mm). If pipe is 2000 kN/m² th mum velocity. of flow of oil.…

A:

Q: 2 t B * RB 100 lb/ft . 4 t C M = 1200 lb - E ਦੇ D 1t|1t RE

A:

Q: Where is/are the location(s) of the maximum compressive flexural stress? A simple I-beam is loaded…

A: A loaded beam is given and it has been asked to determine location of maximum flexural compressive…

Q: Which processes are an output of water from the aquifer? Infiltration A. baseflow B. C. abstraction…

A:

Q: 15. Consider the steady, two-dimensional, incompressible velocity field given by V- (u, v) (1.3…

A:

Q: The floor of an apartment building shown is subjected to a uniformly distributed dead load of 1.5…

A:

Q: For the truss shown, determine the normal stress of member AE, FB and CD. Identify if the stress is…

A: For the truss given below, the normal stress of member AE, FB, and CD are to be determined.

Q: Question 10 5 pts Both 50% marksmen, Cj and Jc agree to a firefight in which they alternate shots…

A:

Q: From the Levels of Biodiversity discussed. Pick one (1) level and cite one (1) example of that…

A:

Q: mine the force in mem ular Howe truss shown mine by inspection the

A:

Q: Discuss the purpose of the National Building Code and scope of application. Answer it briefly.

A: National Building Code- The National Building Code (NBC) is a comprehensive building code that…

Q: Draw the shear-force and bending-moment diagrams for the beam shown. Determine the bending moment…

A:

Q: 19.24 KN

A:

Q: Environmental Conservation/Protection Program implemented in your community or local government.

A: In India, pollution and environmental degradation levels are alarmingly high due to poverty,…

Q: Determine the reaction of the beam shown. 30kN/m A 5m 15kN/m 2m 50kN 2m

A: Given:   Required : Support reactions using method of consistent deformation

Q: The 4000 mm long eyebar BC shown in the figure has an outside dimension of 80mm x 40mm and a uniform…

A:

Q: builder design pattern for parking lot

A: Builder Design Pattern for parking lot:- Builder pattern are aiming to separate the construction of…

Q: A 4.5m square foundation exerts uniform pressure of 200kn/m^2 on a soil . Determine 1:the vertical…

A: Given: The dimension of the square foundation is 4.5 m. The uniform pressure is 200 kN/m2.

Q: A normally consolidated clay layer 3.25 m. thick has a void ratio of 1.11. Liquid limit is equal to…

A:

Q: What is Baseflow Index? A. amount of baseflow over amount of total streamflow B. amount of baseflow…

A:

Q: Situation 7: A C5x9 has a length of 1.40 m. Fy = 248 MPa. The propert Properties of C - Channel with…

A:

Q: 3. If total materials cost for the construction of a three-storey commercial building is…

A:

Q: A weir on a permeable foundation with downstream sheet pile is shown in the figure below. The exit…

A:

Q: Q2) Water at 20°C flows at 30 m³/s in a rectangular channel that is 10 m wide. The flowing water…

A:

Q: 1. В 21.

A:

Q: Q2: Draw Shear Force (S.F.D) and Bending moment diagram (B.M.D) for the beam as shown in figure.…

A: Draw Shear Force (S.F.D) and Bending moment diagram (B.M.D) for the beam as shown in figure. (with…

Q: Consider the beam shown in the figure. a. Draw the shear diagram of the be

A:

Q: A weir on a permeable foundation with downstream sheet pile is shown in the figure below. The exit…

A: The given figure is shown below:

Q: it is the depth difference between the waterlevel measured after some time during borehole pumping…

A: it is the depth difference between the waterlevel measured after some time during borehole pumping…

Q: Q.2) A state of stress is specified as shown in Figure (2), By using Mohr's circle determine the…

A: Radius of the circleR=(σx-σy2)2+τxy2R=(40+802)2+502R=78.1…

Q: Poisson's ratio of a soil sample is 0.4. Using theory of elasticity, the estimated value of the…

A: Poisson's ratio = μ = 0.4 It has been asked in the question to determine the lateral earth pressure…

Q: If the actual dimension is 46 m and the scaled dimension is 184 cm, what is the scale used?

A:

Q: A stream has a speed of 12 ft/s and is 2 ft deep. Find the angular spread of the wave set up by a…

A: Given that the velocity of the stream, v = 12 ft/s depth of the stream, y = 2 ft The angular spread…

Q: 2. The crawler wrecking crane is moving with a constant speed of 3 ft/s when it is suddenly brought…

A:

Matrix Algebra for Structural analysis

Structural analysis is a process in which the effects of different loads and internal forces, acting on structures and their elements are determined. This method of analysis is effective in detecting the failure loads of the structural elements and the design can be altered before commencing the construction process, which ensures proper strength and safety of the structures.