An incompressible fluid flows in a linear porous media with the following properties L= 2500 ft K= 105 md P1= 2100 psi h = 22’ Φ = 16% P2 = 2090 psi Width = 310’ µ = 2 cp Calculate: 1. Flow rate in bbl/ day 2. Apparent fluid velocity in ft/day 3. Actual fluid velocity in ft/day

Q: Oil (dynamic viscosity) between a block of mass M (5 kg) and the substrate (μ = 1.6 Pa.s), oil film…

A:

Q: A prototype submarine moves at velocity V, in fresh water at 20 °C, at a 2-m depth, where ambient…

A: Given    Depth, h = 2 m Pressure, P = 128 kPa Cavitation number, Ca = 0.25 Find   Velocity, v

Q: An incompressible fluid (kinematic viscosity, 7.4 x10-7 m2/s, specific gravity, 0.88) is held…

A:

Q: A fluid flowing through a tube 20ft long and of 0.62 inch inside diameter has the following has the…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: An oil of density 930kg/m and viscosity 0.02 Pa s flows through a pipeline with diameter 3 m at a…

A: Solution    Use Renolds model              ρvdμwater=ρvdμoil

Q: Pipelines are cleaned by pushing through them a closefitting cylinder called a pig . The name comes…

A: Given data To determine the required pressure differance in pascals to drive the pig.

Q: A constriction in a pipe will cause velocity to increase and pressure to fall at the throat. The…

A:

Q: 5. A 50-m duct is 0.060-m in diameter (Figure 2). Calculate the flow rate (m³/sec). Pfluid=917 kg/m³…

A:

Q: 1. An oil of density p and viscosity µ, drains steadily down the side of a vertical wall, as shown.…

A: Given data: The density of oil, ρ. The viscosity of the oil, μ. The thickness of the film, δ.…

Q: Problem 5. A thin oil film (u= 0.80 N - 8/m2.p=865 kg/m') of height h = 5.0 mm is squeezed between…

A: Given, Fluid Viscosity μ=0.8 Ns/m2 Density ρ = 865 kg/m2 Height h = 5 X 10-3 m Velocity of bottom…

Q: A sealed tank filled with a fluid which is maintained at 0.35 bar gauge and 20 0C. The fluid…

A:

Q: Example: Hydraulic conductance Estimate the hydraulic conductance of a filter cartridge that has a…

A: given data;⇒total…

Q: An incompressible fluid (kinematic viscosity =7.4x10-7 m2/s, specific gravity=0.88) is held between…

A: Given:Kinematic viscosity of fluid, ϑ=7.4×10-7 m2/sspecific gravity of fluid=0.88velocity, v=0.5…

Q: An incompressible fluid flows through a pipe without significant viscosity. It has a density of 124…

A: Given:r1=2.8 cm =0.028 mV1=13 m/sz1=0 mP1=103,763 Par2=3.87 cm =0.0387 mz2=5m

Q: Water flows in a pipe at 0.015 m³/s. The pipe is 50 mm bore diameter. The pressure drop is 13 420 Pa…

A:

Q: The velocity of a flow is given as V=-x² i+ (x + 2y) j. where V is in ft/s and X and y are in ft. •…

A:

Q: A seA A, soA A solid cylinder of diameter d, length and density p, falls due to gravity inside a…

A:

Q: Q2: oily water (13% oil by weight) flow through a pipe 1600 m length, calculate the liquid velocity…

A:

Q: A fluid with viscosity of u = 1.752 x 10-5kg/m. s and density of p= 1.2kg/m³ %3D flows at U=1 m/s…

A: We have to determine (a) Find the boundary layer thickness at the end of the plate. (b) Find the…

Q: As shown in figure 3, water (kinematic viscosity of water v =10 m's) flows out of a reservoir into a…

A:

Q: A small round object is tested in a 0.75-m diameter wind tunnel. The pressure is uniform across…

A:

Q: sample by using air. Flow rate = 2 cm3 /sec, T = 65°F, upstream pressure = 30 psi, downstream…

A: Solution: Given data: The flow rate, Q = 2 cm3/sec The downstream fluid pressure, PD = 14.7 psi The…

Q: Three pipes A. B, and C are interconnected as shown in figure 1. The pipe dimensions are as follows:…

A:

Q: Lubricant temperature = 60°C Ambient temperature = 15°C Bearing pressure in pump = 1.2 MPa Heat…

A:

Q: 4 A wind tunnel with a 7/1 inlet and test ratio. The test section is at standard sea-level…

A:

Q: Calculate the pressure of an oil of sp.gr. 0.8, and a mercury of sp.gr. 13.6 in N/cm3. Take density…

A:

Q: SAE 10 oil at 20 °C flows in a vertical pipe of diameter 2.5 cm.It is found that the pressure is…

A: The critical Reynolds's Number is written as,   Re,critical=ρVDμhere, flow…

Q: mechanics of fluids estimate the characteristics of hydraulic devices utilized in force…

A:

Q: QI): Impulse turbine diameter 3.2m O = 0: Angular velocity = 25 rad/s Absolute velocities V, 140m/s…

A: Given: The diameter of impulse turbine, D = 3.2 m The angular velocity, w = 25 rad/s The absolute…

Q: Water with a density of 1 g/cm³ flows through a horizontal pipe. The pipe cross-section tapers from…

A:

Q: Example (3.2) A fluid (p = 960 kg/m³) is flowing steadily through tube. The section diameters are d,…

A:

Q: A liquid of viscosity 1.74 x 103 Ns/m² is flowing through a horizontal capillary tube of diameter…

A: The expression of velocity is written as

Q: Water is flowing at 0.075 cu.m./sec through a glazed porcelain pipe 400m long and 200mm diameter.…

A:

Q: As shown in Fig. 2, the hydraulic pump suctioned oil from a large oil tank, the flow rate q =…

A: Given Q=150l/min =150×10-3m3/minQ=0.0025m3/seckinematic viscosity…

Q: Part 2 - Applving Bernoulli's Equation to a Pine Discharging from a Tank Half - Open Position (45…

A: Given Data, D= inner diameter of the pipe = 1.23 cm A = Computed pipe area = π4×1.232 A= 1.188 cm2…

Q: b) A continuous rigid belt, moving with uniform velocity U, passes vertically upwards through an…

A: Given data: The fluid is viscous and incompressible. Kinematic viscosity = constant Flow state:…

Q: A hydro turbine operates with a head of 50 m of water. Inlet and outlet conduits are  2 m in…

A: From bernoullis theorem we have P1ρg+v122g+Z1=P1ρg+v222g+Z2....................(1)P1, P2= Pressure…

Q: laminar fluid flows through a round pipe. What is the shape of fully developed velocity profile? a)…

A:

Q: Liquid is pushed through the narrow gap formed between two glass plates. The distance between the…

A:

Q: Estimation of void fraction of a packed column. A tube of 146 sq. in. cross section and 73 in.…

A:

Q: In air pipline, the flow has the following conditions at section 1: 25C. 1.8 bar, 15 m/s velocity,…

A:

Q: The continuity of flow equation is fundamental to much of the fluid flow in building services…

A:

Q: D. Part (a) : A polymer of densityp=0.85 g/cm³ and viscosity µ = 230 cP flows at a rate Q = 1,560…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: Question 11) Vortices are usually shed from the rear of a cylinder, which are placed in a uniform…

A: (1) The given variables are: Frequency: f The velocity of the stream: V Fluid density: ρ Fluid…

Q: What type of flowc

A: Laminar flow (re<2000)

Q: The resistance for flow through all feed arteries (assume N=2,000,000 feed arteries) can be…

A: given artery has length L=0.5cm=0.005mmartery has radius r=0.004cm=0.00004mviscosity of blood…

Q: Lubricating oil is pumped to flow with velocity, V between two stationary parallel plates separated…

A: