Answered: An inductance of 15mH has a current…

Engineering

Electrical Engineering

An inductance of 15mH has a current drawing I = 15sin(650t - 300) A. Determine the equation of voltage in the circuit

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 2PP: Assume that the current flow through the resistor, IR, is 15 A; the current flow through the...

See similar textbooks

Related questions

Q: II. In a 220 Vrms, 60 Hz. Source, determine the following values: a) Trigonometric equation b) V…

A: Given: Vrms=220 Vf=60 Hz

Q: Define Shift register and draw four-bit shift register using D-Flipflop.

A: Since these are two different questions, in the following section, the first question will be…

Q: What are the Z-parameters for the circuit below? ΤΩ Μ 3.j1 Ω ΤΩ Ο 211 = j, Z12 = 1+j, Z21 = 1+j, Z22…

Q: Q2 (i) Consider the circuit shown in Fig. 2.1. R = 100 Vi = Vsin t (a) (b) (c) (d) (e) C = 50 µF Vo…

A: As per the guidelines of Bartleby we supposed to answer first three subpart only for solution of…

Q: Which of the following is true about resistors that are connected in series? The reciprocal of the…

Q: Q2 A series RLC bandreject filter is used to reject a 200 Hz sinusoid while passing other…

Q: b. Determine the proper spatial sampling interval required to make small-scale propagation…

A: The minimum sampling frequency should be at least twice the frequency of the system. The proper…

Q: pam ww 5 ohms bo www.co 10 ohms www 15 ohms www 20 ohms 25 ohms www 30 ohms www do

Q: For the circuit shown, the switch was on position 2 for long time, then switched from position 2 to…

Q: 3. A dc motor develops 150 N-m and 50 N-m of torque at a speed of 250 rad/s and 750 rad/s…

A: A dc motor develops 150 N-m and 50 N-m of torque at a speed of 250 rad/s and 750 rad/s respectively…

Q: *10. Design a series resonant circuit to have a bandwidth of 400 Hz using a coil with a Q, of 20 and…

A: In this question, We need to design the series resonant circuit? If bandwidth BW= 400Hz,…

Q: An ideal battery of terminal voltage 22 volts charges two practical batteries connected in parallel…

Q: (b) Compare and contrast Memory-mapped I/O and I/O mapped I/O.

A: Memory Mapped Input Output − allocate a memory address to an Input-Output device. Any…

Q: 35.A 3-phase, 32 kW, 400 V, Hz star-connected synchronous motor has a full load efficiency of 90%.…

Q: The Li-ion battery commonly used in electronic devices is a secondary battery. Select one: True…

A: In this question, We need to choose the correct options Check The given Statment is true or false…

Q: A diode conducts 1mA at 20°C. If it is operated at 100°C, what will be the current? Given data:…

A: A diode conducts 1 mA at 20 °C. If it is operated at 100 °C. We need to find the current. Given…

Q: A long solid conductor with diameter 2 cm carries a current of 32 A uniformly over its cross…

Q: Q3: Find Req. between points (A&B) in the network in fig.(3). 2 425 lon 8.r Fig.3 TA Pa

Q: An oscillator differs from an amplifier because it * Requires no DC Has more gain Requires no input…

A: In this question we will write about oscillator etc...

Q: A simple RC oscillator has a feedback resistance of 20 ohms. The feedback capacitance of the same…

A: Given R=20Ω C= 35 F

Q: Q. No. 3: Determine the power absorbed by each of the resistors in the circuit shown in Fig. (3). 3…

A: In this question, We need to determine the power across the each resistance We know Power across…

Q: Please provide answers in at least 5 significant figures Surface charge densities are positioned in…

A: As we know due to infinite sheet charge tye electric field is only in the perpendicular direction of…

Q: (a) Point charges of 1 nC and 2 nC are located at (0, 0, 0) and (1, 1, 1), respectively, in free…

Q: Implement Four-to-one-line multiplexer with Logic diagram and Function table.

Q: (a) Reduce the following state table to a minimum number of states. Present Next State Output Z X=0…

A: a) We need to reduce the following state table to a minimum number of states. b) We are given two…

Q: β = 100. Check if approximation can be used. Show calculation proof. If yes, use approximatic…

A: We need to find out current and voltage for given circuit by using of approximate method

Q: Determine the values of i2, 14, V2, V3, and V6 in Fig.(2). - P3 - -4V- 6A 3A 12A ₂ Fig(2) 14

Q: Define full adder, make its truth table, solve for the equation of SUM and CARRY and draw its logic…

A: Full adder is a circuit that performs addition operation. Full adder is a digital circuit that adds…

Q: When resistors R1 and R2 are connected in parallel each resistor dissipate 100 W and 75 W,…

Q: Simplify the following Boolean functions by tracing it on a K Map, grouping of blocks the best…

Q: 10.A sequential circuit has two JK flip-flops A and B, two inputs x and y, and one output z. The…

Q: Determine the equivalent resistance between terminals a and b. O 6.9130 Q O 7.6547 Q O 5.9253 Q O…

A: In this question, We need to determine the equivalent resistance across the terminal a and b as…

Q: Prove the logic equality A. (B+C) = A B+ A.B.C

A: In this question we need to prove the given logic equality.

Q: What is the purpose of the N/O contact in parallel with the start button in the magnetic start…

Q: sketch the root locus for the system above. Hand written plzz D(S) 2) R(s) K. 5+7 C(s) (533) s G,(s)…

Q: A 2002 load receives power from parallel-connected battery cells, as shown in the figure below.…

A: We need to find out the load current for given circuit

Q: Determine both wo, R for R = 500, 50 50 mH Vo 5/0° A Table R ww R 5 μΗ Q0 Wrirad/s) f(Hz) IV,¹(kV)…

A: This is related to practical tank circuit case no. 3 in the result that i provided in the below…

Q: 3.- Suppose that each diode in the circuit shown in figure N°2 has a turn-on voltage of Vy=0.7…

Q: Determine the equivalent resistance between terminals a and b. 10 ohms www 10 ohms ww 10 ohms ww 10…

Q: The Laplace transformation of equation is given by: V₂ S Apply initial condition How? Taking the…

Q: On OP AMPS with negative feedback, what happens with the closed loop gain when we increase its open…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: what are the circui JAU

Q: ΤΩ ww 3Ω, 4Ω Be For the above circuit, determine the value for RAB, which is the equivalent…

Q: The reciprocal of the number of waves that occur in one second is frequency amplitude period time…

A: We need to select correct option for given statement

Q: For the circuit shown below, determine the power consumed by battery 1's internal resistance.

A: This question belongs to circuit theory . It is based on the concept of power consumption by the…

Q: Question 33 Given the circuit below, determine the magnitude of the current through the 20-volt…

A: Brief description: For the given electrical circuit we need to calculate current flowing through the…

Q: 11.A lightning load of 1500 kW and a motor load of 2200 kW at a pf of 0.707 are supplied by two…

A: In this question we will find kVA load and power factor of alternator.......

Q: A/Find the Norton equivalent circuit around R 5A 60 RL

A: Given figure,

Q: 4.1Calculate the energy capacity and the capacitance of a super capacitor consisting of X metal…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Determine the equivalent resistance between terminals a and b. ww 10 ohms 10 ohms 10 ohms ww 10 ohms…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

. An inductance of 15mH has a current drawing I = 15sin(650t - 300) A. Determine the equation of voltage in the circuit

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
Assume that the current flow through the resistor, IR, is 15 A; the current flow through the inductor, IL is 36 A; and the circuit has an apparent power of 10,803 VA. The frequency of the AC voltage is 60 Hz. ET ER EL IT IR15A IL36A Z R XL VA10,803 P VARSL PF L
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?