An infinitely long wire carrying the current / in the negative x direction is placed along the x-axis at distance d=D0.5m from a 5-turn circular loop with the diameter r = 0.1m located in the x-y plane and carrying current 12 =0.1A. (see the Figure). %3D 12 Q1: If the magnetic field at the center of the loop is zero, what is the direction of the current l2 flowing in the loop? O CCW O CW

Q: 6.7 In cylindrical coordinates, V = 0 at p = 2 m and V = 60 V at p = 5 m due to charge 10 distributi...

A: GIVEN:               (1)    V=0 at p=2m                      V=60V at p=5m                     ρr=10...

Q: What is the resulting PDN equation Y= ((A'+B')(C'+D'+E') + F')G' a) G+AB+CDEF b) ABE + CDEF + G c) ...

A:

Q: (b) Figure QI(b) shows an AC circuit. Given the voltage, V, across the impedance Z, is 111.803 4 - 4...

A:

Q: A 400hp induction motor and a 400hp synchronous motor both are operating at 90% efficiency. The indu...

A: The solution is given below 

Q: QUESTION 4 A 200mH inductor, a 820 ohm resistor, and a function generator are all connected in paral...

A:

Q: 102 4032 Reguivalent 71002 20

A: Given circuit shown 

Q: Consider the following digital logic circuit: Q AND R NOT NOT AND OR NOT NOT AND With initial values...

A:

Q: 0.8F t = 0 lit) 0.2F 8Ω 4i, 0.5F 20 V

A:

Q: A transformer has a 30 V input and a 10:1 turns ratio. Determine the secondary voltage

A: The transformer turns ratio is used to find the secondary voltage.  (V1/V2) = (N1/N2) = (10/1) Here ...

Q: Determine the V, voltage in the circuit of 42 100/45 V 10 2 Ve

A:

Q: A coil has a resistance of 14 Q at 50°C. If the temperature coefficient of resistance at 0°C is 0.00...

A: Given a coil has, AT temperature, T1=50 °C Resistance, R1=14 Ω Temperature coefficient at 0 °C is, α...

Q: Calculate G. in the circuit of Fig. 2.41.

A: The circuit given is shown below:

Q: 4. Figure shows a 1-0 system with power source that feeds a 120 kVA 12.47/2.4 kV transformer through...

A:

Q: 2- Find the inverse Laplace transform of the following functions 1 (a) G(s) = s (s+2)(s+3) 100(s +2)...

A:

Q: 1. Define: a) Communication b) Communication System c) Message d) Signal e) Transducer

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: 3.12 Using nodal analysis, determine V, in the circuit in Fig. 3.61. 20 Q 10Ω 20 Ω 4 Ig 10 Ω Vo 40 V...

A:

Q: Continuous-Time Filters 33. In Figure E.33 are some descriptions of filters in the form of an impuls...

A:

Q: find the differential equation that show the relationship between u(t) (input) and uR(t) (output)

A: The differential equation method is a very important approach to solve that electrical circuit that ...

Q: Write a matrix equation that determines the loop currents For each matrix, let row 1 corenpond to lo...

A:         A mesh is defined at a loop which does not contain any other loops within it. To apply mesh ...

Q: (c) A balanced three-phase wye-connected load is connected to a balanced three-phase delta-connected...

A:

Q: 20: Given ddc=0.98 , determine Bdc: Pac O Given determine the cormesponding Pdc =120 , value of c © ...

A:

Q: Question 1 Calculate the total amount of current that the battery must supply to this parallel circu...

A: 1)Given

Q: (c) A 50 kVA, 2300 V/460 V transformer has a primary winding resistance and reactance of 3.5 N and 8...

A:

Q: 6. Describe the chaxacterr'stecs of the ideal diode and how they O determine the on and off states o...

A:

Q: 18. what is the which of the transistor currents is ale source of leakage cerent în a transi'stor al...

A: In this question we will write answers to questions related to bipolar junction transistor e.g curre...

Q: The characteristics equation of the series RLC circuit is: s2 + (LC)s + † R 82 + (금)8+ R LC L s2 + (...

A:

Q: Which of the following are used by scientist and electricians for ease of work? a. circuit diagrams...

A: The explanation is as follows.

Q: (b) A balanced Y-connected load has phase voltage of 230 V and positive phase sequence. The impedanc...

A:

Q: The power input to the rotor of 440 V, 50 Hz, 6 pole, 3-phase, induction motor is 100 kW. The rotor ...

A: Given a 440 V, 50 Hz, 6 pole, 3 phase, induction motor is 100 kW. Motor frequency, f = 50 Hz Rotor m...

Q: 1.12* Add and multiply the following numbers without converting them to decimal. (a) Binary numbers ...

A: As per the guidelines of Bartleyby I need to answer first question only.

Q: 3.4 Given the circuit in Fig. 3.53, calculate the currents i, through i4. ЗА iz i3 6 A () 2 A 20 Q 1...

A:

Q: (b) A balanced Y-connected load has phase voltage of 230 V and positive phase sequence. The impedanc...

A: By using three phase voltages and currents     

Q: HE R2 : 1000R Xc 2363 GEN : 15 V V GEN pk-pk

A:

Q: Take note that for the capacitor, the input in the software must be the capacitance in nano-Farad (n...

A:

Q: 2. Find the inverse Laplace transforms, as a function of x a) 2s-3

A: Given function, Fs=12s-3

Q: Q1 (a) Based on electrical DC circuit as depicted in Figure Q1(a), (i) Determine the mesh currents I...

A:

Q: D.02)

A: Given that ρ=2.8×10-8 Ωm l=20 m I=15 A Et=P<3 w We have to find the Cross section Area

Q: The clipping circuit is shown in figure whose input varies from -50V to +50V. The slope of the trans...

A:

Q: HE + 230° V V 3Ω 50Z0° V +

A: Given circuit diagram

Q: 34. Which of the following is not a technique for FM demodulation? a) Phase locked discriminator b) ...

A: In this case, from the given options, the technique which is not an FM demodulation technique needs ...

Q: An 11 bit Ramp and SAC ADC has step size 10 mV. Determine digital output and number of steps for 5.2...

A: The number of steps for the given ramp ADC is,  Number of steps=2N-1N=11Number of steps=211-1Number ...

Q: 12V 10L RL Fig.1 Fig.2

A:

Q: 3. A three-phase, three wire, CBA system with an a line voltage of 150 Volt, has three impedances of...

A:

Q: 12V Re 102 RL Fig.2 Fig-1

A: Let the voltage drop during forward biased condition of the practical diode be 0.7 V. The diode is f...

Q: Sketch the transfer and drain curve characteristics for an n – channel JFET defined by IDSS = 12 mA ...

A: JFET (Junction Field Effect Transistor ) This is a three terminal semiconductor device namely the so...

Q: Compare the maximum conversion times of a 8-bit digital-ram p ADC and a 8-bit successive- approximat...

A:

Q: (c) A 50 kVA, 2300 V/460 V transformer has a primary winding resistance and reactance of 3.5 2 and 8...

A:

Q: The network is initially unenergized. At t=0, the switch is closed. Find currents i1(t)

A: Given diagram, Since source is initially Unenergized. There will be no initial current in inductor ...

Q: 4. Find 8-bit l's complement numerals representing the following decimal numerals: a. 89 b. 135 с. 2...

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...

Q: n 11 bit Ramp and SAC ADC has step size l0 mV. Determine digital output and number of  5 steps for ...

A: The DAC outputs a little higher (more positive) voltage as the counter counts up with each clock pul...

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.