GG-Translatecanvas C Coursera G Grammarly zy zyBooksAn L-C circuit has an inductance of 0.380 H and acapacitance of 0.200 nF. During the current oscillations,the maximum current in the inductor is 1.00 A25°▶Part APart BSubmitCS.HΑΣΦProvide FeedbackHow many times per second does the capacitor contain the amount of energy found in part A?Express your answer in times per second.View Available Hint(s)Previous AnswersSubmitX Incorrect, Try AgainCS.DCBrrrr N ML?GPT 7zandS-1COCO

Inductance, L = 0.380 HCapacitance, C = 0.200 nFMaximum current in inductor, I = 1 A

An L-C circuit has an inductance of 0.380 H and a capacitance of 0.200 nF. During the current oscillations, the maximum current in the inductor is 1.00 A Part A Part B How many times per second does the capacitor contain the amount of energy found in part A? Express your answer in times per second. View Available Hint(s)

An L-C circuit has an inductance of 0.380 H and a capacitance of 0.200 nF. During the current oscillations, the maximum current in the inductor is 1.00 A Part A Part B How many times per second does the capacitor contain the amount of energy found in part A? Express your answer in times per second. View Available Hint(s)

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 14.10CYU: Check Your Understanding The angular frequency of the oscillations in an LC circuit is 2.0103rad/s ....

See similar textbooks

Similar questions

In a damped oscillating circuit the energy is dissipated In the resistor. The Q-factor Is a measure of the persistence of the oscillator against the dissipative loss. (a) Prove that for a ligt1y danced circuit the energy, U, in the circuit decreases according to the following equation. du dt =2u,where= R 2L (b) Using the definition of the Q-factor as energy divided by the loss over the next cycle, prove that Q-factor of a lightly damped oscillator as defined in this problem is Q= U begin U onecycle = 1 R L C c (Hint: For (b), to obtain Q, divide E at the beginning of one cycle by the change E over the next cycle.)
The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
(a) Does the phase angle in an RLC series circuit depend on frequency? (b) What is the phase angle for the circuit when the inductive reactance equals the capacitive reactance?
(a) Does the phase angle in an RLC series circuit depend on frequency? (b) What is the phase angle for the circuit when the inductive reactance equals the capacitive reactance?
An RLC series circuit has an impedance of 60 and a power factor of 0.50, with the voltage Lagging the current (a) Should a capacitor or an inductor be placed in series with the elements to raise the power factor of the circuit? (b) What is the value of the capacitance or self-inductance that will raise the power factor to unity?
After the switch is dosed in the LC circuit shown in Figure CQ32.8, the charge on the capacitor is sometimes zero, but at such instants the current in the circuit is not zero. How is this behavior possible? Figure CQ32.8 Conceptual Question 8 and Problems 52, 54, and. 15.
A 60.0-ft resistor is connected in series with a 30.0-F capacitor and a source whose maximum voltage is 120 V, operating at 60.0 Hz. Find (a) the capacitive reactance of the circuit, (b) the impedance of the circuit, and (c) the maximum current in the circuit. (d) Does the voltage lead or lag the current? (e) How will adding an inductor in series with the existing resistor and capacitor affect the current? Explain.
A 200- resistor, 150- F capacitor, and 23-H inductor are connected in series with an ac source of amplitude 10 V and variable angular frequency . (a) What is the value of the resonance frequency R? (b) What is the amplitude of the current if =R ? (c) What is the phase constant of the current when =R ? Is it leading or lagging the source voltage, or is It In phase? (d) Write an equation for the voltage drop across the resistor as a function of time when =R . (e) What is the power factor of the circuit when =R ? (f) How much energy is used up by the resistor in 2.5s when =R ?
An RLC circuit connected across an AC voltage source at frequency f has resistance R, capacitive reactance XG and inductive reactance XL. If the frequency is doubled so that fnew = 2f, find the ratios (a) Rnew/R, (b) XC,new/XC, and (c) XL,new/XL.
An AC generator with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a 12.0-F capacitor. Find the (a) capacitive reactance, (b) rms current, and (c) maximum current in the circuit. (d) Does the capacitor have its maximum charge when the current takes its maximum value? Explain.
A coaxial cable has an inner conductor of radius a, and outer thin cylindrical shell of radius b. A current I flows in the inner conductor and returns in the outer conductor. The self-inductance of the structure will depend on bow the current in the inner cylinder tends to be distributed. Investigate the following two extreme cases. (a) Let current in the inner conductor be distributed only on the surface and find the self-inductance. (b) Let current in the inner cylinder be distributed uniformly over its cross-section and find the self-inductance. Compare with your results in (a).
An 80.0- resistor and a 200-mH inductor are connected in parallel across a 100-V (rms), 60.0-Hz source. (a) What is the rms current in the resistor? (b) By what angle does the total current lead or lag behind the voltage?