An op-amp is usually a differential amplifier havingO Dual input and only one outputSingle input and two outputs alwaysO Single input and single output alwaysO Unbalanced input and two outputs alwaysumumpto

Answered: Image /qna-images/answer/06acde1e-8c4f-4f2c-a62b-64cc2c60d2a4.jpg

An op-amp is usually a differential amplifier having O Dual input and only one output O Single input and two outputs always O Single input and single output always O Unbalanced input and two outputs always

An op-amp is usually a differential amplifier having O Dual input and only one output O Single input and two outputs always O Single input and single output always O Unbalanced input and two outputs always

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: In order to get single-ended operation using a diff amp both inputs are used. one input is used and…

A: Type of Differential amplifier Configuration Differential input with single-ended output…

Q: Calculate the voltage gain of inverting OP AMP if R2 =94kohms and R1 = 4.7kohms O -10 O -20 O +10 O…

Q: Op-Amp has output(s). a. Similar O b. Differential c. Single O d. Multiple

A: Amplifier is an electronic device whose output is amplified version of the input signal. The…

Q: The output of an op-amp comparator will be zero when both inputs are equal. Select one: O True O…

Q: d) close loop gain of the op-amp, AcL e) input impedance, Z; f) output voltage, V. 200 k2 2 k2 V. 2…

A: The solution is shown in the next step

Q: The output of an op-amp comparator will change of state when the input voltage exceeds the reference…

A: True . This statement is true as a comparator will comapre the values and will provide the output…

Q: The output levels of the open-loop op-amp are +12V. Determine the output voltage, vo in Volt when v1…

A: Output of opamp is at positive saturation levels when voltage at non inverting terminal is greater…

Q: In OP-AMP, signal applied to the non inverting input gets amplified output ,which is with the input…

A: As the input signal is applied to non inverting terminal so output signal is in phase i.e. 0 degree…

Q: The op-amp has 4 input terminals Select one: O a. FALSE O b. TRUE

A: Input terminal of Op amplifier

Q: 1. The input of a voltage follower has a square waveform. Draw the output waveforms (v.) of a…

A: Here it is given that the slew rate of the opamp is 0.25V/µS it means that the output of the opamp…

Q: With zero volts on both inputs, an OP-amp ideally should have an output 1. equal to the positive…

A: The correct option along with the explanation has been provided in the following section.

Q: Q.1 A certain op-amp has an open-loop gain of 80,000. The maximum saturated output levels of this…

Q: The output stage of an Op-amp is usually Differential amplifier Class A amplifier class B push-pull…

A: Output stage of Op amplifier

Q: An op amp is designed to be

A: An op amp is designed to be:

Q: Voltage when applied at 2 inputs of Op-amp to get 0 V of output is called_voltage. O a. Output…

Q: It is a concept based on the practical fact the differential input voltage between plus (+) minus…

A: In this question we will write about operational amplifier....

Q: 1. An integrated circuit (IC) op-amp has (a) two inputs and two outputs (b) one input and one output…

A: NOTE: “Since you have asked multiple question, we will solve the first question for you. If you want…

Q: The Op-amp can amplify 1. a.c. signals only 2. d.c. signals only 3. both a.c. and d.c. signals 4.…

A: The correct option along with the explanation has been provided in the following section.

Q: With zero volts on both inputs, an OP-amp ideally should have an output. 1. equal to the positive…

A: The correct option along with the explanation has been provided in the following section.

Q: It takes an op-amp 12 us to change its output from -10 V to +10 V. The slew rate of this op-amp is…

Q: An OP-AMP has a slew rate of 1 V/u sec with a gain of 40 decibel. If this amplifier has to…

Q: When an op-amp is operated in the single-ended differential mode, the output is grounded one input…

A: Operational Amplifier: A direct coupling amplifier that can increase the bandwidth of an input…

Q: With zero volts on both inputs, an OP-amp ideally should have an output ..... 1. equal to the…

A: Given when both the inputs of the op-amp are zero then we have to find the output of the IDEAL…

Q: Calculate the input bias current for op-amp circuit, when it has 10mA and 15mA input currents O…

A: input bias current is the average of two input bias current flowing into the inverting and…

Q: The if the input to a Differentiator op-amp is a DC signal then the magnitude of the output will…

Q: A certain op-amp has bias currents of 50µA and 49.3µA. The input offset * current is (a) 700 nA O…

Q: If the output polarity is same as that of input polarity but with amplification, then it should be a…

A: In case of operational amplifier we have many type of configuration amplifier amplifier voltage…

Q: op-amp are ±12V. R¡ = 10 kN, R2 = 30 kN and v = 1V. Determine the voltage gain in V/V. The maximum…

Q: A good op-amp has a O very high input resistance very low input resistance very high output…

Q: Determine the bias current, IBIAS, given that the input currents to an op-amp are * 7.9 µA and 8.3…

A: Given, The input currents of operational amplifier are I1 = 7.9 uA I2 = 8.3 uA

Q: The op-amp will only slightly amplify signals: O a. when the supply voltages are less than +/- 25V O…

A: Features of Operational amplifier High CMRR High input impedence Low output impedence High…

Q: List any four properties of a practical op amp.

A: In this question , we will write practical op-amp characteristics...

Q: 4. A differential op-amp circuit has a (a) positive gain (b) negative gain

A: Given A multiple choice question on differential op-amp circuit. please find the below attachment…

Q: An op-amp is usually a differential amplifier having O Single input and two outputs always O Dual…

Q: In an op-amp comparator, when the input voltage crosses zero, the voltage output will be always…

A: In comparator circuit of opamp, output will be either +Vsat or -Vsat. it will never be 0V.

Q: 3- For nonideal op amp, the letter A is called

A: As per the honour code I will only solve question 3. Kindly repost the other questions again. THANK…

Q: The following are common specifications of an op-amp except. O a. Gain O b. Input power O c. Offset…

A: Specification of opamp specifies how much opamp can give and it can take and also how much it can…

Q: It is the average of the two de currents that flows into the inverting and non- inverting inputs of…

Q: In an op-amp comparator, when the input voltage crosses zero , the voltage output will be always…

A: In op amplifier Op comparator when, the input voltage crosses zero, the output voltage will be…

Q: R +1 1=0 Vi R₂ 사 + output

Q: A good op-amp has a O very high slew rate O very low slew rate O very high output resistance O very…

A: Op amplifier property High slew rate High input impedance Low output impedance High bandwidth

Q: In the linear region of an op-amp, the output voltage is: Select one: O a. Between -VCC and VCC O b.…

A: An OPAMP (operational amplifier) is an integrated electronic circuit that is used to amplify weak…

Q: The third Op amp used in instrumentation amplifier is operated as amplifier O a. Non-inverting O b.…

A: Instrumentation amplifier is used to eliminate unwanted noise at the input terminals. To avoid…

Q: Identify the connection and application of each op-amp: A1, A2, A3 and A4

Q: A certain op-amp has an open-loop gain of 80,000. The maximum saturated output levels of this…

Q: A certain differential amplifier has R1 of 6.5 R2 of 8.6kN. Vin1=6.1mV and Vin2=23.7mV Then the…

Q: In the common mode of a differential amplifier, O a. opposite polarity signals are applied to its…

A: In common mode differential amplifier, Use 2 transistors in common emitter configuration

Concept explainers

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.

Question

An op-amp is usually a differential amplifier having
O Dual input and only one output
Single input and two outputs always
O Single input and single output always
O Unbalanced input and two outputs always
um
umpto

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Questions: 1.) It refers to an Op-Amp configuration where there is no feedback from the output back to the input. 2.) This is a type of IC that is especially useful as an audio oscillator because it has high gain, and it can easily be connected to produce positive feedback. 3.) A ________________ reduces the gain and improves many characteristics of the op-amp.
3K Calculate the the input Voltage of an inverting op-amp with the following parameters Rf = 1 MOhms, Ri = 20kOhms and Vo = 2V. a.3.47 mV b.-40 mV c.-3.47 mV d.40 mV
3)An op-amp is usually a differential amplifier having:which one 1-Unbalanced input and two outputs always 2-Single input and single output always 3-Single input and two outputs always 4-Dual input and only one output
3ZI The if the input to a Differentiator op-amp is a DC signal then the magnitude of the output will be.. a.Maximum b.Negative c.Zero d.Infinite
3ZC It is a concept based on the practical fact that the differential input voltage between plus (+) and minus (-) inputs is nearly 0 V—when calculated as the output voltage divided by the very high voltage gain of the op-amp. a.Voltage divider b.Zero potential c.Maximum power transfer d.Virtual ground
A certain op-amp has a CMRR of 250,000. Convert this to decibels.
Determine the output voltage of an op-amp for input voltages of V i1 =150 μν, V_{i2} = 140μV The amplifier has a differential gain of A_{d} = 4000 and the value of CMRR is: (a) 100. (b) 10 ^ 5
Find the maximum possible output voltage deliverable by an op-amp if it’s slew rate is 1volt/μs and frequency of input signal is 06.5 Khz.
Given an Ideal OP-AMP, what is the output voltage if the input voltage is Vi=0.9, R1=220 Ω and R2=2.7kΩ
A differential amplifier has an open-loop voltage gain of 150 when the input signals are 3.55V and 3.50 V. Determine the output voltage of the amplifier. a. 0.0225 kV b. 0.25 kVc.1 kV d. 1.25 kV
Does output voltage for a inverted op amp Voup= +Vsat
An op-amp has a differential voltage gain of 2000 and a CMRR of 20000. A single-ended input signal of 250 uVrms is applied and a 0.5Vrms, 50 Hz common-mode noise sigmal appears on both inputs from the ac power line. Calculate the output voltage. Choices: a) 0.5Vrms, b) 0.7Vrms, c) 0.75Vrms, d) 1.5Vrms