An open tank consists of 3 immiscible liquids, in which the water is at the height of 450 cm, above which a crude oil of specific gravity of 0.9 is filled up to a height of 2400 mm, above which a coconut oil of specific gravity of 0.86 is filled for about 5 m. without considering the atmospheric pressure Find: O the intensity of pressure in kPa at the interface between coconut oil & crude oil (1) the intensity of pressure in MPa at the interface between crude oil & water () the intensity of pressure in N/cm at the bottom of the tank (ENTER ONLY THE VALUES BY REFERRING THE UNITS GIVEN) Solution: The intensity of pressure at the interface between coconut oil & crude oil (unit in kPa) = * The intensity of pressure at the interface between crude oil & water (unit in MPa) = ( The intensity of pressure at the bottom of the tank (Unit in N/cm?) = v

An open tank consists of 3 immiscible liquids, in which the water is at the height of 450 cm, above which a crude oil of specific gravity of 0.9 is filled up to a height of 2400 mm, above which a coconut oil of specific gravity of 0.86 is filled for about 5 m. without considering the atmospheric pressure Find: O the intensity of pressure in kPa at the interface between coconut oil & crude oil (1) the intensity of pressure in MPa at the interface between crude oil & water () the intensity of pressure in N/cm at the bottom of the tank (ENTER ONLY THE VALUES BY REFERRING THE UNITS GIVEN) Solution: The intensity of pressure at the interface between coconut oil & crude oil (unit in kPa) = * The intensity of pressure at the interface between crude oil & water (unit in MPa) = ( The intensity of pressure at the bottom of the tank (Unit in N/cm?) = v

Name: An open tank consists of 3 immiscible liquids, in which the water is
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: An open tank consists of 3 immiscible liquids, in which the water is at the height of 450 cm, above which a crude oil of specific gravityof 0.9 is filled up to a height of 2400 mm, above which a coconut oil of specific gravity of 0.86 is filled for

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Similar questions

The surface tension of fluid in contact with air at 25oC is 0.51 n/m. The pressure inside a droplet is to be 0.05 N/cm2 greater than outside pressure. Determine the diameter of the droplet
Calculate the density of water vapor at 350 kPa abs and 20C if its gas constant is 0.462 kPa-m3/kg-K
A glass tube 1.6m long and having a diameter of 2.5cm is inserted vertically into a tank of oil (s.g. = 0.80) with the open end down and the closed end uppermost. If the open end is submerged 1.30m from the oil surface, determine the height to which the oil will rise in the tube. Assume barometric pressure is 100 KPa and neglect vapor pressure.
The pressure on the suction side of pumps is typically low, and the surfaces on that side of the pump are susceptible to cavitation, especially at high fluid temperatures. If the minimum pressure on the suction side of a water pump is 0.70 psia absolute, determine the maximum water temperature to avoid the danger of cavitation.
The submerged sector gate AB shown in the figure is 1/9 of a circle of radius 4 m. The length of the gate is 10 m. Determine the horizontal component of water pressure acting on the gate.
The surface tesnion of waterr in contact with air at 20deg C is given at 0.0716 N/m. The pressure inside a droplet of water is to be 0.0147 N/cm^2 greater than the outside pressure, calculate the diameter in mm of the droplet of water.
A 0.9 m diameter vertical cylindrical tank which is 1 m high and is open to the atmosphere contains water upto 0.3 m height. The tank is rotated about the centerline and the water level drops at the centre, while it rises at the edges. The angular velocity at which the bottom of the tank will be just exposed is _____ rad/s.
5. What is the pressure at the bottom of the 7.5 m tall storage tank of fluid at 25°C? Assume that the fluid is gasoline with atmospheric pressure 101 kPa on the top surface. Repeat the question for the liquid refrigerant R- 134a when the top surface pressure is 1 MPa. The densities of the liquids are: pgasoline = 750 kgm; PR-134a = 1206 kg/m2. %3D
The liquid inside the tank on the left side of the 2000 mm wide rectangular shaped lid hinged from the O point, which is seen in the middle of the figure, is under pressure of -22.50 kPa, and on the right side there is oil with a density of d= 0.80. Find the intensity and direction of the force that will act on the O point in order for this cover to remain in balance (Y(liquid)=0.9 kg/lt, Ig=bh^3/12). (Hava=air, Sıvı=liquid, yağ=oil)
The pressure on the suction side of pumps is typically low, and the surfaces on that side of the pump are susceptible to cavitation, especially at high fluid temperatures. If the minimum pressure on the suction side of a water pump is 0.51 psia absolute, determine the maximum water temperature to avoid the danger of cavitation. Find the maximum water temperature to avoid the danger of cavitation (in ºF).
A tube with diameter of 0.3cm is inserted into water (Surface tension= 0.061N/m). The water in the tube rises to a height of 0.45cm from the surface. Calculate the contact angle between the water and the tube.
Determine the pressure at the interface of liquids of an open tank containing 3 m of oil (SG=0.79) and 10 cm of mercury (13.6)