An open tank has the shape of a right circular cone. The tank is 8 feet across the top and 6 feet high. How much work is done in emptying the tank by pumping the water over the top edge? Work done: ??? ft-lb

An open tank has the shape of a right circular cone. The tank is 8 feet across the top and 6 feet high. How much work is done in emptying the tank by pumping the water over the top edge? Work done: ??? ft-lb

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter7: Conservation Of Energy

Section: Chapter Questions

Problem 32P: Sewage at a certain pumping station is raised vertically by 5.49 m at the rate of 1 890 000 liters...

See similar textbooks

Related questions

Q: A cylindrical water tank 4 meters high with radius of 2 meters is buried so that the top of the tank…

A: Density=Mass/volume Gravitational force=mass X acceleration due to gravity=mg Work done=potential…

Q: Two identical cylindrical vessels with their bases at the same level each contain a liquid of…

Q: The power available from a wind turbine is calculated by the following equation: P==Apu where P=…

A: Write the given values of this problem. The diameter of blade(d)=380 feetradius(r)=3802 feet(r)=190…

Q: A pump is required to lift a mass of 810 kgkg of water per minute from a well of depth 14.1 mm and…

A: Answer:- Given, Mass(m) = 810 kg water per minute…

Q: 350 J of work was done on a system where pressure stayed at 1300 Pa. By how much did the volume…

A: Given: The work done on the system is 350 J. The pressure of the system is 1300 Pa. Introduction:…

Q: A water tank is shaped like an inverted cone with height 6 m and base radius 1.5 m (as shown). a. If…

A: Given data: The radius is, R= 1.5 m The height is, h= 6 m Step 1 The diagram of the cone is as shown…

Q: *** A right circular cylindrical tank of depth 12 ft. and radius 4 ft. is half full of oil weighing…

A: The given tank is in the shape of a right circular cylinder with radius, r=4 ft, and depth, h= 12…

Q: How much work is required to pump all the water over the top of a full cylindrical task that is 2 m…

Q: A circular swimming pool has a diameter of 10 m, the sides are 3 m high, and the depth of the water…

Q: A manufacturer states that their gear pump requires 0.85 hp to pump 9 gpm of oil (sg=0.90) with a…

Q: A circular swimming pool has a diameter of 16 m, the sides are 4 m high, and the depth of the water…

A: Given the diameter of the pool is 16 m. Therefore, the radius of the pool will be 8 m. The depth of…

Q: What is the GPE of chandelier that has a mass of 9.5kg and is 3m high

A: Given data Mass is m= 9.5 kg Height is h= 3 m The formula for gravitational potential energy or…

Q: 16. A centrifugal pump runs at 1540 rpm and discharges 120 litres per second against a head of 25…

A: SOlution: Given that n = 1540 rpm Q = 120 LPS =0.12 m3/s H = 25 m D2 = 25 cm = 0.25 m t2 = 8 cm =…

Q: A water tank has the shape of the bottom half of a sphere with a radius of 4 meters. It is currently…

Q: How much work is required to increase the surface area of a container of water from 200.0 cm² to…

A: Surface tension (T) is the property of liquid that tries to minimize its free surface area. It is…

Q: Calculate the amount of work done in raising a glass of water of mass 0.4 kg to a height of 10 cm

A: The mass of the glass of water, m = 0.4 kg The height the glass being raised to, h = 10 cm = 0.10 m…

Q: A soap bubble is blown to a diameter of 7cm . If 36960 erg of work is done in blowing it furthur ,…

A: The expression for the work done is

Q: A circular swimming pool has a diameter of 24 f t, the sides are 5 f t high, and the depth of the…

Q: A tank is is half full of oil that has a density of 900 kg/m³. Find the work W required to pump the…

A: Givenρ(density of oil)=900 kg/m3r=3mh=1m

Q: One possible result of doing work on a system is the change in its Shape Speed System Composition

A: Introduction: The work is the energy transferred to or from an object via the application of force…

Q: A vertical right circular cylindrical tank measures 32 ft high and 18 ft in diameter. It is full of…

Q: The below figure shows a pump that transfers a steady stream of 35◦API crude oil from an oil tanker…

Q: Two identical cylindrical vessels with their bases at the same level each contain a liquid of…

Q: A spherical tank of diameter 4 m is half-full of water (weight density = 9800 N/m³). Setup the…

Q: A swimming pool is 20 m long and 10 m wide, with a bottom that slopes uniformly from a depth of 1 m…

A: Given,

Q: Steel ball with radius of 0.09 m lays on a bottom of the lake 5 m deep. What work is needed to lift…

A: Apply the Archimedes principle, and solve for the mass of the ball.

Q: For a given cylindrical tank, the radius is 8 m and the height is 18 m. The tank is filled to a…

A: Solution: Given that r = 8 m, h = 18 m water filled H = 10 m

Q: Calculate the Efficiency of a bulb a)Lumen:800 W=60 b)Lumen:780 w=13 c)Lumen:806 w=7.5…

A: a) Efficiency = No. of Lumens / No. of watts => Efficiency = 800/60 => Efficiency = 13.33…

Q: A conical tank with height 10 and radius 2 is filled to the top with a liquid weighing 15 N/m3 . How…

A: consider a small disk of radius r and height dh at a height h which is a small conethe small volume…

Q: Steel ball with radius of 0.09 m lays on a bottom of the lake 5 m deep. What work is needed to lift…

Q: A pump is used to lift 500kg of water from a depth of 80m in 10s. Calculate: (a) The work done by…

Q: Find the amount of work done in blowing a soap bubble of surface tension 0.06N/m from 2cm radius to…

A: The equation for the work done is given by,

Q: A man pushes a lawn mower on a level lawn with a force of 187 N. If 26% of this force is directed…

A: P=Wt=26%Fdt

Q: How many seconds it itakes to pump 10 tons of water to a tank 5 m up from the pump position with a 1…

Q: A tank in the shape of an inverted cone has a height of 15 meters and base radius of 4 meters and is…

A: Given: Height of cone tank, x = 15 m Radius of cone tank, r = 4 m Water is filled to depth = 12 m…

Q: Problem 2 A rectangular tank that is 88 feet long, 33 feet wide, and 1515 feet tall is filled with…

A: a) Work for pump all of the liquid out of the tank through the spout.The volume of the water strip…

Q: What is the SI (System International) Unit of the Density of Water as used in the Energy Calculation…

Q: Calculate the pressure exerted on the roof of a building which measures 2.0 m x 2.0 m and the force…

Q: How much work is required to pump all the water over the top of a full cylindrical tank that is 4 m…

Q: How much work is Done when a piston is compressed from 7.68L to 2.88L under constant atmospheric…

A: Given data The initial volume is given as Vi = 7.68 L. The final volume is given as Vf = 2.88 L.…

Q: A homogeneous cube of side length a and density ρc is pushed down into a liquid of density ρl ,…

A: Given: Density of cube =ρc Density of liquid =ρl Cube length = a Area =2a2

Q: If there is a 90 kg tub, what is the amount of work needed to move this from a unit onto a 1.0 m…

A: Given data: Mass (m) = 90 kg Height (h) = 1.0 m Required: Work done

Q: A full water tank in the shape of an inverted right circular cone is 8 m across the top and 4 m…

A: Write the given values using a suitable variable. Here h signifies cone height, r signifies cone…

Q: Example 1.29. Calculate the work done in blowing a soap bubble of diameter 100 mm. Assume e surface…

Q: A trough full of water is 20ft. long and its cross section is in the shape of an isosceles triangle…

A: Work is your trade with the world. You provide your time, agility and skills, and you get paid cash…

Q: A tank in the shape of an inverted cone has a height of 15 meters and base radius of 4 meters and is…

A: Let the radius of the cone is given by R. Let the height of the cone is given by H. Let the radius…

Question

An open tank has the shape of a right circular cone. The tank is 8 feet across the top and 6 feet high.
How much work is done in emptying the tank by pumping the water over the top edge?

Work done: ??? ft-lb

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Sewage at a certain pumping station is raised vertically by 5.49 m at the rate of 1 890 000 liters each day. The sewage, of density 1 050 kg/m3, enters and leaves the pump at atmospheric pressure and through pipes of equal diameter. (a) Find the output mechanical power of the lift station. (b) Assume an electric motor continuously operating with average power 5.90 kW runs the pump. Find its efficiency.
A circular swimming pool has a diameter of 24 f t, the sides are 5 f t high, and the depth of the water is 4 f t. How much work is required to pump all of the water out over the side? Use the fact that water weighs 62.5 lb/f t3 and g=1. Note: Just set up the integral. Do not evaluate it
A conical tank with height 10 and radius 2 is filled to the top with a liquid weighing 15 N/m3 . How much work spent pumping all of the liquid out of the tank through the top?
A circular swimming pool has a diameter of 16 m, the sides are 4 m high, and the depth of the water is 3 m. How much work (in Joules) is required to pump all of the water over the side? (The acceleration due to gravity is 9.8 ms2 and the density of water is 1000 kgm3.)
A cylindrical water tank 4 meters high with radius of 2 meters is buried so that the top of the tank is 1 meter below ground level.How much work is done in pumping a full tank of water up to ground level? (The water weighs 9800 newtons per cubic meter.) Work done:
A water tank is shaped like an inverted cone with height 6 m and base radius 1.5 m (as shown). a. If the tank is full, how much work is required to pump the water to the level of the top of the tank and out of the tank? b. Is it true that it takes half as much work to pump the water out of the tank when it is filled to half its depth as when it is full? Explain.
How much work is required to pump all the water over the top of a full cylindrical tank that is 4 m in diameter and 7 m high? (Unit of work= Joules, J) Specific weight of water = 9.81 kN/m³
Application of Integration: A tank in the form of an inverted right-circular cone is 8m across the top and 10m deep. The tank is filled to a height of 8m with oil weighing 950kg/m3. Find the work done in pumping all the oil to the top of the tank. Note: g 9.8 m/s2
A circular swimming pool has a diameter of 10 m, the sides are 3 m high, and the depth of the water is 2.5 m.How much work (in Joules) is required to pump all of the water over the side? (The acceleration due to gravity is 9.8 m/s2 and the density of water is 1000 kg/m3.)
Your client is planning to drain their swimming pool and decided to pump it until it drained. A two horsepower motor can do 1100 ft-lb of work per second. They have 0.2 hp motor to used to pump water from a full tank in the shape of a rectangular swimming pool with a 4ft deep, 4 ft wide, and 12 ft long to a 10 ft above the top of the tank, how long it will take?
A full water tank in the shape of an inverted right circular cone is 8 m across the top and 4 m high. If the surface of the water in the tank is 2 m below the top of the tank, how much work is required to pump all the water over the top of the tank? (The density of water is 1000 kg/m3. Assume g = 9.8 m/s2.) Answer in exact form
A tank in the shape of an inverted right circular cone has height 5 meters and radius 2 meters. It is filled with 3 meters of hot chocolate. Find the work required to empty the tank by pumping the hot chocolate over the top of the tank. The density of hot chocolate is ?=1070 kg/m3. Your answer must include the correct units.