An orangutan leaps off of a cliff and its body begins to rotate clockwise. If the orangutan then starts to rotate both of its arms counter-clockwise, which of the following happens: The clockwise rotation of its body will be faster The clockwise rotation of its body will be slower The clockwise rotation speed of its body will not change Cannot say, not enough information provided

An orangutan leaps off of a cliff and its body begins to rotate clockwise. If the orangutan then starts to rotate both of its arms counter-clockwise, which of the following happens: The clockwise rotation of its body will be faster The clockwise rotation of its body will be slower The clockwise rotation speed of its body will not change Cannot say, not enough information provided

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter10: Fixed-axis Rotation

Section: Chapter Questions

Problem 13CQ: A solid sphere is rotating about an axis through its center at a constant rotation rate. Another...

See similar textbooks

Similar questions

An athlete in a gym applies a constant force of 50 N to the pedals of a bicycle to keep the rotation rate of the wheel at 10 rev/s. The length of the pedal arms is 30 cm. What is the power delivered to the bicycle by the athlete?
A potters wheela thick stone disk of radius 0.500 in and mass 100 kgis freely rotating at 50.0 rev/min. The potter can stop the wheel in 6.00 s by pressing a wet rag against the rim and exerting a radially inward force of 70.0 N. Find the effective coefficient of kinetic friction between wheel and rag.
An automobile engine can produce 200Nm of torque. Calculate the angular acceleration produced if 95.0 of this torque is applied to the drive shaft, axle, and rear wheels of a car, given the following information. The car is suspended so that the wheels can turn freely. Each wheel acts like a 15.0-kg disk that has a 0.180-m radius. The walls of each tire act like a 2.00-kg annular ring that has inside radius of 0.180 m and outside radius of 0.320 m. The tread of each tire acts like a 10.0-kg hoop of radius 0.330 m. The 14.0-kg axle acts like a rod that has a 2.00-cm radius. The 30.0-kg drive shaft acts like a rod that has a 3.20-cm radius.
A sphere of mass 1.0 kg and radius 0.5 m is attached to the end of a massless rod of length 3.0 m. The rod rotates about an axis that is at the opposite end of the sphere (see below). The system rotates horizontally about the axis at a constant 400 rev/min. After rotating at this angular speed in a vacuum, air resistance is introduced and provides a force 0.15 N on the sphere opposite to the direction of motion. What is the power provided by air resistance to the system 100.0 s after air resistance is introduced?
Repeat Example 10.15 in which the stick is free to have translational motion as well as rotational motion.
Two flywheel fo negligible mass and different radii are bounded together and rotate about common axis (see below). The smaller flywheel of radius 30 cm has a cord that has a pulling force of 50 N on it. What pulling force needs to be applied to the cord connecting the larger flywheel of radius 50 cm such that the combination does not rotate?
Today, waterwheels are not often used to grind food. Instead, we have electrical devices such as blenders, choppers, and mixers. The electric motors in these devices are similar to a waterwheel, but instead of falling water causing the wheel to spin,electricity causes a shaft to spin. The specifications on a particular electric motor reports that at 1.75 103 rpm, it puts out5 hp. What is the corresponding torque in N m?
The blades of a wind turbine are 30 m in length and rotate at a maximum rotation rate of 20 rev/min. (a) If the blades are 6000 kg each and the rotor assembly has three blades, calculate the angular momentum of the turbine at this rotation rate. (b) What Is the torque require to rotate the blades up to the maximum rotation rate in 5 minutes?
A bowling ball of mass 7.00 kg is rolling at 3.00 m/s along a level surface. Calculate (a) the balls translational kinetic energy, (b) the balls rotational kinetic energy, and (c.) the balls total kinetic energy, (d) How much work would have to be done on the ball to bring it to rest? (See Section 8.6.)
A stick of length 1.0 m and mass 6.0 kg is free to rotate about a horizontal axis through the center. Small bodies of masses 4.0 and 2.0 kg are attached to its two ends (see the following figure). The stick is released from the horizontal position. What is the angular velocity of the stick when it swings through the vertical?
In 2015, in Warsaw, Poland, Olivia Oliver of Nova Scotia broke the world record for being the fastest spinner on ice skates. She achieved a record 342 rev/min, beating the existing Guinness World Record by 34 rotations. If an ice skater extends her aims at that rotation rate, what would be her new rotation rate? Assume she can be approximated by a 45-kg rod that is 1.7 m tall with a radius of 15 cm in the record spin. With her aims stretched take the approximation of a rod of length 130 cm with 10 of her body mass aligned perpendicular to the spin axis. Neglect frictional forces.
A diver goes into a somersault during a dive by tucking her limbs. If her rotational kindetic energy is 100 J and her moment of inertia in the tuck is 9.0kgm2 , what is her rotational rate during the somersault?