An RL circuit consists of a resistor with a resistance of 13 Ohms and an inductor with an inductance of 3.71 H. At t = 0s, the circuit is connected to a source potential of 34 V. At what time will the current be 74.5 % of its maximum value?

An RL circuit consists of a resistor with a resistance of 13 Ohms and an inductor with an inductance of 3.71 H. At t = 0s, the circuit is connected to a source potential of 34 V. At what time will the current be 74.5 % of its maximum value?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 69CP: An RLC series circuit consists of a 50 resistor, a 200F capacitor, and a 120-mN inductor whose coil...

See similar textbooks

Related questions

Q: A 36.0-mH inductor is connected to a North American electrical outlet (AVms 120 V, f = 60.0 Hz).…

A: Given value--- L = 36 mH. Vrms = 120 V. frequency = 120 Hz. time t = 1/170 sec. We have to…

Q: An LR circuit is hooked up to a battery which the switch initially open. The resistance in the…

A: Formula of current passing through the LR circuit is as follows: I=VsR1-e-tRL…

Q: An inductor of inductance 6.0H and resistance 640 ohms is connected in series to two resistors which…

A: Given: The value of first resistor is R1=640 Ω The inductor has a value of L=6 H. Out of the…

Q: What differential equation corresponds to an RL circuit with a resistor of R = 100 and an inductor…

Q: An RL circuit has an emf source of 28 v, a 62 resistor, a 38 H inductor, and a switch. At what rate,…

A: Given:- In the RL circuit The emf of the source voltage V = 28 V The resistance R = 6 ohm The…

Q: The time variation of the current in a 3H inductor is given by I=5+7t-7t^2, with I in amperes and t…

Q: RL circuit

Q: A wooden toroidal core with a square cross section has an inner radius of 13 cm and an outer radius…

A: Given : Inner radius (a) = 13 cm = 0.13 m Outer radius (b) = 16 cm = 0.16 m Diameter (d) = 0.90 mm =…

Q: A circuit is constructed with a resistor, two inductors, one capacitor, one battery and a switch as…

Q: A 32.0 [] resistor, a 0.40 [H] inductor, and a 20.0 [F] capacitor are connected in series to form an…

Q: An L-C circuit has an inductance of 0.450 H and a capacitance of 0.240 nF. During the current…

Q: A circuit consists of a 35 N resistor and a 580 mH inductor connected in series to a 12 V battery.…

Q: An inductor with inductance 10.23 H and a resistor with resistance 3.24 ohms are connected in series…

A: This is an LR series circuit problem. All the given data is already in SI units so we don't need to…

Q: For the RL circuit shown in Figure, let the inductance be 3.00 H, the resistance 8.50 ohm, and the…

A: Given, The inductance, L= 3 H, the resistance, R= 8.50 Ω, Emf, V= 36 V, and current, I= 2 A.

Q: A 32.0 [] resistor, a 0.40 [H] inductor, and a 20.0 [µF] capacitor are connected in series to form…

A: In an LCR circuit the circuit is termed as damped oscillation since the resistor acts as energy…

Q: A circuit is constructed with a resistor, two inductors, one capacitor, one battery and a switch as…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: An inductor has a current I(t) = (0.480 A) cos[(260 s1)t] flowing through it. If the maximum emf %3D…

A: NOTE: As per guidelines, I can solve first question only. If you need help with other questions,…

Q: A 1.25 H inductor in an RL circuit (with resistance 2.2 Ω) is initially fully charged. A switch is…

A: When the switch is at position 2, the expression for the current will be,

Q: A circuit is constructed with a resistor, two inductors, one capacitor, one battery and a switch as…

A: Given, Resistance=231ohm Inductance=307mH Capacitance=190muoF Voltage=12v

Q: A 12.6-V battery is in series with a resistance of 0.304 Ω and an inductor. (a) After a long time,…

Q: Consider an RLC circuit with emf amplitude Em = 10 V, resistance R = 10 N, inductance L = 1.0 H, and…

A: Given data: The emf amplitude is εm=10V. The resistance is R=10 Ω. The inductance is L=1.0 H. The…

Q: For the RL circuit shown above, let the inductance be 3.00 H, the resistance 8.00 Ω, and the battery…

Q: A circuit is constructed with a resistor, two inductors, one capacitor, one battery and a switch as…

A: As per guidelines we are suppose to do only three subpart from multipart question, kindly post rest…

Q: a circuit having an inductance of L=2mH has a current that varies with time as I=t^3e^-t. find the…

A: Emf induced can be given by, ∈=LdIdt where L is inductance and I is current and t is time. To be…

Q: A 16.0-mH inductor is connected to a North American electrical outlet (AVms = 120 V, f = 60.0 Hz).…

Q: A series circuit consists of a resistor with R = 20 0, an inductor with L = 1 H, a capacitor with C…

A: Here we'll find the complimentary and particular solutions of the 2nd order differential equation to…

Q: Consider an inductor with L = 15 mH and a resistor with R = 3 kΩ. At what frequency is the reactance…

A: Inductance, Resistance,

Q: A circuit is constructed with a resistor, two inductors, one capacitor, one battery and a switch as…

Q: 13 R2 R1 L An inductor with inductance L = 1 H and negligible resistance is connected to a battery,…

Q: A 20-Volt power supply is connected to a series R-L circuit and the current begins flowing at t = 0.…

A: Let V be the emf of the battery, I be the current through the circuit, R be the resistance and L be…

Q: ») What is the characteristic time constant (in s) of a 25.5 mH inductor that has a resistance of…

Q: Consider an RLC circuit with emf amplitude Em= 10 V, resistance R = 10 2, inductance L = 1.0 H, and…

A: 1.0 kV

Q: A circuit has a resistor with resistance equal to 8 Ω and an inductor with inductance 8e-4 H. What…

A: Solution is as follows:

Q: A simple LC circuit has an inductance of 23 mH and a capacitance of 3 mF. At t=0 there is 1 J stored…

A: At t=0 seconds, Energy on capacitor was 1 J.

Q: In a series RL circuit, the resistance is 135 ohms, the inductance is 120 x 10-3 H, and the source…

Q: An LC circuit like the one in the figure below contains an 70.0 mH inductor and a 12.0 uF capacitor…

A: The charge on the capacitor at time t = 1.00 ms is,

Q: A battery is used to charge a capacitor. When the stored energy in the capacitor is 1 µj, it is…

A: Given : Maximum energy stored in capacitor, Emax = 1 μJ Inductance, L = 6 μH

Q: A series RL circuit includes a 4.05 V battery, a resistance of R = 0.555 Q, and an inductance of L =…

A: Given data- voltage source V=4.05 V resistance R=0.555 ohm inductance L=2.03 H induced emf after…

Q: An LC circuit like the one in the figure below contains an 70.0 mH inductor and a 12.0 uF capacitor…

A: Given data The magnitude of the inductance of an inductor is L = 70 mH = 70 x 10-3 H The capacitance…

Q: A 20.0 kHz, 16.0 V source connected to an inductor produces a 2.00 A current. What is the…

Q: A 4.7-µF capacitor and a 200-S resistor are connected in series. If you want to connect an inductor…

Q: What is the inductance of a coil in which the average emf induced is 20.0 mV when the current in…

A: E = 20mV 3.5 A to 7.7 A t = 0.33 sec L=?

Q: The voltage across an inductor is 4.0 x 10-6V when the current through it decreased at a rate of…

A: Given:Voltage, V = 4×106 Vdidt = 4 A/s

Q: A wooden toroidal core with a square cross section has an inner radius of 10 cm and an outer radius…

A: a) The required value of inductance is,

Q: An inductor with inductance 15.34H and a resistor w/ resistance 3.432 are connected in series to a…

Q: What resistance R should be connected in series with an inductance L= 220 mH and capacitance C= 12.0…

A: Assume it is a RLC circuit, thus the expression for the time of N cycles is given is,

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time must the 0.100-A current through a 2.00-mH inductor be switched on or off to induce a 500-V emf?
In an oscillating RLC circuit with L = 10 mH, C = 1.5 F , and R = 2.0 , how much time elapses before the amplitude of the oscillations drops to half its initial value?
The current I(t) through a 5.0-mH inductor varies with time, as shown below. The resistance of the inductor is 5.0 . Calculate the voltage across the inductor at t = 2.0 ms, r = 4.0 ms, and t = 8.0 ms.
At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?
The self-inductance and capacitance of an LC circuit e 0.20 mH and 5.0 pF. What is the angular frequency at which the circuit oscillates?
Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If h = 0.10 m, what is the ratio of its outer radius to its inner radius?
In an oscillating LC circuit the maximum charge on the capacitor is 2.0 × 10-6 C and the maximum current through the inductor is 8.0 mA. (a) What is the period of the oscillations? (b) How much time elapses between an instant when the capacitor is uncharged and the next instant when it is fully charged?
In an LC circuit, what determines the frequency and the amplitude of the energy oscillations in either the inductor or capacitor?
In an RLC series circuit, can the voltage measured across the capacitor be greater than the voltage of the source? Answer the same question for the voltage across the inductor.
An RLC series circuit consists of a 50 resistor, a 200F capacitor, and a 120-mN inductor whose coil has a resistance of 20. The source for the circuit has an tins emf of 240 V at a frequency of 60 Hz. Calculate the tins voltages across the (a) resistor, (b) capacitor, and (c) inductor.