An RLC series circuit has a voltage source given by E(t) = 15 V, a resistor of 120 £2, an inductor of 4 H, and a capacitor of 0.02 F. If the initial current is zero and the initial charge on the capacitor is 7 C, determine the current in the circuit for t> 0. 1(1) = 0 (Type an exact answer, using radicals as needed.) GITH

An RLC series circuit has a voltage source given by E(t) = 15 V, a resistor of 120 £2, an inductor of 4 H, and a capacitor of 0.02 F. If the initial current is zero and the initial charge on the capacitor is 7 C, determine the current in the circuit for t> 0. 1(1) = 0 (Type an exact answer, using radicals as needed.) GITH

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 3CQ: In an RLC series circuit, can the voltage measured across the capacitor be greater than the voltage...

See similar textbooks

Similar questions

In an RLC series circuit, can the voltage measured across the capacitor be greater than the voltage of the source? Answer the same question for the voltage across the inductor.
At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?
Show that for the circuit shown below, the initial energy stored in the inductor, LI2(0)/2 , is equal to the total energy eventually dissipated in the resistor 0I2(t)Rdt.
An RLC series circuit consists of a 50 resistor, a 200F capacitor, and a 120-mN inductor whose coil has a resistance of 20. The source for the circuit has an tins emf of 240 V at a frequency of 60 Hz. Calculate the tins voltages across the (a) resistor, (b) capacitor, and (c) inductor.
In an oscillating LC circuit, the maximum charge on the capacitor is qm. Determine the charge on the capacitor and the current through the inductor den energy is shared equally between the electric and magnetic fields. Express your answer in terms of qm, L, and C.
Suppose a coil has a self-inductance of 20.0 H and a resistance of 200 . What (a) capacitance and (b) resistance must be connected in series with the coil to produce a circuit that has a resonant frequency of 100 Hz and a Q of 10?
What resistance R must be connected in series with a 200-mH inductor of the resulting RLC oscillating circuit is to decay to 50% of its initial value of charge in 50 cycles? To 0.10% of its initial value in 50 cycles?
Explain why at high frequencies a capacitor acts as an ac short, whereas an inductor acts as an open circuit.
Show that N m /l and el(dl/dt), which are both expressions for se1f-inductance, have the same units.
When the current in the RL circuit of Figure 14.12(b) reaches its final value /R, what is the voltage across the inductor? Across the resistor?
In an oscillating RLC circuit with L = 10 mH, C = 1.5 F , and R = 2.0 , how much time elapses before the amplitude of the oscillations drops to half its initial value?
An LC circuit in an AM tuner (in a car stereo) uses a coil with an inductance of 2.5 mH and a variable capacitor. If the natural frequency of the circuit is to be adjustable over the range 540 to 1600 kHz (the AM broadcast band), that range of capacitance is required?