An uncharged capacitor and a resistor are connected in series to a source of emf. If Ɛ = 11.0 V, C = 23.0 µF, andR = 100 N, find the following. (a) the time constant of the circuit ms (b) the maximum charge on the capacitor (c) the charge on the capacitor at a time equal to one time constant after the battery is connected µC

An uncharged capacitor and a resistor are connected in series to a source of emf. If Ɛ = 11.0 V, C = 23.0 µF, andR = 100 N, find the following. (a) the time constant of the circuit ms (b) the maximum charge on the capacitor (c) the charge on the capacitor at a time equal to one time constant after the battery is connected µC

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter28: Direct-current Circuits

Section: Chapter Questions

Problem 28.38P: Consider a series RC circuit as in Figure P28.38 for which R = 1.00 M, C = 5.00 F, and = 30.0 V....

See similar textbooks

Similar questions

An ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations involtage oversmall time intervals, (a) If the resistance of the circuit (duemostly to that of the patient's chest) is 1.00kTwhat is the maximum capacitance of the circuit?(b) Would It be difficult in practice to limit the capacitance to less than the value found in (a)?
The student engineer of a campus radio station wishes to verify the effectiveness of the lightning rod on the antenna mast (Fig. P21.71). The unknown resistance Rx is between points C and E. Point E is a true ground, but it is inaccessible for direct measurement because this stratum is several meters below the Earths surface. Two identical rods are driven into the ground at A and B, introducing an unknown resistance Ry. The procedure is as follows. Measure resistance R1 between points A and B, then connect A and B with a heavy conducting wire and measure resistance R2 between points A and C. (a) Derive an equation for Rx in terms of the observable resistances, R1 and R2. (b) A satisfactory ground resistance would be Rx 2.00 . Is the grounding of the station adequate if measurements give R1 = 13.0 and R2 = 6.00 ? Explain. Figure P21.71
The duration of a photographic flash is related to an RC time constant, which is 0.100F for a certain camera, (a) If the resistance of the flash lamp is 0.0400 duringdischarge, what is the size of the capacitor supplying its energy? (b) What is the time constant for charging the capacitor, if the charging resistance is 800 k ?
Consider a series RC circuit as in Figure P28.38 for which R = 1.00 M, C = 5.00 F, and = 30.0 V. Find (a) the time constant of the circuit and (b) the maximum charge on the capacitor after the switch is thrown closed. (c) Find the current in the resistor 10.0 s after the switch is closed.
Ralph has three resistors, R1, R2, and R3, connected in series. When connected to an ideal emf source E1, current I1 flows through the resistors. a. If the resistors are instead connected to a second source with E2=2E1, what is the new current through the resistors in terms of the first current? b. Show that, if each resistance is doubled and the resistors are connected in series to the second emf source, the current through the resistors is equal to I1.
A 160F capacitor charged to 450 V is dischargedthrough a 31.2k resistor, (a) Find the time constant.(b)Calculate the temperature increase of the resistor, given that its mass is 2.50 g and its specific heat is 1.67kJ/kg °C,noting that most of the thermal energy is retained in the short time of the discharge, (c) Calculate the new resistance, assuming it is pure carbon. (d) Does this change in resistance seem significant?
An uncharged capacitor and a resistor are connected in seriesto a source of emf. If ε = 9.00 V, C = 20.0 µF, and R = 1.00 x102 Ω, find (a) the time constant of the circuit, (b) the maximumcharge on the capacitor, and (c) the charge on thecapacitor after one time constant.
An uncharged capacitor and a resistor are connected in series to a source of emf. If ε = 9.00 V, C = 20.0 µF, and R = 100 Ω, find (a) the time constant of the circuit, (b) the maximum charge on the capacitor, and (c) the charge on the capacitor after one time constant.
A capacitor that is initially uncharged is connected in series with a resistor and an emf source with EEEMF = 110 VV and negligible internal resistance. Just after the circuit is completed, the current through the resistor is 6.6×10−5 AA. The time constant for the circuit is 4.3 s.What is the resistance of the resistor?
An uncharged capacitor and a resistor are connected in series to a source of emf. If = 10.00 V, C = 22.0 µF, and R = 100 Ω, find the following: (a) the time constant of the circuits(b) the maximum charge on the capacitorµC(c) the charge on the capacitor after one time constantµC
A capacitor that is initially uncharged is ocnnected in series with a resistor and an emf source with ℰ = 110 V and negligible internal resistance. Just after the circuit is completed, the current through the resistor is 6.5 × 10−5 A. The time constant for the circuit is 5.2 s. What are the resistance of the resistor and the capacitance of the capacitor?
In the circuit below, the capacitor starts out uncharged. The resistance is R = 118 Ω, capacitance is C = 0.0647 F, and the battery emf is 16.7 V. What is the charge (Q) on the capacitor at a time of t = 3.72 seconds after the switch is closed?