Analyze a series R.L.C. circuit, connected to anAC-voltage source of (AVmax=135 V), (R=200 2),(L=4 H), (C=2.1 µF), and (f=60 Hz). Calculateimpedance (z), phase angle ($) and find outwhether this circuit is capacitive, resistive orinductive?

Given data: AC voltage source is, V=135 V Resistance is, R= 200 Ω The inductance of the inductor is,…

Analyze a series R.L.C. circuit, connected to an AC-voltage source of (AVmax=135 V), (R=200 N), (L=4 H), (C=2.1 µF), and (f=60 Hz). Calculate impedance (z), phase angle ($) and find out whether this circuit is capacitive, resistive or inductive?

Analyze a series R.L.C. circuit, connected to an AC-voltage source of (AVmax=135 V), (R=200 N), (L=4 H), (C=2.1 µF), and (f=60 Hz). Calculate impedance (z), phase angle ($) and find out whether this circuit is capacitive, resistive or inductive?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 32P: A 40-mH inductor is connected to a 60-Hz AC source whose voltage amplitude is 50 V. If an AC...

See similar textbooks

Related questions

Q: An RLC series circuit has a 1.08 ka resistor, a 160 pH inductor, and an 18.0 nF capacitor. (a) Find…

Q: A 402 resistor and a 50mH inductor are connected in series across a Vrms f = 60HZ. Recall 120V AC…

Q: For what value of the phase angle ϕ between the voltage output of an ac source and the current is…

A: The average power output of the source is given as,

Q: A series ac circuit contains a 250 Ω resistor, a 15 mH inductor, a 3.5 uF capacitor, and an ac power…

A: The inductance, L=15 mH=15×10-3 H The resistance, R=250 Ω The capacitance, C=3.5 μF=3.5×10-6 F

Q: In an L-R-C series circuit, the resistance is 440 ohms, the inductance is 0.400 henrys, and the…

Q: Consider a series RLC circuit where the resistance R = 753 2, the capacitance C = 4.25 µF, and the…

Q: 23An RLC series circuit consists of a 240W resistor, 5.0mF capacitor, and 3.0mH inductor connected…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: An RLC circuit is shown below. The elements have the following values: resistor (R = 75.0 N),…

A: Part A: Find impedance of RLC circuit, which is given by: Z = sqrt (R^2 + (XL - Xc)^2) R = 75.0 ohm…

Q: An L-R-C series circuit is constructed using a 175 Ω resistor, a 12.5 μF capacitor, and an 8.00 mH…

A: Given Resistance, R= 175 ohmsCapacitor, C = 12.5 uF = 12.5*10^-6 FInductance, L = 8 mH = 0.008…

Q: A series RLC circuit with L=160mH, C=100F and R=40.0Ω is connected to a sinusoidal voltage…

A: Dear student, "Since you have posted a question with multiple sub-parts, we will solve first three…

Q: An RLC series circuit has a 2.50 Ω resistor, a 100 μH inductor, and an 80.0 μF capacitor. (a) Find…

A: Dear student, this question contains more than three sub-parts. We will answer first three…

Q: A 200-Ω resistor, 150-μF capacitor, and 2.5-H inductor are connected in series with an ac source of…

Q: In an L-R-C series circuit, the resistance is 320 ohms, the inductance is 0.400 henrys, and the…

Q: A series R-L-C circuit, excited by a 100 V, variable frequency source has a resistance of 10 2 and…

A: According to question--- Given that --- RLC series circuit excited by 100v Resistance = 10ohm…

Q: Analyzing an L-R-C Circuit. You have a 200 Ω resistor, a 0.400 H inductor, a 5.00 uF capacitor, and…

A: Given: The resistance is 200 ohms. The inductance is 0.400 H. The capacitance is 5.00 μF. The…

Q: A 12.5 mH inductor is connected in series to an AC power supply and a 250 Ohm resistor. The voltage…

Q: An RLC series circuit has a 2.7 Ω resistor, a 125 μH inductor, and a 85 μF capacitor. (a) If the…

A: Given data: The resistor in the circuit is R=2.7 Ω. The inductor in the circuit is L=125…

Q: You have a 209 −Ω resistor, a 0.390 −H inductor, a 4.98 −μF capacitor, and a variable-frequency ac…

Q: In an L-R-C series circuit, what are the phase angle f and power factor cos f when the resistance is…

A: For an ac circuit, the phase angle is given by tanϕ =XL - XcR Where, XL is the inductive…

Q: What is the capacitive reactance

A: Capacitive reactance is given as Xc = 1/wC Where w = 2π f ...f is frequency... C is capacitance of…

Q: 1. Given the following apparent power, what is the reactive power, in VAR? S = 4.2 VA θ = π/7…

Q: What is the resonant frequency of an RLC series circuit with R = 20 Ω , L = 2.0 mH , and C = 4.0 µF?…

Q: An ac generator with a frequency of 60.0 Hz and an rms voltage of 120.0 V is connected in series…

A: The phase angle in RLC circuits is given by ϕ =tan-1(XL-XCR) Where XL =2πfLXC =12πfC

Q: An RLC circuit is shown below. The elements have the following values: resistor (R = 85.0 0),…

Q: Assume that you have an RC AC Circuit with one resistor, R RC Circuit phasor diagram below. VR Vps Y…

A: In this question we have to use the law of cosines to determine the phase angle Gamma in degrees.…

Q: Consider the RLC series circuit shown in the figure below where R = 420 Ω, L = 75 mH, and C = 0.750…

Q: An alternating source with a variable frequency, a capacitor with capacitance C, and a resistor with…

Q: ompute the impedance Z of a series R-L-C circuit at angular frequencies ω = (a) 751 rad/s Assume R…

Q: An RLC series circuit shown below is driven by an AC source of voltage amplitude 200 volt and…

A: As there is not mentioned which part to answer hence i am answering the first three parts as per the…

Q: A sinusoidal voltage where Vmax = 100.0 V and a frequency of 60 Hz is applied to a series RLC…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: In a purely inductive AC circuit as shown in the figure, ΔVmax = 100 V. A square circuit is shown.…

A: Given : Voltage of the AC circuit, V=∆Vmaxsin 2πft peak voltage of the AC source, ∆Vmax=100 V…

Q: An RLC series circuit with R = 600 Ω, L = 30 mH,and C = 0.050µF is driven by an ac source…

Question

Analyze a series R.L.C. circuit, connected to an
AC-voltage source of (AVmax=135 V), (R=200 2),
(L=4 H), (C=2.1 µF), and (f=60 Hz). Calculate
impedance (z), phase angle ($) and find out
whether this circuit is capacitive, resistive or
inductive?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 6 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Calculate the rms currents for an ac source is given by v(t)=v0sint , where V0=100V and =200rad/s when connected across (a) a 20F capacitor, (b) a 20-mH inductor, and (c) a 50 resistor.
Check Your Understanding Show that the tins voltages across a resistor, a capacitor, and an inductor in an ac circuit where the tins current is Irmsare given by IrmsR,IrmsXC , and IrmsXL, respectively. Determine these values for the components of the RLC circuit of Equation 15.12. Pave=12t0v0cos (15.12)
Check Your Understanding In the circuit of Figure 15.11, L=2.0103H,C=5.0104F , and R=40 (a) What is the resonant frequency? (b) What Is the Impedance of the circuit at resonance? (c) If the voltage amplitude is 10 V, what is i(t) at resonance? (d) The frequency of the AC generator is now changed to 200 Hz. Calculate the phase difference between the current and the emf of the generator. The ac circuit shown in Figure 15.11, called an RLC series circuit, is a series combination of a resistor, capacitor, and inductor connected across an ac source. It produces an emf of Figure 15.11 (a) An RLC series circuit, (b) A comparison of the generator output voltage and the current the value of the phase difference depends on the values of R, C, and L.
An ac source of voltage amplitude 100 V and variable frequency f drives an RLC series circuit with R=10 , L = 2.0 mH, and C=25F (a) Plot the canal through the resistor as a function of the frequency f. (b) Use the plot to determine the resonant frequency of the circuit.
The two circuits shown below act as crude low-pass filters. The input voltage to the circuits is vin, and the output voltage is vout. (a) Show that for the capacitor circuit, voutvin=11+2R2C2 and for the inductor circuit, voutvin=RR2+2L2 (b) Slow that for low frequencies, voutvin , but for high frequencies, vout0 .
Calculate the reactance of a 5.0F capacitor at (a) 60 Hz, (b) 600 Hz, and (c) 6000 Hz.
At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?
Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
In an oscillating RLC circuit, R=5.0 ,. L=5.0mH , and C = 500 F . What is the angular frequency of the oscillations?
A 700-pF capacitor is connected across an ac source with a voltage amplitude of 160 V and a frequency of 20 kHz. (a) Determine the capacitive reactance of the capacitor and the amplitude of the output current of the source. (b) If the frequency is changed to 60 Hz while keeping the voltage amplitude at 160 V, what are the capacitive reactance and the current amplitude?
A 40-mH inductor is connected to a 60-Hz AC source whose voltage amplitude is 50 V. If an AC voltmeter is placed across the inductor, what does it read?
At 1000 Hz, the reactance of a 5.0-mH inductor is equal to the reactance of a particular capacitor. What is the capacitance of the capacitor?