Analyze the unsignalized intersection below and calculate the optimum cycle length if the intersection will be signalized. Approach E W N S Maximum no. of lanes 5 5 4 4 Direction Through left Through left Through left Through left N Total volume pcu/hr 1,480 370 860 586 1,360 494 2,030 265 Sat. flow rate pcu/hr/lane 2,400 1,700 2,400 1,700 2,200 1,800 2,200 1,800

Analyze the unsignalized intersection below and calculate the optimum cycle length if the intersection will be signalized. Approach E W N S Maximum no. of lanes 5 5 4 4 Direction Through left Through left Through left Through left N Total volume pcu/hr 1,480 370 860 586 1,360 494 2,030 265 Sat. flow rate pcu/hr/lane 2,400 1,700 2,400 1,700 2,200 1,800 2,200 1,800

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter9: Capacity And Level Of Service For Highway Segments

Section: Chapter Questions

Problem 16P

See similar textbooks

Similar questions

Determine the PTSF in each direction for a 4.5 mi (7.2 km) two-lane highway segmentin level terrain. Traffic volumes (two-way) are 1100 veh/h. Trucks: 10%; RVs: 7%; PHF:0.97; directional split: 60/40; no passing zones: 40%.
Downvote for wrong answers A section of a roadway has a horizontal curve with superelevation of 6% and central angle of 40°. The design speed of the section is 60 mph. There are two lanes on the curve, each 12 f wide. Determine: (a) The degree of the curve. (b) The length of the curve. (c) The minimum distance of an obstruction from the centerline of the innermost lane.
The through movement passenger car equivalents (pcphpl) for each approach of Vine and Maple Streetsintersections obtained from a traffic survey as shown in the following diagram. Vine Street for NSmovements 1s 48 ft wide and Maple Street for EW movements is 60 ft wide. There are two throughmovement lanes and one left-tum lane in each approach. The yellow times for Vine Street and MapleStreet through movement and left-tum phases are 4 second and 3 seconds per g_hase, respectively. TheAll-red for each phase is 2.0 seconds and the ost time is 5 seconds per phase. Pedestrian walkmgspeed is 3.5 ft/sec. Assuming equal distribution of traffic on the two through-movement lanes in eachapproach and a saturation flow rate of 1,900 pcphpl. A 3-phase fixed timing signal plan (namely, aprotected left-turn phase, a NS phase, and an EW phase) is suggested.I) In the diagram, the through movement volume is for 2 lanes and left tum volume is for one-lane.2) Determine one N-S or E-W left tum phase on the…
Subject : Transportation engineering Please give me right solution according to the question clearly.. Urgent please A 6% downgrade meets a 3% upgrade at elevation 100m at station 10+000. If the length of the parabolic curve is 160m long, find the stationing of the lowest point of the curve.
A signalized intersection approach has an upgrade of 4%. The total width of the cross street is 60 ft. The avg. vehicle length is 16 ft. Traffic operates at 40 mph. Find the min. change and clearance interval (CCL). if chart or graoh where use dplease include below and explain
A new section of Richmond Highway is being designed as a six-lane facility (three ineach direction) with a two-way left-turn lane. Determine the peak-hour LOS.Traffic data:• Directional design hourly volume = 3600 veh/h• PHF = 0.94• Assumed base free-flow speed = 55 mi/h (88 km/h)Geometric data:• Urban setting• Rolling terrain• Lane width = 11 ft (3.3 m)• Shoulder widths = 4 ft (1.2 m) (right side) and 1 ft (0.3 m) (left side)• Average access point spacing = 12 points per mile on each side
Read the question carefully and give me right solution according to the question. Station 10+00.00 has an elevation of 110.00 and a grade of -3%. Station 20+00.00 has an elevation of 105.00 and a grade of +2%. What is the stationing at the two grade intersections? options A) 14+00, B) 15+00, C) 16+00, D) 17+00)
NEED ASAP! THANK YOU A straight railroad AL intersects the curve highway route BC as shown in the figure. Distances on he route are measured along the arc using the data specified. (USING STATION C) -Compute angle COP -Compute the length of curve (Lcu) in meter, from point C to point P in meters. -Determine station C. -Find the stationing at the point of intersection “P” of the railroad and the highway curve
A horizontal curve with a radius of 800 ft connects the tangents of a two-lane Highway that has a posted speed limit of 35 mi/h. If the highway curve is not super elevated, e =0, determine the horizontal sightline offset (HSO) that a large billboard can be placed from the centerline of the inside lane of the curve, without reducing the required SSD. Perception-reaction time is 2.5 sec, and f = 0.35. when S<L and S>L.
Two parallel tangents are connected by a reversed curve having equal radii of 360m.______________ 1. If the central angle of the curve is 8° compute the distance between parallel tangents. ______________ 2. Compute the length of chord from the P.C to the P.T.______________ 3. If P.C is at Sta. 3+960.40, what is the stationing of the P.T.
Traffic volume is 2578 veh/hr with 687 vehicles arriving in peak 15 minutes.There are tow lanes, 12 percent trucks(30/70 split for SUT/TT), the length of the road is 1.8 miles long with a 3.5 percent grade. calculate the analysis flow rate?
A Highway curve will pass through a railway at grade. The crossing must be at Sta. 4+310 and at elevation 220.82 m. the initial grade is +2% and meets a -3% grade at Sta. 4+235 at elevation of 223.38 m. The rate of change must not exceed at 2%. Compute the length of curve, station and elevation of highest point also check if the condition of rate of change if meet. 3 decimal places. ASAAP 30 MINS THANK YOU