An LC circuit like the one in the figure below contains an 60.0 mH inductor and a 20.0 µF capacitor that initially carries a 185 µC charge. The switch is open for t < 0 and is then thrown closed at t = 0.   What are the first three times (in ms), after t = 0, when the capacitor is fully charged again?

Q: An LC circuit like the one in the figure below contains an 60.0 mH inductor and a 25.0 µF capacitor…

A:

Q: An LC circuit like the one in the figure below contains an 80.0-mH inductor and a 11.0-µF capacitor…

A:

Q: The battery terminal voltage in the figure below is E = 8.30 V and the current I reaches half its…

A: Given:-  The terminal voltage is ε= 8.30 V  The current reaches half of its maximum value of current…

Q: The figure below shows a circuit consisting of a 12.0 V battery in series with an inductor with…

A:

Q: 20) S R2 An inductor with inductance L = 0.5 H and negligible resistance is connected to a battery,…

A: You have posted 2 different questions. As per our policy, we are supposed to answer only one…

Q: An LC circuit like the one in the figure below contains an 70.0 mH inductor and a 12.0 uF capacitor…

A:

Q: A single-loop circuit consists of a 7.20 ohm resistor, a 12.0 H inductor, and a 3.20 mF capacitor.…

A: Write the expression for the charge on the capacitor in RLC circuit after time t.

Q: A 32.0 [] resistor, a 0.40 [H] inductor, and a 20.0 [F] capacitor are connected in series to form an…

A:

Q: The current I flowing rightward through inductor L is at a steady rate of 0.1280 A/s. The magnitude…

A: GivenThe steady rate of flow of current ,dIdt=0.1280  A/sεL=0.0160 V

Q: The angular frequency of the oscillations in an LC circuit is 2.0×103 rad/s. (a) If L=0.10H, what is…

A: (a)Given,L=0.1HThe angular frequency of oscillation in the LC Circuit is given by

Q: The figure below shows a circuit consisting of a 15.0 V battery in series with an inductor with…

A:

Q: The figure below shows a circuit consisting of a 18.0 V battery in series with an inductor with…

A:

Q: The battery terminal voltage in the figure below is E = 7.10 V and the current I reaches half its…

A: Current=8A Emf=7.10v

Q: The circuit below contains an inductor (L = 3 H) with an internal resistance R3 = 60 ohm. The other…

A: As soon as the switch is on, the current in inductor will be zero. i3=0 rest i1 and i2 will be in…

Q: An LR circuit is hooked up to a battery as shown in the figure, with the switch initially open. The…

A: For charging of an inductor i=VR(1-e-RtL)

Q: In the L-C circuit in the figure, the ammeter reads a maximum cur­rent of I = 5.19 mA. The…

A:

Q: The Figure Q3(b) shows an inductor having cylindrical ferromagnetic core.Calculate the value of…

A: N = 200 l = 0.075 m d = 0.005 m To find = Inductance of the coil

Q: A 6.0 μF capacitor, a 0.12 H inductor, and an 85Ω resistor are connected in series across a 10V, 300…

A: Write the given values with the suitable variables. C=6 μF=6×10-6 FL=0.12 HR=85 ΩV=10 Vf=300 Hz…

Q: A resistor R and an ideal inductor L are connected in series to an ideal battery having a constant…

A:

Q: What is the energy stored in the inductor shown in the figure after the switch has been closed for a…

A:

Q: A 7.2-mH inductor is connected to a current. What is the magnitude of the voltage in the inductor at…

A: The inductance of the inductor, L =7.2 mH Current through the inductance circuit, I(t) = 5+7t-2t2…

Q: A 1.65 H inductor in an RL circuit (with resistance 1.8 Ω) is initially carrying a current of 4.95…

A: Given that:- Inductance of inductor=L=1.65H

Q: The switch in the figure below is connected to position a for a long time interval. At t = 0, the…

A: "As per the guidelines i solved the first three subpart". (a) The frequency of oscillation of LC…

Q: At t=infinity, what is the current flowing through an inductor? What is the voltage across the…

A:

Q: A 6.0 V battery has been connected to an LR circuit for sufficient time so that a steady current…

A: Given,

Q: ») What is the characteristic time constant (in s) of a 25.5 mH inductor that has a resistance of…

A:

Q: 14.0-mH inductor is connected to a North American electrical outlet (ΔVrms = 120 V, f = 60.0 Hz).…

A:

Q: An RL circuits is made of a 9.5V battery, a switch, a 0.48H inductor, and a 534 resistor. What is…

A:

Q: In a series RL circuit, the resistance is 135 ohms, the inductance is 120 x 10-3 H, and the source…

A:

Q: A powdered iron (Bsat = 1 T) toroid core has µ = 25µ0 (µ0 = 4π × 10-7 H/m). The outside diameter is…

A: The inductance of the toroid be defined as, Where, r be defined as the toroid radius to centreline…

Q: A 15.0 uF capacitor is charged by a 150.0 V power supply, then disconnected from the power and…

A: (a) The oscillation frequency of the circuit is given by, f=12πLC Here, L is the inductance of the…

Q: An LC circuit like the one in the figure below contains an 60.0 mH inductor and a 25.0 µF capacitor…

A:

Q: A single-loop circuit consists of a 7.2 Q resistor, 11.9 H inductor, and a 3.3 UF capacitor.…

A:

Q: A 6.0 V battery has been connected to an LR circuit for sufficient time so that a steady current…

A: Given, V=6V, L=18mH, R=2.2KΩ

Q: An inductor and a resistor are connected in series to a battery as shown in the figure below, where…

A:

Q: A 14.0-mH inductor is connected to a North American electrical outlet (ΔVrms = 120 V, f = 60.0 Hz).…

A:

Q: 6. a. Draw an RLC circuit with a 0.3 n resistor, 0.1 H inductor, and 5 F capacitor connected in…

A: (a)

Q: The current I(t) through a 5.0-mH inductor varies with time, as shown below. The resistance of the…

A:

Q: An RL circuit consists of a switch, an emf source E, a 3.0 ka resistor, and a 1.0 H inductor. If the…

A:

Q: An LC circuit like the one in the figure below contains an 70.0 mH inductor and a 12.0 uF capacitor…

A: Given data The magnitude of the inductance of an inductor is L = 70 mH = 70 x 10-3 H The capacitance…

Q: Initially two capacitors each of capacitors C have charges as shown and the inductor L has zero…

A:

Q: A 0.180-H inductor is connected in series with a 90.0-Ω resistor and an ac source. The voltage…

A: Solution: Given that The inductance of the coil L =0.18 H Resistance R = 90.0-Ω

Q: A circuit consists of 18 volts battery, a 72 mH inductor and two 50 ohms resistors connected in…

A:

Q: A 20.0-mH inductor is connected to a North American electrical outlet (ΔVrms =  120 V, f = 60.0 Hz).…

A: Given:inductance, L = 20.0×10−3 H= 0.02 Hrms voltage, Vrms = 120 Vtherefore peak voltage, Vo =…

Q: The switch In the figure below is connected to position a for a long time interval. At t = 0, the…

A: Given data: Capacitance C=1.50μF Resistance R=10.0Ω Inductance L = 0.100 H Voltage V = 12.0 V

Q: A 14.0-mH inductor is connected to a North American electrical outlet (ΔVrms = 120 V, f = 60.0 Hz).…

A:

Q: The 4.00 A current through a 1.30 H inductor is dissipated by a 2.00 Ω resistor in a circuit like…

A: Since there are multiple sub parts posted, we will answer the first three sub parts. a) The equation…

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.