answer with solutionFind the transfer functiond C(t)2-d²C (t)dt²+2-dtC(s)R(s)- +C(t) = r(t) +2r(t − 1)of a system having differential equation

Given here a differential equation and asked to find the transfer function.we know that L c t = C…

Answered: answer with solution C(s) Find the…

answer with solution C(s) Find the transfer function R(s) d²C d 2#*C(Đ) +2&°C(Đ) dt² ¹+2+C(t)=r(t) of a system having differential equation +2r(t− 1)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A servomotor for position control of a rotatable mass is stabilized by viscous friction damping…

A: Given f= 12 Hz ωn =2πf =2π×12=75.4 rad/sec To determine i) expression for output of the system ii)…

Q: 3. The vector current density is given as J = (4/r²) cose ar + 20e-2r sine ae - rsinecos ao at r =…

A: Given: Vector current density is given as:J→=4r2cosθar+20e-2rsinθaθ-rsinθcos∅a∅ Required:J→ at…

Q: Q2: Determine the particular solution of the difference equation y(n) = zy(n-1) - by(n - 2) + x(n)…

Q: For the system shown below, design a lead compensator Ge(s) such that wn=4 rad/sec. and 3=0.5 for…

A: Given data : Gc(s)H(s)=4s(s+2) Natural frequency ωn=4rad/sec Damping ratio ξ=0.5

Q: Q2 If the unit step response of a network is (1 - e-at), then Find its unit impulse response

A: Given here a unit step response and asked to find the impulse response.

Q: Q1) for the signal that is shown in the figure below A) plot the amplitude spectrum X(t) 3 0.5 B)…

A: Given: Consider the signal shown in the figure below: To find: (a) Plot the amplitude spectrum. (b)…

Q: 2. The unit impulse response of a system is given by T(t)= e-(1-cos2t). Determine its transfer…

Q: ww R1 V 2 sine sine In the above circuit, let R1 = 8 ohm, reactance of L1 be j12 ohm. RMS value of…

Q: Q1) For the emitter-bias configuration of Fig. below, determine: Rc, RB and RE if Icq= (1/2)Isat =…

Q: Let C₁ = 8 µF, C₂ = 16 µF, C3=24 µF, and V = 6 V. Find the equivalent capacitance and the charge and…

A: Given : values of three capacitors and voltage source, V = 6 v To find the equivalent capacitance…

Q: I need the answer as soon as possible

Q: a) The maximum input low voltage for 74LS00. 4 b) The typical output high voltage for 74LS00. c) The…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Find the equivalent capacitance

Q: Two wire transmission line whose cross section is illustrated below. Each wire is having a diameter…

A: Given data, Each wire diameter is 2 m, The distance between the conductor is 8 m, The value of the…

Q: A unit feedback system has open-loop transfer function: 25 G(s) = s(s+6) The peak overshoot in the…

A: Given: A unity feedback system has open loop transfer function, Gs=25ss+6 Hs=1

Q: 4. By using trigonometric functions, find the resultant horizontal and vertical components,…

A: Given:

Q: In rl circuit the voltage across the inductor is v(t) = 2e^(-4t) v nd the current is passing through…

Q: 1.a. Which one of the following pitches is the minimum recommended pitch for a 24-pole motor with…

A: 1 (a) Coil span = pole pitch for full pitch⇒ slotpole= 36024 = 15As all others are less than 15…

Q: 4- An induction Motor is a) Self-starting with high torque c) Self-starting with low torque 5- In…

A: (4) Starting of induction motor: Because each phase's winding displacement is 120 degrees, and the…

Q: 43 Like a resonant RLC circuit, a parallel resonant circuit also Ohas a power factor of unity O…

A: A parallel resonance is similar to the series resonance circuit but the only difference is the…

Q: Write the expression for the output voltage of a balanced modulator

A: A balanced modulator circuit is an electronic circuit which is used to produce double sideband…

Q: Two identical wave generators in a ripple tank produce an interference pattern using a wavelength of…

A: Given data, Wavelength (λ)=2.58cm n=1

Q: 1. Refer to Fig. 1.1. Derive voltage gain A, v /v, in terms of R1, R2 and b. 602 RI bi, R2 7V 802…

Q: 4. Design and draw a self-commutation (with capacitor initially charged) circuit, where the time to…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Given an LTI system with the transfer function H(jΩ)= e-jΩ (2+2cosΩ), the input signal…

Q: 9. A 6-bit DAC has an input of 1001012 and uses a 10.0 V reference. i. Find the output voltage…

A: Given, DAC has Number of bits (N) = 6 Input digital data => 1001012 Reference voltage (Vref) =…

Q: b. Choose the suitable choice for nine of the following sentences. 1. In order to tune a parallel…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Compute the rms value of the voltage waveform shown in Fig. v(t) (V) 4 ил. 2 4 6 8 t(s)

A: By using the concept of signal and systems we need to calculate the value of RMS voltage of the…

Q: The unit-step response of a unity feedback system with open loop transfer function is shown in the…

A: Given a unity feedback open-loop transfer function, Gs=Ks+1s+2 Hs=1 Unit response, Rs=1s Curve:

Q: Two 70 kW single-phase transformers are connected in parallel. The impedances of the first and…

A: The Given Two 70kW 1ϕ Transformer are connected in parallel. The 1st and 2nd transformer are 0.6+j6Ω…

Q: Determine the poles and zeros of the system whose transfer function is given by G(s)=- 2s +1 s²+35+2…

A: Given: The transfer function of the system is Gs=2s+1s2+3s+2

Q: If the appropriate value of the current is not known, measurement should start on the lowest range…

A: Current is the flow of electrical charge carrier and the electron and electron deficient atom we…

Q: 21 The power factor of an AC circuit is given by O Cosine of the phase angle O tangent of the phase…

A: Real power is the active power is the power drawn by the resistance of the circuit and it is…

Q: 23 The phase angle of an RLC circuit is leading if XL = 0 OR=0 O XC > XL O XC < XL

Q: A dc motor operates with a load that demands constant developed torque. With VT = 200V, the motor…

A: A DC motor is a machine which takes DC electrical energy as an input and produces mechanical output…

Q: Define Electrical engineering

A: Electrical engineering: This branch of engineering deals with the technology of electricity.…

Q: - Define the Zeroth law of Thermodynamic? -What is Energy? And Energy forms?

Q: The optical power launched into optical fiber is 1.5uW. The fiber has attenuation of 0.5dB/km. if…

A: It is given that:Mean optical power launched into an optical fiber link=1.5×10-3wMinimum mean…

Q: What is the ac current flowing in the circuit shown below? 12 v 1.5kHz 0.1 µF

Q: Find (vab)

Q: 15 There will sometimes, natural, XL = XC always, natural, R = 0 always, resonant, XL =XC sometimes,…

Q: 2. Calculate the following: a. V₁, V₂, and V3 b. VAG, VBG, and VCG V₁=100v +-+ RT= 100 ohms R2= 180…

A: Given Voltage Division ....

Q: ми Tos 3A 3252 3652 20v find the Nortons equivalent circuit for the network to the resis for R of…

A: Given figure,

Q: A-Prove that the efficiency of class-B power amplifier is n = VL(P)*78.53%. Vcc

Q: -V W To/2 7. T. find C₁, X(+) :- scetch the amplitude and phase Spectrums

Q: Consider an LTI system with frequency response H(e^jw). The input to this system is x[n]= ∑n=-∞ to…

A: Given that input to LTI system xn=∑k=-∞∞δn-3k Output is yn=cos2π3n+π6 We know that…

Q: Determine R and Vz Given: ILMAX=200 micro ampere ILMIN=0 ampere V₁=12V V-16V R VL=12V

A: The Zener diode is used as a voltage regulator in the above circuit, where it cut-offs the supply to…

Q: 2. A UK-based digital terrestrial television using DVB-Digital Video Broadcasting uses 16 QAM has a…

A: For the above given question we need to calculate the value of symbol rate.

Q: II. Refer to Figure 2. 1. State if the circuit below in Figure 2 is a high pass or low pass filter,…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: Find the type of the feedback in the given circuit. Vcc TYC Vo Cc -IH Vs (A) Voltage- series (B)…

A: For the above given electrical circuit we need to find type of the feedback circuit.

Question

answer with solution
Find the transfer function
d C(t)
2-
d²C (t)
dt²
+2-
dt
C(s)
R(s)
- +C(t) = r(t) +2r(t − 1)
of a system having differential equation

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The following circuit is discussed. Your circuit, V,(S). V,(s) a) In the S-region, subtract the transfer function (H(s)= Vo(S)/Vs(S)). The initial values of all circuit elements are zero. b) For Vs(t)=u(t), find Vo(t) using the transfer function and inverse Laplace transform.
Know how to analyze a circuit in the s domain and be ableto transform an s-domain solution to the time domain Express i2 as a function of di1/dt when i2 is at its peak value.
A discrete time signal is given by: x(n) = [2, 2, 2, 2, 3] Sketch the following signals : x(n) u(n-1)
The transfer function of a control system is given in the picture. Find the steady-state response and error when the unit-step test signal r(t)=u(t) is applied to this system.
1) In the electrical circuit given in the figure, v (t) -input and vC2 (t) -output, a) Draw the Laplace equivalent of the system and obtain the transfer function. (In your transactions, consider the initial values as zero.). b) Draw the appropriate graph tree and write the equation of state for the system.
Problem 5. Which gives the Laplace transforms of the given time-domain function? ln [(s + sqrt 2)/(s - sqrt 5)] ln [(s - sqrt 2)/(s + sqrt 5)] ln [(s - 2)/(s + 5)] ln [(s - sqrt 2)(s + sqrt 5)]
For the following circuit, find the transfer function (H(S)= I(s)/Vin(s) , at responses i(t) to zero input and zero state, the total response i(t), responses to transient and steady state, the natural frequencies and the circuit time. Assume Vin = 24 u(t) V and that the capacitor is initially loaded with 10 V. Use only the resolution via Laplace transform. Any other methods used will not be considered.
Root Locus Question Utilizing root locus techniques (by hand) prove that for the transfer function K*G(s) where G(s) = 1/(s^2+s+10) there is no value for K that will allow for less than 16% overshoot. Sketch the region of allowance on the root locus which would give less than 16% overshoot as added proof to the statement 5
Use the convolution integral to find the function h=(f*g) where f=t*u(t) and g=t^n*u(t) where n is a constant.
Which system with the following transfer functions does not have an overshoot in its response to step inputs?( need only handwritten solution .otherwise downvote.)
A 6 H inductor and a 30Ω resistor are connected in series with avoltage source of 10??? 20?. Use Laplace transforms as a function of time ifthe initial current is zero.. What is the current when ? = 2 ?
The transfer function for a linear time-invariant circuit is H(s)=VoVg=4(s+3)s2+8s+41. If vg=40 cos 3t V, what is the steady-state expression for vo?