Apply the moment principle about point B of the 300-N force.

Q: With an example, discuss the differences between CAM and CIM

A: introduction; CAM is computer aided manufacturing. it is used for effective manufacturing planning…

Q: Carbon dioxide gas is compressed at steady state from a pressure of 18 lb/in² and a temperature of…

A: Introduction In this problem, we will calculate the compressor's inlet flow area using the mass…

Q: A 14-ft3 tank contains oxygen initially at 14.7 psia and 80°F. A paddle wheel within the tank is…

A:

Q: Draw the Shear and Moment Diagram and find the maximum shear and maximum moment for the given beam…

A:

Q: Given Specific Weight of fluid is 7.85 N/L and its mass is 650 g. Calculate : Diberi berat tentu…

A: Given data: specific weight  of fluid is 7.85 N/Lmass is 650 g

Q: Why does the brittle material fails in helicoidal shape and ductile material shears on right section…

A: introduction; brittle material fail in tension. and ductile material fail in shear because ductile…

Q: rigid rod is constrained between points A and B, as shown. A Spring CD has stiffness 1.5 N/mm and n…

A:

Q: A piston-cylinder device contains 0.13 kg of air initially at 2 MPa and 350°C. The air is first…

A: Introduction In this problem, we will calculate the work done by the piston cylinder device or work…

Q: Problem 2 For the system of forces shown to the right, complete the following: a) Represent force F1…

A: Ddd

Q: oblem 1. apter 10 Pouring Calculations mold sprue is 25 cm long, and the cross-sectional area at its…

A:

Q: Learning Goal: To demonstrate the consistency of the principle of moments by calculating a moment…

A:

Q: Explain Following in detail. Please give Handwritten answer 1.Vector Managed Inventory 2.ABC…

A:

Q: Construct two position synthesis of single slider crank mechanism by relative pole method.

A: introduction; relative pole method- relative pole is the center of its rotation with respect to…

Q: Steam enters a turbine stage with an internal energy of 3,072 kJ/kg at 69 m/s and leaves the same…

A:

Q: Calculate the forces in members AB, BH, and BG. Members BF and CG are cables which can support…

A:

Q: A fluid in an aquifer is 6.5 m above reference datum, and the fluid pressure is 1800 N/m2• If the…

A:

Q: The Resultant Force and The angle of the Resultant Force with respect to vertical axis

A:

Q: At the center of a narrow, uniformly charged ring with radius R is a non-polar molecule. What is the…

A:

Q: 4. An ideal dual combustion cycle has a compression ratio of 10. At the beginning of compression,…

A:

Q: Determine the force in each member of the loaded truss. The force is positive if in tension,…

A: Given data as per the question Weight =260 kg

Q: 90 mm un 00 N B X Z BI 600 mm P A 500 mm 360 mm y Fig. P2.34 Fig. P2.35, P2.36 2.35 The magnitude of…

A: Given data  Force (P) = 100 N. Find the moment about point O and point C.

Q: The gauge pressure of the air in the tank shown in the figure is measured to be 56 kPa.  Determine…

A: Given:Gauge pressure of the air in the tank, Pg=56 kPaSpecific gravity of liquid, sl=0.9Specific…

Q: Figure P4.15 provides steady-state data for air flowing through a rectangular duct. Assuming ideal…

A:

Q: Calculate the time in hours that it will take to reach thefatal concentration of 40% methane in a…

A:

Q: A block placed under the head of the claw hammer as shown greatly facilitates the extraction of the…

A:

Q: 4. An iron ball of mass equal to 7.00 kg hits perpendicularly a massive wall and bounces off with a…

A: Given data mass of iron ball (m) = 7.00 kg  Velocity after collision (v) = 2 m/s Impulse exerted by…

Q: Your department is going to start working with two new therapy radiopharmaceuticals, one that is a…

A: The shielding material to be used against the pure alpha emitter is thin piece of paper because thin…

Q: 8 0 P

A: Give ,

Q: Cm 0.5 0.4 0.3 0.2 0.1 0 -0.1 -0.2 -0.3 -0.4 -0.5 FIGURE P2.4 2 (a) Estimate the stick fixed neutral…

A:

Q: he working fluid is water. There is no heat transfer to or from the water, and the f the water per…

A: Part A:-  Energy Balance Equation is as follows, dmu + gz + V22system = u + gz +V22 indmin-u + gz +…

Q: Z is incorrect

A:

Q: A diffusion couple of two metals, A and B, was fashioned as shown: Diffusion of A atoms K A-B alloy…

A:

Q: Q2/ In simple refrigeration system uses R134a, the evaporator pressure is 0.25 MPa and the condenser…

A: Given data as per the question Evaporator pressure =0.25 Mpa Condenser pressure =1 Mpa Evaporator…

Q: As shown in the figure, Refrigerant 22 enters the compressor of an air conditioning unit operating…

A:

Q: Learning Goal: To apply the scalar formulation of the moment of force including the determination of…

A:

Q: Based on the attached figure: (a) Determine the force acting on the hydraulic cylinder BC. F(BC) = ?…

A:

Q: A particle undergoing motion along the z-axis means eliminating all terms involving i and j. O True…

A: It is true that a particle undergoing motion along the z-axis means eliminating all terms involving…

Q: A pulley 250 mm in diameter is belt-driven by a pulley 150 mm in diameter. If the 10-in.- diameter…

A:

Q: A step aeration plant is working under the following conditions: Influent sewage flow = 20,000 m³/d…

A:

Q: cept of vibration isolation. When d

A: Vibration:- A mechanical oscillation can be used to explain vibration. The oscillation could be…

Q: To heat​ potatoes, you use a microwave with an output power of 780 watts​ [W]. The microwave has​…

A: To determine the time it will take to heat a potato to a  temperature, we use the following…

Q: K Kt m₂ mi C 22 ZI 9

A: Given,

Q: Platinum (Pt) has the FCC crystal structure, an atomic radius of 0.1387 nm, and an atomic weight of…

A:

Q: A C-130 pilot desires to fly a low-level navigation mission at 4 n miles/ min (240 kn ground speed).…

A: Given Data The ground speed is: Gs=240 kn The wind speed is: Ws=20 kn Altitude is: h=10,000 ft The…

Q: Eigure P3.36 Three-phase AC system. 3-37. In a motion capture study of a runner, one frame shows the…

A: From the data given in the question, we have the following diagram with marked angles These angles…

Q: The 100-kg spool is resting on the inclined surface for which the coefficient of kinetic friction is…

A: Write the given data. μk=0.13kG=0.22 mm=100 kgt=7 s

Q: A 14-ft tank contains oxygen initially at 14.7 psia and 80°F. A paddle wheel within the tank is…

A: Given data as per the question The volume of tank= 14 ft3 =0.396436 m3 Initial pressure =14.7 psia…

Q: FIND THE CUBIC SPLINE G(x) for the given data k0 and kn as given 12. fo=f(0) = 1, ₁ = f(2)=9,…

A:

Q: The 400-kg uniform I-beam supports the load shown. Determine the reactions at the supports.

A:

Q: The annular venturi meter is useful for metering flows in pipe systems for which upstream calming…

A: GivenAir at standard conditons flowstemperature 25oC and Pressure 101 kPaD=10cm=0.1mdD=0.8P1-P2ρg=5…