ard The two coils in the figure below lie on a horizontal axis through their centers. When the current in the coil on the left is increased at a rate of 0.8 A/s using a power supply, an emf of 185 mV is induced in the coil the right. Determine the mutual inductance of the two coils. M = Submit Question H B

ard The two coils in the figure below lie on a horizontal axis through their centers. When the current in the coil on the left is increased at a rate of 0.8 A/s using a power supply, an emf of 185 mV is induced in the coil the right. Determine the mutual inductance of the two coils. M = Submit Question H B

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 3PE: Referring to Figure 23.5?(a), what is the direction of the current induced in coil 2: (a) If the...

See similar textbooks

Similar questions

Integrated Concepts Referring to the situation in the previous problem: (a) What current is induced in the ring if its resistance is 0.0100 ? (b) What average power is dissipated? (c) What magnetic field is induced at the center of the ring? (d) What is the direction of the induced magnetic field relative to the MRI'S field?
Eddy current are induced currents set up in a piece of metal when it moves through a nonuniform magnetic field. For example, consider the flat metal plate swinging at the end of a bar as a pendulum, as shown in Figure CQ20.9. (a) At position 1, the pendulum is moving from a region where there is no magnetic field into a region where the field B is directed into the paper. Show that at position 1 the direction of the eddy current is counterclockwise. (b) At position 2, the pendulum is moving out of the field into a region of zero field. Show that the direction of the eddy current is clockwise in this case. (c) Use right-hand rule number 2 to show that these eddy currents lead to a magnetic force on the plate directed at shown in the figure. Because the induced eddy current always produces a retarding force when the plate enters or leaves the field, the swinging plate quickly comes to rest. Figure CQ20.9
What is the value of the magnetic flux through the coil in Figure 23.56 (b) due to the wire?
Inductive charging is used to wirelessly charge electronic devices ranging front toothbrushes to cell phones. Suppose the base unit of an inductive charger produces a 1.00 103-T magnetic Held. Varying this magnetic Held magnitude changes the flux through a 15.0-turn circular loop in the device, creating an emf that charges its battery. Suppose the loop area is 3.00 104 m2 and the induced emf has an average magnitude of 5.00 V. Calculate the time required for the magnetic field to decrease to zero from its maximum value.
Referring to Figure 23.57(b), what is the direction of the current induced in the coil: (a) If the current in the wire increases? (b) If the current in fine wire decreases? (c) If the current in the wire suddenly changes direction? Explicitly show how you follow the steps in the Problem-Solving Strategy for Lenz’s Law.
Why must pan of the circuit be moving relative to other parts, to have usable motional emf? Consider, for example, that the rails in Figure 23.11 are stationary relative to the magnetic field, while the rod moves.
A loop of wire is moving near a long, straight wire carrying a constant current I as shown in Figure CQ31.10. (a) Determine the direction of the induced current in the loop as it moves away from the wire. (b) What would be the direction of the induced current in the loop if it were moving toward the wire?
A coil is moved through a magnetic field as shown below. The field is uniform inside the rectangle and zero outside. What is the direction of the induced current and what is the direction of the magnetic force on the coil at each position shown?
Two coils are placed near each other as shown in Figure OQ31.9. The coil on the left is connected to a battery and a switch, and the coil on the right is connected to a resistor. What is the direction of the cur- rent in the resistor (i) at an instant immediately after the switch is thrown closed, (ii) after the switch has been closed for several seconds, and (iii) at an instant after the switch has then been thrown open? Choose each answer from the possibilities (a) left, (b) right, or (c) the current is zero.
Integrated Concepts This problem refers to the bicycle generator considered in the previous problem. It is driven by a 1.60 cm diameter wheel that rolls on the outside rim of the bicycle tire. (a) What is the velocity 0f the bicycle if the generator’s angular velocity is 1875 rad/s? (b) What is the maximum emf of the generator when the bicycle moves at 10.0 m/s, noting that it was 18.0 V under the original conditions? (c) If the sophisticated generator can vary its own magnetic field, what field strength will it need at 5.00 m/s to produce a 9.00 V maximum emf?
Transcranial magnetic stimulation (TMS) is a noninvasive technique used to stimulate tedious of the human brain (Figure P31.3). In TMS, a small coil is placed on the scalp and a brief burst of current in the coil produces a rapidly changing magnetic field inside the brain. The induced emf can stimulate neuronal activity. (a) One such device generates an upward magnetic Held within the brain that rises from zero to 1.50 T in 120 ms. Determine the induced emf around a horizontal circle of tissue of radius 1.60 mm. (b) What If? The field next changes to 0.500 T downward in 80.0 ms. How does the emf induced in this process compare with that in part (a)? Figure P31.3 Problems 3 and 51. The magnetic coil of a Neurostar TMS apparatus is held near the head of a patient.
A patient with a pacemaker is mistakenly being scanned for an MRI image. A 10. 0-cm-long section of pacemaker wire moves at a speed of 10.0 cm/s perpendicular to the MRI unit’s magnetic field and a 20.0-mV Hall voltage is induced. What is the magnetic field strength?