Question
Asked Nov 1, 2019
13 views

Article 300

The is defined as the area between the top of direct-burial and the finished grade.

a. Notch.  b. Cover 

c. Gap.      d. None of these

check_circle

Expert Answer

Step 1

Direct burial cable is a kind of cable which is designed to be buried under the ground without the extra covering or protection.

Finished grade is the levelled ground or the surface below which the cable is laid down.

Step 2

As mentioned in the article 300. The cover is measured from the top of the cable or raceway to the finished grade. Hence the area between the top of the direct burial ...

help_outline

Image Transcriptionclose

FINISHED GRADE COVER DIRECT-BURIAL CABLE

fullscreen

Want to see the full answer?

See Solution

Check out a sample Q&A here.

Want to see this answer and more?

Solutions are written by subject experts who are available 24/7. Questions are typically answered within 1 hour.*

See Solution
*Response times may vary by subject and question.
Tagged in

Engineering

Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by student like you
Show more Q&A
add
question_answer

Q: CompressionLet’s take a look at compression.Take the file Fig 05-15 which can be found on the author...

A: 1. Right click on file and go to properties to get  the type of file format.Answer: a) Chapter 5.doc...

question_answer

Q: When applying the general provisions for receptacle spacing to the rooms of a dwelling unit, which r...

A: Article NEC 210.52(A)(1) states that the receptacles shall be installed such that no point measured ...

question_answer

Q: At room temperature, what will be the value of thermal voltage? Show detailed calculations.

A: Write the expression thermal voltage as follows:

question_answer

Q: perform addition  -18+j23  and 30-j15              subtraction (8-j4)-3<25             multiplica...

A: There are two ways to represent complex numbers-(1) Polar form(2) Rectangular form(1) Polar form: It...

question_answer

Q: For the circuit below: (a) Determine the Thevenin equivalent. (b) Find the maximum power that can be...

A: (a) According to the Thevenin’s theorem any linear complex circuit can be simplified in the form of ...

question_answer

Q: For this circuit (attached), find the voltages at points A, B, C, D, and E. You may assume all the t...

A: Given data:Redraw the given circuit as shown in Figure 1.

question_answer

Q: 93uF 7 L 301 3302 5 Pa ssband ain190 vj İVJ I got the exact ftsl98.0549Hz- vil is the Voltage gan Va...

A: Write the expression to find exact value of lower cutoff frequency for the given circuit as follows:

question_answer

Q: Problem 3 Using source trans formations, find (a) the voltage at A; (b) the magnitude and direction ...

A: Click to see the answer

question_answer

Q: When you are converting an instantaneous current to a phasor, how does the phase angle being positiv...

A: The overall solution depends on the phase angle or epoch (initial phase) of the instantaneous form o...