As a researcher, you are trying to obtain some 2D materials using exfoliation. You put some adhesive tape onto a piece of graphite that is 2 cm by 3 cm. You pulled the tip of the tape at an angle of 35° from the horizontal direction, and the tip of a thin graphene sheet of about 0.001 mm started to be separated from the bulk. How much force did you apply on the tape? The exfoliation strength of graphene is 21.9 × 106 N/m² Таре Таре Таре Side view (magnified) Top view

As a researcher, you are trying to obtain some 2D materials using exfoliation. You put some adhesive tape onto a piece of graphite that is 2 cm by 3 cm. You pulled the tip of the tape at an angle of 35° from the horizontal direction, and the tip of a thin graphene sheet of about 0.001 mm started to be separated from the bulk. How much force did you apply on the tape? The exfoliation strength of graphene is 21.9 × 106 N/m² Таре Таре Таре Side view (magnified) Top view

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter9: Fluids And Solids

Section: Chapter Questions

Problem 54P

See similar textbooks

Similar questions

Maria is filling a bucket of water from a faucet. After she turns it on, she sees that the cross-sectional area of the water stream right below the faucet is about the size of a quarter, or 4.62 × 10^−4 m2 . The stream constricts to about the size of a dime, or 2.52 × 10^−4 m2 , after falling 2.50 cm. If the bucket Maria is filling has a volume of 10.0 L, how long will it take to fill the bucket?
A shearing force of 75 N is applied to an aluminum rod with a length of 10 m, a cross-sectional area of 1.0 x 10-5 m2, and a shear modulus of 25 x 109 N/m2. As a result the rod is sheared through a distance in mm of:
Mr. Tanner’s construction class is studying the construction of roof trusses He taught them that the trusses must form two right triangles. Which of the following designs could be used as a roof truss?
Mercury makes an angle of 130 degrees when in contact with clean glass. What distance will mercury depress in a vertical 2 cm diameter glass? Use surface tension = 0.47 N/m. -0.543 mm b.-0.354 mm c.-0.453 mm d.0.500 mm
A steel cable 3.00 cm2 in cross-sectional area has a mass of 2.40 kg per meter of length. If 500 m of the cable is hung over a vertical cliff, how much does the cable stretch under its own weight? Take Ysteel = 2.00 × 1011 N/m2.
12-19. please provide a clear and complete solution, thank you!
A tunnel of length L = 130 m, height H = 9.4 m, and width 5.6 m (with a flat roof) is to be constructed at distance d = 68 m beneath the ground. (See the figure.) The tunnel roof is to be supported entirely by square steel columns, each with a cross-sectional area of 906 cm2. The mass of 1.0 cm3 of the ground material is 2.3 g. (a) What is the total weight of the ground material the columns must support? (b) How many columns are needed to keep the compressive stress on each column at one-half its ultimate strength?
If you are grilling hamburgers and getting impatient, why is it a good idea to flatten the burgers to make them wider and thinner?
A container whose height is “h” has a constant cross-sectional area. Half of the container is filled with water and the other half is filled with liquid whose specific gravity is 0.80. Find the ratio of the force exerted by water acting on the lower half to that of oil acting on the other half?A.3.35B.2.25C.3.25D.4.15
Grains of fine California beach sand are approximately spheres with an average radius of 50.0 μm and are made of silicon dioxide, which has a density of 2.80 × 103 kg/m3. What mass of sand grains would have a total surface area (the total area of all the individual spheres) equal to the surface area of a cube 1.10 m on an edge?
A 9.00 m × 15.0 m swimming pool slopes linearly from a 1.20 m depth at one end to a 3.70 m depth at the other. What is the mass of water in the pool?
Collectible coins are sometimes plated with gold to enhance their beauty and value. Consider a commemorative quarter-dollar advertised for sale at 4.98. It has a diameter of 24.1 mm and a thickness of 1.78 mm. and it is completely covered with a layer of pure gold 0.180 m thick. The volume of the plating is equal to the thickness of the layer multiplied by the area to which it is applied. The patterns on the faces of the coin and the grooves on its edge have a negligible effect on its area. Assume the price of gold is 25.0 per gram, (a) Find the cost of the gold added to the coin, (b) Does the cost of the gold significantly enhance the value of the coin? Explain your answer.