ASAP PLEASE: A man makes a cup of tea using 354 g of water at 93 degrees C inside a 92 g ceramic mug with a specific heat of 1.09 J/gC. He cools off the tea by adding an ice cube at -6 C. The final temp of the tea and melted ice together is 72 C. Assume the mug and tea keep the same temp. Calculate the mass of the ice cube using only q=mc(tf-ti), q=mHf, and/or q=mHv

ASAP PLEASE: A man makes a cup of tea using 354 g of water at 93 degrees C inside a 92 g ceramic mug with a specific heat of 1.09 J/gC. He cools off the tea by adding an ice cube at -6 C. The final temp of the tea and melted ice together is 72 C. Assume the mug and tea keep the same temp. Calculate the mass of the ice cube using only q=mc(tf-ti), q=mHf, and/or q=mHv

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter2: Steady Heat Conduction

Section: Chapter Questions

Problem 2.39P: The tip of a soldering iron consists of a 0.6-cm- diameter copper rod, 7.6 cm long. If the tip must...

See similar textbooks

Similar questions

A refrigerator is connected to a generator powered by a fuel with a calorific value of 35000 kJ/kg and a density of 0.85 g/cm3 . The inside temperature of the refrigerator is 0°C, and the outside temperature is 20°C. a. How much work is required to freeze 500 g of water? ΔfreezingH° = 6.02 kJ mol– 1 ) b. How much internal energy change occurs during the process? c. Since the generator consumes 5 L of fuel per hour, calculate the thermal efficiency of this engine.
A 0.5 kg of ice(-4°) C is used to cool a bag of shrimp in an insulated cooler after hours all ice melts into water and the final temp of the shrimp and water is 2°C .
5. A 4-m x 5-m x 7-m room is heated by the radiator of a steam-heating system. The steam radiator transfers heat at a rate of 10,000 kJ/h, and a 100-W fan is used to distribute the warm air in the room. The rate of heat loss from the room is estimated to be about 5000 kJ/h. If the initial temperature of the room air is 10°C, determine gow long it will take for the air temperature to rise to 20oC. Assume constant specific heats at room temperature where CAIR = 0.768kJ/kg-K. Draw a figure or FBD that will support the problem. Explain each step by step formula.
8. A room contains 60 kg of air at 100 kPa and 15°C. The room has a 250-W refrigerator (the refrigerator consumes 250 W of electricity when running), a 120-W TV, a 1- kW electric resistance heater, and a 50-W fan. During a cold winter day, it is observed that the refrigerator, the TV, the fan, and the electric resistance heater are running continuously but the air temperature in the room remains constant. Solve for the rate of heat loss from the room that day. (3 DECIMAL IN FINAL ANSWER PLS)
A Styrofoam coffee cup contains 125 g of hot coffee at 95.0 oC. A 25.0-g ice cube at -20.0 oC is dropped into the hot coffee. After the ice melts and thermal equilibrium is reached, the resulting liquid has a temperature of 65.0 oC. The specific heat capacity of ice is 1.99 J g-1 oC-1 and that of water is 4.184 J g-1 oC-1. The heat capacity of the coffee cup is 15.0 J oC-1. Calculate the molar heat of fusion for water. Assume the coffee is essentially pure water (FW 18.015) and that no heat enters or escapes from the system.
Hi! A 14-ft3 tank contains oxygen initially at 14.7 psia and 80°F. A paddle wheel within the tank is rotated until the pressure inside rises to 20 psia. During the process 20 Btu of heat is lost to the surroundings. Determine the paddle-wheel work done. Neglect the energy stored in the paddle wheel. The gas constant and molar mass of oxygen are R = 0.3353 psia·ft3/lbm·R and M = 32 lbm/lbmol. The specific heat of oxygen at the average temperature of Tavg = (735 + 540)/2 = 638 R is cv ,avg= 0.160 Btu/lbm·R. The paddle-wheel work done is Btu. ANSWER
An ordinary egg with a mass of 0.1 kg and a specific heat of 3.32 kJ/kg·°C is dropped into boiling water at 95°C. If the initial temperature of the egg is 5°C, the maximum amount of heat transfer to the egg is (a) 12 kJ (b) 30 kJ (c) 24 kJ (d) 18 kJ (e) infinity
Estimate the volume of your kitchen oven and guess how many Watts it takes to pre-heat the air in your oven from 22 °C (72° F) to 221 °C (~430° F)? If the amount of steel that is heated in the inside of the oven totals 3 kg, how many Watts additionally does it take to pre-heat that? Time your oven to preheat and estimate the average Q needed.
A long roll of 2-m-wide and 0.5-cm-thick 1-Mn manganesesteel plate (ρ = 7854 kg/m3 and cp = 0.434 kJ/kg·°C)coming off a furnace at 820°C is to be quenched in an oil bathat 45°C to a temperature of 51.1°C. If the metal sheet is movingat a steady velocity of 10 m/min, determine the requiredrate of heat removal from the oil to keep its temperature constantat 45°C.
Sup A 14-ft3 tank contains oxygen initially at 14.7 psia and 80°F. A paddle wheel within the tank is rotated until the pressure inside rises to 20 psia. During the process 20 Btu of heat is lost to the surroundings. Determine the paddle-wheel work done. Neglect the energy stored in the paddle wheel. The gas constant and molar mass of oxygen are R = 0.3353 psia·ft3/lbm·R and M = 32 lbm/lbmol. The specific heat of oxygen at the average temperature of Tavg = (735 + 540)/2 = 638 R is cv ,avg= 0.160 Btu/lbm·R. The paddle-wheel work done is Btu. ANSWER is not 54 or 72
An inventor proposes to make a heat engine using water/ice as the working substance, taking advantage of the fact that water expands as it freezes. A weight to be lifted is placed on top of a piston over a cylinder of water at 1°C. The system is then placed in thermal contact with a low-temperature reservoir at -1°C until the water freezes into ice, lifting the weight. The weight is then removed and the ice is melted by putting it in contact with a high-temperature reservoir at 1°C. The inventor is pleased with this device because it can seemingly perform an unlimited amount of work while absorbing only a finite amount of heat. Explain the flaw in the inventor's reasoning, and use the Clausius-Clapeyron relation to prove that the maximum efficiency of this engine is still given by the Carnot formula, 1 -Tc/Th.
It is difficult to extinguish a fire on a crude oil tanker, because each liter of crude oil releases 2.80×10^7 J of energy when burned. To illustrate this difficulty, calculate the number of liters of water that must be expended to absorb the energy released by burning 1.00 L of crude oil, if the water has its temperature raised from 23.5 °C to 100 °C, it boils, and the resulting steam is raised to 315 °C. Use 4186 J/(kg·°C) for the specific heat of water and 2020 J/(kg·°C) for the specific heat of steam.