A room contains 60 kg of air at 100 kPa and 15°C. The room has a 250-W refrigerator (the refrigerator consumes 250 W of electricity when running), a 120-W TV, a 1- kW electric resistance heater, and a 50-W fan. During a cold winter day, it is observed that the refrigerator, the TV, the fan, and the electric resistance heater are running continuously but the air temperature in the room remains constant. Solve for the rate of heat loss from the room that day

Q: Figure 2 shows the results of tensile tests performed on Alloys A and B. Interpret from the curves s...

A: The figure given is : It represents two materials with different material properties  

Q: In a cogeneration cycle, the water vapor in the turbine expands from 6000 kPa and 440 °C to 8 KPa. T...

A:

Q: projected a it attains a by the pre of

A:

Q: Figure Q2[a] shows a shaft supported by three smooth journal bearings at A, B, and C. Given: F,-923 ...

A:

Q: Ammonia exits the stream of a process as saturated liquid at a pressure of 11bar, and is reduced to ...

A:  

Q: An ideal ammonia (R – 717) vapor-compression refrigeration cycle has an evaporator temperature of –2...

A:

Q: The figure represents the concurrent force system acting at a joint of a bridge truss. Determ the va...

A: To determine the value of forces P and F

Q: A standpipe with an inside diameter of 108 in. contains water, which has a weight density of 62.4 lb...

A:

Q: In a boat race, boat A is leading boat B by 50 m and both boats are traveling at a constant speed of...

A:

Q: Replace the loading shown by an equivalent single resultant force and specify the x and y coordinate...

A: The calculated equivalent single resultant force and the x coordinate of its line of action in meter...

Q: 1. A plate is subjected to a couple Fd, with d= 20cm , as shown below left. Verify that the couple c...

A: Hi. as you have posted multiple questions and have not specified which question needs to be solved, ...

Q: Consider a 210-MW steam power plant that operates on a simple ideal Rankine cycle. Steam enters the ...

A:

Q: The beam is supported by two rods AB and CD that have cross- sectional areas of 12 mm and 8 mm?, res...

A: Answer: The position "d" of the 6 kN load is 1.2 m.  

Q: Q3-Draw the shear force and bending moment diagrams for the beam shown in Figure (3). 10 kip 8 kip 2...

A: Explanation: The stepwise procedure to solve this problem is shown in the following attached image:

Q: A single-acting, two-stage air compressor with perfect intercooling delivers 15 kg/min of air at 25 ...

A: Given That,   X=2 two stages,n=1.25,   m=15 kg/min,p3=25 bar,  p1=1 barT1=15°C=15+273=288 K,n=1.25 T...

Q: IV. Constant Pressure Process Steam with an enthalpy of 2000 kJ/kg undergoes a constant pressure pro...

A:

Q: One kg of a gas at 240 °C, expands adiabatically, so that its volume is doubled and the temperature ...

A: m=1 kgT1=240°C+273=513 Kv1=vv2=2vT2=115°C+273=388 KWork done W=90 kJ

Q: A 50 kN block is resting on a horizontal plane with a coefficient of statics friction of 0.3. Determ...

A: The necessary information given in the question is written below as- The static friction coefficient...

Q: A simple Rankine cycle works between the boiler pressure of 100 bar and condenser pressure of 30 bar...

A: GIVEN DATA - A SIMPLE RANKINE CYCLE GIVEN WORKING BETWEEN 100bar AND 30bar WE HAVE TO FIND THERMAL E...

Q: Liquid flows tangentially past a flat plate. The fluid properties are u=10° N.S/m² and p=1.5 kg/m³. ...

A:

Q: ment of each of the N (in N.m and co

A: given:F1=125NF2=150NF3=250N

Q: The pipe assembly is subjected to the force F=58N. Determine the moment of this force about point B ...

A:

Q: A simple Rankine cycle works between the boiler pressure of 4 MPa and condenser pressure of 6 kPa. T...

A: Given:P1=4 MPaP2=6 KPa

Q: 1. The plate below is attached to the vertical surface AB. ItS top and bottom surfaces slide smoothl...

A: Solution: Given Data:

Q: a.) velocity and b.) displacement.

A: Derivation for velocity and displacement.

Q: ᴡᴀᴛᴇʀ ꜰʀᴏᴍ ᴀ ʀᴇꜱᴇʀᴠᴏɪʀ ᴀ 10 ᴍ ᴇʟᴇᴠᴀᴛɪᴏɴ ɪꜱ ᴅʀᴀᴡɴ ʙʏ ᴀ ᴍᴏᴛᴏʀ ᴅʀɪᴠᴇɴ ᴘᴜᴍᴘ ᴛᴏ ᴀɴ ᴜᴘᴘᴇʀ ʀᴇꜱᴇʀᴠᴏɪʀ ʙ ᴀᴛ 7...

A:

Q: (a) Determine the shear strain at corner A if the plate distorts as shown by the dashed line. (b) De...

A:

Q: The following table presents the highway gasoline mileage performance and engine displacement for Au...

A: a.The simple linear model fit for given data is: Hence the regression line is given by:  y = 39.155...

Q: The height (in mm) for a 125 mm sine bar to measure a taper of 27'32' on a flat work piece (correct ...

A: Given:Length of sin bar, L=125 mmθ=27o 32'θ=27+3260oθ=27.533o

Q: The stored energy of a fluid in a closed system changes from 500 to 440 Btu/lbm while the fluid perf...

A:

Q: A single-acting, two-stage air compressor with perfect intercooling delivers 15 kg/min of air at 25 ...

A: Given data: P1 = 1 barT1 = 15°C = 288Kn=1.25Q = 15 kg/min = 0.25 kg/sP3 = 25 barDensity of air at 15...

Q: A thick-walled cylinder with internal and external radii 86 mm and 166 mm respectively, is subject t...

A: we have to determine the radial and hoop stress

Q: 03-Draw the shear force and bending moment diagrams for the beam shown in Figure (3). 10 kip S kip 2...

A: For solution refer below images.

Q: Employ FOUR (4) interrelated constraints which are most vital to improve a spoon design for a fast f...

A:

Q: Determine maximum shear stress in rectangular cross section having width3D5 m and depth =12 m shear ...

A: Given data : Depth=h Width=B Shear force=V   To find : Maximum shear stress

Q: its optimum point of operation, a given centrifugal pump with an impeller diameter of 500 mm deliver...

A: Since no value of head is provided assuming a variable H for head we will proceed as follows

Q: A piece of debris is in circular Earth orbit at altitude 650 km. What is the speed of this orbit? (k...

A: a) 7.53 km/s b) 0.337 km/s c) 1.82 hrs

Q: The hot-air balloon contains air having a temperature of 180∘F while the surrounding air has a tempe...

A:

Q: Express the number .0000003597 using the powers of ten. ON 359.7 x 106 B) 3.597 x 107 35.97 x 104 D)...

A: GIVEN DATA - A DECIMAL NUMBER GIVEN WE HAVE WRITE IN POWER OF TEN

Q: A 3-stage compressor delivers 0.23 kg/s of air. The suction pressure and temperature are 100 kPaa an...

A: Calculated compressor work in kW.  

Q: A 6-pack canned drink is to be cooled from 25°C to 3°C. The mass of each canned drink is 0.355 kg. T...

A: Answer: The amount of heat transfer from the 6 canned drinks is 195.875 kJ.  

Q: Strength of a metal can be measured by the internal resistance or stress that it can withstand. Usin...

A:

Q: A steady-flow Carnot refrigeration cycle uses R-134a as the working fluid. The refrigerant changes f...

A:

Q: A rod is composed of an aluminum section rigidly attached between steel and bronze sections, as show...

A:

Q: A simple rigid structure ABC is to be built to hold load at Cas showa in Figure Q Suppoit AE is to b...

A:

Q: In a refrigeration cycle, the working fluid (refrigerant) absorbs heat from the surroundings in this...

A:

Q: 3 kg of liquid water initially at 12°C is to be heated at 95°C in a teapot equipped with a 1200-W el...

A: Given:m=3 kgTi=12°CTf=95°CQ=1200 WC=4.18 KJ/s

Q: With a solidification factor of 0.97 x 10 s/m2, the solidification time (in seconds) for a spherical...

A: Given: Spherical castingd=200 mmr=100 mm or 0.1 m

Q: Which statement is not correct?   a. For a closed system, the area below the curve of a process on a...

A: Its answer is d) In most cases, internal energy of a closed system is negligible compared to its kin...

Q: Determine pressure due to water at depth of 20 m on a body

A: