Couples Assignment:1. Find the values of P and F so that the four forces shown in the figure will produce an upwardresultant of 300lbs acting 4ft from the left end of the bar.100 lb200 lb2'--3'

Answered: Assignment: 1. Find the values of P and…

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.6P: Find the internal force systems acting on sections 1 and 2.

See similar textbooks

Similar questions

The structure is supported by a pin at C and a cable attached to A. The cable runs over the small pulley D. Find the internal force systems acting on sections 1 and 2.
Cable AB supports the uniformly distributed load of 4 kN/m. If the slope of the cable at A is zero, compute (a) the maximum tensile force in the cable; and (b) the length of the cable.
Find the values of P and F so that the four forces shown in the figure will produce an upward resultant of 300lbs acting 4ft from the left end of the bar?
The post weighing 1500 lbs is to just be vertically pulled out of the ground using two ropes as shown in the figure. One rope is subjected to a force of 600 lb and is directed at 60° from the horizontal. Determine the angle θ (degrees). Solve with FBD and complete solution.
In a hydraulic press the diameter of the plunger is 50 mm . Find the diameter of the hydraulic press side when the force at hydraulic press side is 22050 N to lift the weight at the plunger of 450N. a. 350 mm b. 250 mm c. 500 mm d. 100 mm
Q2: Determine the X and Y components of (100) N force as in figure below.
A 30N pair of forces equivalent to these pairs will be placed at points A and B. So what should the AB length be?
Resolve the forces shown in the Figure below to two components Fx and Fy
Figure Q2 shows an arrangement used to transfer materials F to a construction site. The rod OB is fixed at datum O. One of the systems used have dimension and loads as given in Table Q2. During operation, Pulley A is rotated as shown to move the load upwards. The inclination angle of rod OB is θ = 45O. Determine: Stress in Rope 1 (in MPa) Stress in Rope 2 (in MPa) Extension in Rope 2 (in mm) The minimum diameter of Rope 2 (in mm) if the stress is at yield
The figure shown has a force load distributed as shown in the figure. The value of the intensity of w is 116 lb/ft. Calculate the value of the resultant force.
Compute the forces in the two angled rods in Figure below for an applied force, F = 1500 lb, if the angle u is 45°.
The semi circular gate shown in the figure is hinged at B. Determie the force F Required to hold the gate in position? 5088.5 lbs

SEE MORE QUESTIONS

Recommended textbooks for you

International Edition---engineering Mechanics: St…

Mechanical Engineering

ISBN:

9781305501607

Author:

Andrew Pytel And Jaan Kiusalaas

Publisher:

CENGAGE L