Answered: At the receiver the syndrome for a…

At the receiver the syndrome for a Hamming coded data was=[00100], in what bit there is an error, and what is the code rate.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

ChapterS: Safety, Basic Electricity And Ohm's Law

Section: Chapter Questions

Problem 8RQ: What is an MSDS?

See similar textbooks

Related questions

Q: B A o CLK B K A CLR CLR CLR B

A: We need to tell about the given circuit, how bit counter ,it is .

Q: Binary to Octal Decoder using 7-Segment Display

A: To design Binary to Octal Decoder using 7-Segment Display

Q: 27.Transmission protocol serial asynchronous 8 bits ASCII, 1 parity bit, 9600 bps. How long will it…

Q: Given 7-bit message 1001101. Explain the process involved in Hamming code in sender and receiver…

Q: 1.how does an additional 2 bits affect the SQNR ?

A: The signal to quantization noise ratio SQNR in db is given by SQNR=6.02n+ k where n=no of bits per…

Q: The propagation delay period of gate A is longer than that of gate B. Which gate has the capability…

A: propagation delay is the time elapsed between the arrival of input to gate and output . Time period…

Q: b) What is the purpose (jll ) of the parity bit during data transmission?

A: According to the question we have to discuss the purpose of the parity bit during the data…

Q: Find the answers to the following question? a) Convert binary to grey code 0101011

A: Given binary code is 0101011. To convert n bit binary to grey code:…

Q: clock signal frequency for a 4-bit up counter is 20kHz. What is the frequency of the most valuable…

A: Option :b Answer

Q: Decode the signal according to the given constellation diagram, where each symbol represents a…

A: It is clearly seen from the plot of signal that it consists of 4 signals each of different…

Q: Find the answers of the following questions? a) Find the excess-3 code of (175)10 b) Convert binary…

A: a) excess -3 code of (175)10 (175)10 1 7 5 +3 +3 +3=4 =10 =80100 1010…

Q: If the sequence "101010." is transmitted using Differential Manchester encoding, what is the ratio…

Q: Design a 3Bit Odd Parity Detector using :a) Multiplexer b) Decoder, and appropriate gates?

A: To design a 3 bit odd parity detector, we will use 3 bits A, B, C & output will be Y Therefore…

Q: 5. Design a synchronous counter that counts from 0 to 32 and write its truth table?

A: Let us make the counter using the D flip-flops. Write the state table for the D flip-flop.…

Q: A common bus system which is capable of transferring 2 bits at time with number of registers are 4…

A: The circuit diagram for a common bus system which is capable of transferring 2 bits at a time with…

Q: Design don't-care conditions. an excess-3-to-binary decoder using the unused combinations of the…

A: Design an excess 3 to binary decoder using the unused combinations of the code as dont care…

Q: Q6) What is the smallest value of n in linear block code with a minimum distance of three and a…

A: Given: In the above given question they have mentioned about the linear block codes. Linear block…

Q: When using an ADC what is the drawback to using a larger number of bits?

A: ADC (analog to digital converter) which converts the analog signal into the digital signal.

Q: 6. Calculate the check bits (find the codeword) for the bit-pattern (100101011), using Hamming code…

Q: Find the simplified form of F in the decoder circuit below and write to the textfield. F = ?

A: The solution can be achieved as follows.

Q: Binary to Octal Decoder using 7-Segment Display. what is the K-map and truth table ?

A: Binary to octal Decoder using 7-segment Display- These four input lines (A, B, C, and D) is used in…

Q: d. For a bit error probability of 1 bit in 10' bits, how many errors could be expected in 60 GB of…

Q: Binary to Octal Decoder using 7-Segment Display. write the k-map and use 4 input and 7output?

A: Truth Table digit A B C D a b c d e f g 0 0 0 0 0 0 0 0 0 0 0 1 1 0 0 0 1 1 0 0 1 1 1 1 2 0…

Q: Draw a bus organization consisting of 3 bits and 5 registers.

A: The following diagram shows the bus organisation with 5 registers

Q: (b) If the received code word is 110100010101, determine if the code word is correct. If no,…

A: According to the question, we need to determine if the codeword is correct? The codeword is…

Q: 4. Draw 3-bit synchronous counter and write its truth table?

A: We need to design 3 bit synchronous counter . We will Design the 3 bit up counter by using of T flip…

Q: Construct a 4-to-16-line decoder with five 2-to-4-line decoders with enable. Use block diagrams.

Q: Q2- c) Consider the transmitted bit stream b(t)= [1011101100] for a DPSK modulation scheme. At the…

Q: A large multiplexer 512 to 1 require how many address line?

A: The number of address lines in a MUX is the addition of select lines and input lines.

Q: 7. (15') Stack: What is the function of the stack? If the current values in the stack segment…

A: According to the question, we need to define stack and also find the addresses of Bottom of Stack…

Q: A message 001101101 is being transmitted through a even parity generator. What will be total…

A: The parity bit is added to the left-most position of the message bits. If the number of 1's present…

Q: Vhat is the minimum number of bits required for the binary representation of a number greater than…

A: SOLVE ABOVE QUES.

Q: Q. No 3. In a Public Switch Telephone Network (PSTN), how the analog speech signal is converted to…

A: PSTN represents Public Switched phone phone Network or the standard circuit-exchanged phone…

Q: Draw 3-bit synchronous counter and write its truth table?

Q: For the given diagram determine which of the inputs devices is transferring its data to the data Bus…

A: Figure shows that input channels are connected to microprocessor through 3 state octal buffer

Q: Give an example of a decoder.

A: The decoder is an electronic device that converts the message signal into the signal, which is…

Q: Q4. Suppose we receive a bit sequence: 00000 00100 11110 10000, and suppose a repetition code with 5…

A: In the received bit sequence a repetition code with 5 total bits and 1 data bit is used that implies…

Q: A multiplexer combines four 100 kbps channels using a time slot of 2 bits. The bit duration is 2 ms…

A: Multiplexer- It is a combinational circuit that selects several inputs and forwards them to a single…

Q: 1. What is the purpose of channel coding? 2. What are the different channel coding techniques used?…

A: 1) The purpose channel coding is to design codes for the reliable transmission of digital…

Q: A call processor in exchange requires 240 ms to compute the call (call processing time). What is…

A: We are authorized to answer one question at a time, since you have not mentioned which one you are…

Q: Suppose we are representing a sequence of 8 bits using 4-ary pulse amplitude modulation (PAM). If…

Q: If the sequence "111111." is transmitted using Differential Manchester encoding, what is the ratio…

Q: For the following sets of codewords, i. Please give the appropriate (n,k,d) designation where n is…

A: Given: For the following set of codewords: To find: i. Please give the appropriate (n,k,d)…

Q: Observe the encoded binary signal? What line encoding format was used

A: What type of encoding format is used

Q: 3. A communication system uses (7, 4) Hamming code for encoding and decoding. a) Write the encoded…

A: Part a: Since it is given a 7-bit number, so there must be 4-bit data and 3-bit parity. According to…

Q: Suppose, you have 6 voice channels, each of 60MBPS. You have to use synchronous TDM to multiplex…

Q: In a multibyte addition program, when must you use the ADD instruction? When must you use the ADC…

A: In this question we will write about ADD and ADC instruction..

Q: Q6) What is the smallest value ofn in linear block code with a minimum distance of three and a…

Concept explainers

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.

Question

I need the answer as soon as possible

Q.5
At the receiver the syndrome for a Hamming coded data was=[00100],
in what bit there is an error, and what is the code rate.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

a. If 1,000 bits per second (bps) are transmitted, what is the error probability?b. If 10,000 bps are transmitted, to what value must A be adjusted in order to attain the same error probability as in part (a)?
A bit word 1010 is transmitted . construct the even party 7-bit hamming code for this data?If at receiver end data is received as 1000010, then check and correct the code using even parity scheme. Assume the direction of generation and checking the code from right to left?
Find the simplified form of F in the decoder circuit below and write to the textfield. F = ?
Consider g(x)= x3 + x + 1, with 1001 as the information sequence. Determinethe transmitted codeword. With the first received bit in error, how the errorchecking is done at the receiver?
What is the worst-case value for the bit error probability for any digital communication system? Use the decimal form.
Q3) A bit word 1010 is transmitted. Construct the even parity 7-bit hamming code for this data? If at receiver end data is received as 1000010, then check and correct the code using even parity scheme. Assume the direction of generation and checking the code from right to left?
In PCM, assuming uniform quantization, what is the signal to noise ratio in dB for 12-bit code word?
What is the probability of error with a PSK system with a bit rate of 20kpbs, BW of 50 kHz, Noise power of 10-13 W, Carrier Power of 3.3-14 Joules?
In a PCM system, the quantizer has 256 equal levels. How many bits per sample is present in the transmitted sample?
Assume that a voice channel occupies a bandwidth of 4 kHz. We need to combine three voice channels into a link with a bandwidth of 12 kHz, from 20 to 32 kHz. Show the configuration, using the frequency domain. Assume there are no guard bands in computer communication and network?
If in a PCM system, uniform quantizer having total 256 steps is being used, then what will be the number of transmitted bits per sample?
Assume after sending its frame, node A wait for the acknowledgment back from node C before sending the next frame. What is the average throughput (number of transmitted bits per second) of the data flow from node A to node C?