Binary to Octal Decoder using 7-Segment Display. write the k-map and use 4 input and 7output?

Q: Can you call a DECODER as a DEMUX? If yes, in which case that could be. Design a DEMUX using simple…

A: The major distinction between a demultiplexer and a decoder is that the former is a combinational…

Q: B A o CLK B K A CLR CLR CLR B

A: We need to tell about the given circuit, how bit counter ,it is .

Q: How many bits are required for the control selector in the 64x1 multiplexer? a. 4 O b. 5 О с. 6 How…

A: Use fundamental of multiplexer design 1)Option c 6 2)Option c 8

Q: b) What is the purpose (jll ) of the parity bit during data transmission?

A: According to the question we have to discuss the purpose of the parity bit during the data…

Q: 2. How can a serial in/parallel out register be used as a serial in/serial out register?

A:

Q: Question Implement the Function 'Y = ACB + BC + E' using a 4-Input, 2-Address Bit Multiplexer. What…

A:

Q: Write VHDL code for an n-bits register (n can be 4, 8, 16, …) with the Synchronous Reset Active Low,…

A:

Q: 3. What converts binary numbers to decimal numbers? 1. BCD to 7-segment Decoder 2. Encoder 3.…

A: BCD to 7-segment Decoder converts binary numbers into decimal numbers.

Q: 2. Define MUX and DEMUX. Where we use mux and demux system? How toc reate a 16:1 MUX by using 4:1…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: Draw the internal logic circuit for 3-8 decoder circuit with enable

A:

Q: Show how a five bit 11011 binary number can illustrated in the five-bit serial in –parallel out…

A:

Q: 1. Compare between BCD code & Excess-3 code?

A: The digital circuits can be combinational as well as sequential circuits. The combinational circuits…

Q: What is meant by 4 to 16-line decoder? Draw the block diagram of that decoder (Please don't show the…

A: As per bartleby guidelines we are supposed to answer only question as it is not a subpart, So I have…

Q: Q6) What is the smallest value of n in linear block code with a minimum distance of three and a…

A: Given: In the above given question they have mentioned about the linear block codes.   Linear block…

Q: 2- Draw the logical diagram of a 2 line to 4 line decoder using NOR 1- Draw the circuit for 3 to 8…

A: Demultiplexer is many to one logic circuit. It is also known as distributor or serial to parallel…

Q: Find the simplified form of F in the decoder circuit below and write to the textfield. F = ?

A: The solution can be achieved as follows.

Q: Binary to Octal Decoder using 7-Segment Display.  what is the K-map and truth table ?

A: Binary to octal Decoder using 7-segment Display- These four input lines (A, B, C, and D) is used in…

Q: Sketch the function F= A (Buffer) using NOR gates only.

A:

Q: What Is branch datapath?

A: Branch datapath : A datapath which is also written as data path is the path which consist of…

Q: Explain how the data logger works in at least four points or sentences

A: Data logger: It is a measuring device. They will automatically store or record data time to time.

Q: Convert the given BCD number into decimal BCD 1010101001 Decimal b) Convert the given binary number…

A: 10102 = this will produce an error as it is decimal 1010 and not a valid BCD number BCD valid for…

Q: Construct a 5X32 decoder with 3X8 decoders with enable and one 2X4 decoder. Use block diagram for…

A: this required one 2x4 decoder and four 3x8 decoders.

Q: A large multiplexer 512 to 1 require how many address line?

A: The number of address lines in a MUX is the addition of select lines and input lines.

Q: 7. (15') Stack: What is the function of the stack? If the current values in the stack segment…

A: According to the question, we need to define stack and also find the addresses of Bottom of Stack…

Q: (b) Draw the diagram of SR latch using NOR gate with truth table.

A: The truth table of an SR latch using NOR gate can be made as:

Q: Load the number of ffh into the 'a' register and write the code that reduces the number in the 'a'…

A: Load the number of ffh into the 'a' register and write the code that reduces the number in the 'a'…

Q: How many decoders 3:8 Decoders and 2 inp-And gates needed to construct 4:16 decoder?

A: Encoders and decoders are a part of combinational logic circuits. A decoder has n inputs and 2^n…

Q: 1 the minimum signal to noise ratio (SNR) to receive the symbols bability of bit error 106 or less?…

A:

Q: The required 7-segmrnt decoder should have 3-inputs (which are the bits of the binary number desired…

A: We need to design 7 segment decoder circuit using 3 inputs A,B,C. We need to find output as a…

Q: The binary number 1010 0011 is an ?even or odd? number that has ?even or odd? parity?

A: If the number of ones are even then it is a even parity    If the number of ones present in the…

Q: Q4. Suppose we receive a bit sequence: 00000 00100 11110 10000, and suppose a repetition code with 5…

A: In the received bit sequence a repetition code with 5 total bits and 1 data bit is used that implies…

Q: How is serial transmission of a digital word different from parallel transmission?

A: There are generally two ways so that anyone can send data between digital signal. The ways are…

Q: 5) Design an Encoder system using the following truth table for a system. a) Find the out-put…

A: Part a: Redraw the truth table for showing the input and output variable,

Q: A data of 111e is serially transmitted using both binary and BCD? Which encoding technique is faster…

A: Bartleby has policy to solve only 1st question.  For solutions of rest questions re-upload them.

Q: 1. What is the purpose of channel coding? 2. What are the different channel coding techniques used?…

A: 1)     The purpose channel coding is to design codes for the reliable transmission of digital…

Q: true or false ?? an even two bit parity checker will output a parity error if data A=LOW data ,…

A: Given, An even two bit parity checker will output a parity error if data A=LOW, data B=HIGH, parity…

Q: In a DPCM system, the number of bits per sample is 7. How many levels are present in the quantizer?

A: A quantizer is an integral part of a differential pulse code modulated (DPCM) system.  The number of…

Q: SV What is clocking block ? what is program block?

A: Reg is driven by always  block it can't be driven by continuous assignment statement. Always block…

Q: Explain the operation of a 2 x 4 line decoder with enable and active low output.

A:

Q: How many BCD code bits and how many straight binary bits would be required to represent the decimal…

A: we need to represent 34 into BCD code and straight binary.

Q: Observe the encoded binary signal? What line encoding format was used

A: What type of encoding format is used

Q: Write the truth table of 3 to 8 line decoder and derive the Boolean expression and finally draw the…

A:

Q: (b) How many 3-to-8 line decoders with an enable input are needed to construct a 6-to-64 line…

A:

Q: a. What is the counting range in binary and decimal for an up-counter with 3 bits? p. What is the…

A:

Q: In a multibyte addition program, when must you use the ADD instruction? When must you use the ADC…

A: In this question we will write about ADD and ADC instruction..

Q: Q6) What is the smallest value ofn in linear block code with a minimum distance of three and a…

A:

Q: i): Implement the Boolean function ? = ??̅? using 2-input NAND gates in optimized manner.   ii):…

A: