At what speed (in meters per second) must the sliding rod in the figure below move to produce an emf of 1.00 V in a 1.40 T field directed perpendicular to the rods and into the page, given the rod's length is 27.5 cm? B. & Ⓡ RⓇ Application of Lenz's R law RHR-2 B.X OB. ΔΑ – (ΔΧ increasing 3R Equivalent circuit RHR-1

At what speed (in meters per second) must the sliding rod in the figure below move to produce an emf of 1.00 V in a 1.40 T field directed perpendicular to the rods and into the page, given the rod's length is 27.5 cm? B. & Ⓡ RⓇ Application of Lenz's R law RHR-2 B.X OB. ΔΑ – (ΔΧ increasing 3R Equivalent circuit RHR-1

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter25: Electromagnetic Induction

Section25.1: Electric Current From Changing Magnetic Fields

Problem 3PP

See similar textbooks

Similar questions

Check your Understanding Themagneticfield shown below Is confined to the cylindrical region shown and is changing withtime. Identity those paths for which =EdI0 .
The magnetic flux through the loop shown in the accompanying figure varies with time according to m=2.00e3tsin(120t) , where m is in milliwebers. What are the direction and magnitude of the current through the 5.00 resistor at (a) t= 0; (b) t=2.17102 s and (c)t=3.00 s?
The rod shown below moves to the right on essentially zero-resistance rails at a speed v=3.0m/s . If B = 0.75 T eveywhere in the region, what is the current through the 5.0 resistor? Does the current circulate clockwise or counterclockwise?
Check Your Understanding Shown below is a rod of length l that is rotated counterclockwise around the axis through O by the torque due to mg . Assuming that the rod is in a uniform magnetic field B , what is the emf induced between the ends of the rod when its angular velocity is ? Which end of the rod is at a higher potential?
A solenoid is wound with 2000 turns pet meter. When the cuiient is 5.2 A, what is the magnetic field within the solenoid?
Check Your Understanding A long solenoid of cross-section area 5.0 cm2is wound with 25 turns of wire pet centimeter. It is placed in the middle of a closely wrapped coil of 10 turns and radius 25 cm, as shown below. (a) What is the emfInduced In the coil when the current through the solenoid Is decreasing at a rate dl/dt= -0.20A/s? (b) What Is the electric field Induced In the coil?
In the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a constant VelOCity v. The velocity is in the same plane as the rails and directed at an angle 6 to them. A uniform magnetic field Bis directed out of the page. What is the emf induced in the r?
The accompanying figure shows a conducting ring at various positions as It moves througli a magnetic field. What is the sense of the induced em! for each of those positions?
The armature and field coils of a series-wound motor have a total resistance of 3.0 . When connected to a 120-V source and running at normal speed, the motor draws 4.0 A. (a) How large is tire back emf? (b) What current will the motor draw just after it is turned on? Can you suggest a way to avoid this large initial current?
The current in the long, straight wire shown in the accompanying figure is given by, where I=I0sint I0=15Aand=120rad/s. What is she current induced in the rectangular loop at (a) t = 0 and (b) t=2.1103s The resistance of loop is 2.0 .
An eight-turn coil is tightly wrapped around the outside of the long solenoid as shown below. The radius of the solenoid is 2.0 cm and it has 10 turns per centimeter. The current through the soleNOID increases according to I=I0(1eat) where I0=4.0A and a=2.0102s1 . What is the emf induced in the coil when (a) t=0, (b) t=1.0102s and (c) t ?
In the August 1992 space shuttle flight, only 250 m of the conducting tether considered in Example 23.2 could be let out. A 40.0 V motional emf was generated in me Earth’s 5.00105T field, while moving at 7.80103m/s. What was the angle between the shuttle’s velocity and the Earth’s field, assuming the conductor was perpendicular to the field?