I need the answer quickly The equation of single tone angle modulated voltage signal is Ø(t) = 10 cos(10t + 3sin10 t).Calculate:-1- The carrier and modulating frequencies (in Hz).2- Modulation index and the frequency deviation.3- The bandwidth of Ø(t) by using definition of significant sidebands.4- Total power dissipated in 100 2 resistor.

Answered: Image /qna-images/answer/ade136e8-4353-42c5-a10a-993fc3c7504a.jpg

Answered: ate:- e carrier and modulating…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In the circuit given in the figure, β = 100, r0 = 40 kΩ, RB = 360 kΩ, RC = 3.3 kΩ, RE = 220 Ω, Rs = 0.5 kΩ and RL = 12.2 kΩ. Accordingly, find the voltage gain (Vout/Vin) of the circuit.NOTE-1: The output impedance of the transistor r0 will be taken into account in the calculations.NOTE-2: Capacitors are negligible at midband frequency.NOTE-3: The applied ac voltage has an amplitude of 10 mV and a frequency of 1 kHz.
Consider the modulating signal m(t) = 10 sin(2π10^10) that is used to modulate a carrier frequency of 25MHz
An AM transmitter uses high-level modulation. The RF power amplifier draws 12 A from a 22 V supply, putting out a carrier power of 140 watts. What impedance (in ohms) would be seen at the modulation transformer secondary?
The equation of angle modulated voltage is v = 10 sin ( 108t+ 3 sin 104t). What form of angle modulation is this? Calculate the carrier and modulating frequencies, modulation index and deviation. Power dissipated in 100 Ω resistor.
1.Assuming you are positioned at 5500 meters from the omnidirectional radio receiver you are jamming. Note that the transmitted signal you are jamming originates 3000 meters further away from the receiver. Signal transmitter’s EIRP is 14.5 dBW. Note that both the transmitter and jammer have line of sight, your jammer EIRP of 44W, however, will allow you to jam the receiver with what J/S ratio?.
-The modulating signal 2cos (2 π×103 t) is used to modulate a carrier signal 40cos (2 π×104t). Evaluate the modulation index, percentage modulation, frequency of side band components and their amplitudes .What is the bandwidth of a modulating signal.
Solve for the voltage gain in dB if Rf=7.75kOhms and Ri=2.43kOhms?
Problem 1 The transistor parameters for the given circuit are β = 100, VBE (on) = 0.7 V, and VA = ∞. Determine the midband gain AvM, corner frequencies fL and fH, and bandwidth BW of the given amplifier. Problem 2 Determine the corner frequencies and limiting horizontal asymptotes of a commonemitter amplifier with an emitter bypass capacitor. For the given circuit, RE = 4 kΩ, RC = 2 kΩ, RS = 0.5 kΩ, CE = 1 μF, V + = 5 V, and V − = −5 V. The transistor parameters are: β = 100, VBE(on) = 0.7 V, and ro = ∞.
What is the modulation index for an AM signal having Vmax and Vmin of 2.6 and 0.29, respectively Answer: 0.799 show the solution
20.a. A –0.5 dBm signal is transmitted through a fiber link. The transceiver at the receiving end has a receiver sensitivity threshold of –13 dBm. What's the optical budget in this link?A. 13.5 dBB. 6 dBC. 12.5 dBD. 13 dB20.b. A transceiver has an extinction ratio of 6 in a fiber link. What's the extinction ratio power penalty?A. 1.5 dBB. 7.8 dBC. 1.1 dBD. 6 dB
a. An AM transmitter has the unmodulated carrier power of 20kW and can be modulated to a maximum of 70% before the system saturates/overloads. Find the value to which carrier power can be increased if 40% modulation limit is imposed.b. An analog communication system using FM has the highest modulating frequency of 5 kHz and maximum deviation of 25 kHz. Calculate the bandwidth of modulated signal using Carson’s rule. Compare this value with the one obtained using the simple formula. For practical systems which of these values should be used?
Given the following message, m(t), carrier, c(t), and Kvco=4500(Hz/v), determine the FM modulated signal equation and FM index. m(t)=2cos(2π3500t), c(t)=4cos(2π5MHzt). With explain a. s(t)=2cos(2π5E6t + 1.56sin(2π3500t)), β=1.56 b. s(t)=2cos(2π3500t + 1.56sin(2π5E6t)), β=1.56 c. s(t)=4cos(2π5E6t + 2.57sin(2π3500t)), β=2.57 d. s(t)=4cos(2π3500t + 2.57sin(2π5MHz*t)), β=2.57

SEE MORE QUESTIONS

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS

ate:- e carrier and modulating frequencies (in Hz). dulation index and the freauency deviation