Atmospheric air is blowing at 55 km per hour in a windy province in Mindanao. A windturbine generator set with over-all efficiency of 348%and a fan blade diameter of 20 meters is to be installed. Calculate the power that can be generated if the average air temperature is 28 degrees C.

Atmospheric air is blowing at 55 km per hour in a windy province in Mindanao. A windturbine generator set with over-all efficiency of 348%and a fan blade diameter of 20 meters is to be installed. Calculate the power that can be generated if the average air temperature is 28 degrees C.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.12P: Find the inductive reactance per mile of a single-phase overhead transmission line operating at 60...

See similar textbooks

Related questions

Q: 3. A hydroelectric plant has a reservoir of area 2 sq. kilometres and of capacity 5 million cubic…

Q: Given a biomass fuel cell powerplant which has power capacity of 600 kW, and assume it generates at…

A: Given power capacity =600 kW operation = 50 weeks per year Installation cost =$10 million =$106…

Q: A transmission line has an actual impedance of 18 ohms, compute for the per unit impedance of this…

Q: How can we calculate the safe distance (horizontal and vertical) of the transmission line 11kv?

A: A transmission line is a network of wires used to transport electrical impulses from one location to…

Q: Example 4.5. A generating station has an installed capacity of 50,000 kW and delivers 220 × 10 units…

Q: A wind turbine gives the following data: Blade length, I = 52 m, Wind speed, v= 120 km/hr, Air…

A: wind energy is a type of renewable energy . In this kinetic energy of wind is used to rotate the…

Q: Identify the company or private distributor of electricity involved in primary power distribution in…

A: The company that provides power distribution in the PHILIPPINES is Manila Electric Company is…

Q: A Wind Energy Conversion System with the following data: Downward wind velocity:9 m/s Upward wind…

Q: For a hydroelectric power station, calculate the turbo generator efficiency for a site which is a…

A: Output of hydro power station = 9.81× pho× discharge in m3/sec×height of the dam × efficiency of…

Q: Calculate the power, in Watts, required to move air molecules from a driving car at 79.2 kph, sea…

Q: Maria Cristina falls located at south has a height of 100 meters, it discharges at constant rate 2.5…

Q: Q2. 30, 220 kV, 50 Hz, 115 km long transmission line consisting of three conductors each of 20 mm…

Q: In a string of three identical suspension insulator units supporting transmission line conductor.if…

A: Given: Cm=CCs=0.1C∵Cs=mC∴m=0.1

Q: The fuel-cost curves for a two generators power system are given as follows: C¡ (P1) = 600 + 15 · P1…

Q: In an undisturbed sea level condition airstream, the velocity of the flow is 600 ft/s. What is the…

A: It is given that: v1=600 ft/sv2=680 ft/s

Q: The fuel-cost curves for a two generators power system are given as follows: C (P1) = 600 + 15 · P1…

A: Given: C1P1=600+15P1+0.05P12C2P2=700+20P2+0.04P22PL=2×10-4P12+3×10-4P22-4×10-4P1P2 MWMarginal cost,…

Q: Derive the equation for maximum power transfer, Pmax= E V / X.

Q: Businessman Lance Smile own two large malls in Basilan Island. Both malls are connected in parallel…

A: Given,Operating voltage, V=13.2 kVrmsImpedance, Z=0.1+j0.25 ΩFor mall 1,P1=400 kWcosθ1=0.75…

Q: A remote community in Marikina plans to put up a small hydro-electric plant to service six closely…

A: It is given that: Total Available Head=480 mTurbine efficiency=87%Generator efficiency=92%Loss in…

Q: A 275 kV, 50 Hz, 65 km transmission line has a series impedance of 0.12 + j0.5 O/km. By neglecting…

A: EFFICIENCY: Efficiency of transmission line is defined as the ratio of receiving end power to…

Q: j0.1 2.0+j0.5 j0.4 j0.2 1.01 3.

A: This question is from "Power System". Under which we are going to find out the "Y-parameter of the…

Q: i) Determine rated power of the wind turbine (WT) generator with rotor diameter Drt = 25 m, and the…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: load of the persons and infiltration in the room are 5100 W and 3400 W respectively; the air is 1250…

Q: A hydroelectric plant has a reservoir of area 2 sq. kilometres and of capacity 5 million cubic…

Q: 4. A 12 watts DC motor is used to run a remote-controlled car. A 3-inch aluminum shaft, with a…

A: Shear stress is define as the force which deforms the material by a slipping force along the plane.…

Q: Which Thermal Power Plant utilizes waste, rubbish, or trash that can create methane as well as…

A: Recycling plants are used to produce methane and biomass from waste, rubbish or trash.

Q: Which component represents Y axis of load duration curve ? a Time of a day b. Peak Demand C Power…

A: Choose the correct option Which component represents Y axis of load duration curve?

Q: A transmission aluminum cable 5mm in diameter. Find the 50 degree Celsius AC resistance per km of…

Q: spectively per mile. Find the percent efficiency of the line.

Q: Estimate the total land requirements for wind farms generating an amount of electric energy equal…

Q: QI. A transmission line has a conductor weight of 1200 kg/km and stress of 1110 kg. The sag was 9m.…

A: For a transmission line,The weight of the conductor is,W=1200kg/kmThe stress is,T=1110kgThe sag…

Q: What is the Total Actual Energy Generated by Davao Power Plant if there are (4) substation with 1.12…

Q: Q2.) For an AM Radio channel, calculate the power efficiency of this system when the carrier…

Q: Q1: If the power generated by a wind system at a height of 50 m is equal to 30 kw at a wind speed of…

A: Given that Pw1=30 KWh1=50 mh2=?v1=4m/sPw2=1.5Pw1v2=2v1 Although it is known that , in the case of…

Q: A hydroelectric plant has a reservoir of area 2 sq. kilometres and of capacity 5 million cubic…

Q: 5. A 100 MW hydro-electric station is supplying full load for 10 hours in a day. Calculate the…

A: Given Data: P = 100 MW n = 200 m effi = 80% t = 10 hours

Q: 1. A wind turbine supplies an effective power output of 1.8 MW to a grid. Determine the power…

A: The solution can be achieved as follows.

Q: 400 psoft Word (Product Activation Failed) Table Tools ences Mailings Review View Design Layout Aa…

A: Here it is ask that line charging admittance of Y bus connected between two buses is affects as

Q: A transmission line has a span of 150 m between level supports. The conductor has a cross-sectional…

A: Given Span l = 150 mConductor Area = 2 cm2Ultimate Strength = 5000 kg/cm2Specific gravity of the…

Q: A 46KV 0.8 lagging power factor load is connected to the end of a short transmission line where the…

Q: The span of the same leveled transmission line is 300 meters. The carrier's diameter is 15…

Q: Problem (3): A wind turbine with a blade diameter of 50 m is to be installed in a location where…

Q: Given a windfarm site with 500-meter elevation, 8 m/s average wind speed, and average temperature of…

A: A windfarm site has 500-meter elevation, 8 m/s average wind speed, and average temperature of 27°C.…

Q: Q: A 3 phas e , 50 HZ Transmission line clookm) and (10 kv), delivers 50MUA, o.8 pf Lagging Long the…

Q: 4. Determine the maximum power output of a real wind turbine which has a power coefficient equal to…

A: The power output of real wind turbine for the given data is determined as shown below

Q: A single line diagram of a system is shown in Fig. All the values are in per unit on a common base.…

A: The given circuit is shown below: V=1 p.u.P=1p.u.cosϕ=0.8 lagging

Q: 1. Gas insulated substation (GIS) use following gas for insulation a) CO2 b) Sulfur hexafluoride c)…

A: option " b" is correct. Gas Insulated Substation used Sulfur Hexaflouride gas for insulation.…

Q: HAWT type wind turbine has the following data, height of tower =100 m, diameter of rotor = 80 m,…

A: According to question:

Question

Atmospheric air is blowing at 55 km per hour in a windy province
in Mindanao. A windturbine generator set with over-all efficiency
of 348%and a fan blade diameter of 20 meters is to be installed.
Calculate the power that can be generated if the average air
temperature is 28 degrees C.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

Discuss the significance of FACTS (Flexible AC Transmission Systems) devices in enhancing power system stability.
Find the inductive reactance per mile of a single-phase overhead transmission line operating at 60 Hz given the conductors to be Partridge and the spacing between centers to be 30 ft.
Explore the role of FACTS (Flexible AC Transmission Systems) devices in enhancing power system stability and control.
Draw the circuit diagram of Two quadrant chopper which is having average load current might be positive or negative. Explain each quadrant operation with neat sketch
A transmission line has a span of 250 meters between the line supports. The conductors has a cross sectional area of 1.29 cm2 and weighs 1170 kg/km and has a breaking stress of 4218 kg/cm2. Calculate the sag and vertical sag with a safety factor of 5, with a wind pressure of 122 kg per square meter of the projected area.
The data for a wind turbine is given below: Wind speed = 14 meters/sec, Length of blade = 10 meter Refer to the above wind turbine choose the correct statement a. The wind rotor swept area is 40square meters. b. The wind rotor swept area is 314 square meters. c. The wind rotor swept area is 31.4 square meters. d. The wind rotor swept area is 62.4 square meters.
Four industrial centers are located at the corners of a square of 35300 m side. The loads are 430000 W, 600000 W, 220000 W and 740000 W respectively. Determine the best Y coordinate location of the substation . The reference point of load is 220000 W. Coordinate of Y in KM =
Good day i need a MAXWELL MESH METHOD solution for this thankyou!
The annual load duration curve of a power supply system may be considered as straight line from 40 MW to 8 MW. The load factor of the system is ?
1/In the Transmission Line Simulator, the Transmission Line is connected in Nominal-Pi Circuit. Select one: True False
A high-voltage direct-current (dc) transmission line between Celilo,Oregon, and Sylmar, California, is operating at 800 kV and carrying1800 A, as shown. Calculate the power (in megawatts) at the Oregonend of the line and state the direction of power flow.
Short answer question: Explain one advantage and one challenge associated with the utilization of renewable energy sources, such as wind or solar energy.