Answered: Draw the circuit diagram of Two…

Draw the circuit diagram of Two quadrant chopper which is having average load current might be positive or negative. Explain each quadrant operation with neat sketch

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem ACSQ

See similar textbooks

Related questions

Q: Draw the equivalent circuits of Class E chopper for the different quadrant operation and write its…

Q: Give one advantage and disadvantage of the radial type distribution system.

A: In radial type distribution system, the supply is given from one end that is from one source or…

Q: Application of load flow in power market?

A: There are various applications of load flow. Some of them are mentioned below, It is used to…

Q: What do you think the upsides and downsides of a buck converter system with a duty cycle that can…

A: BJT and MOSFET are the class of transistors used in analog electronics. They are widely used…

Q: 1. The number of devices required to perform the no-load test and the short-circuit test for…

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines…

Q: A. Calculate the frequency of the Fast PWM () when the = 250 kHz and the pre-scalar N=1. If the is…

A: the Atmega microcontroller provides many power management modes to reduce the total consumption of…

Q: Report: In the report comment on the following: - The plot of the obtained VSWR for the matched…

A: Voltage standing wave ratio for a matched load is 1 which define that power is perfectly transmitted…

Q: Explain hybrid operation of wind farms

A: Hybrid operation of wind farms: Any combination of wind energy with another additional form of power…

Q: Describe the growth statistics associated with renewable energy resources.

A: Different energy sources are required in day to day life. Renewable and non-renewable energy sources…

Q: Draw the circuit diagram of Two quadrant chopper which is having average load current might be…

A: Sometimes a chopper may be required to provide a two quadrant operation by retaining the current…

Q: The yearly duration curve of a certain plant can be considered as a straight line from 300 MW to 80…

A: The total installed capacity is, CP=CP1+CP2+CP3CP1=200 MWCP2=CP3=100 MWCP=200+100+100 MWCP=400 MW…

Q: Describe constant and variable frequency operation of chopper control. Describe how duty cycle is…

Q: Explain all components

A: The functioning and purpose of each of the components can be explained as: The bias for the base of…

Q: Why load characteristics goes lower with respect to the occ

Q: What are the advantages of root locus method?

A: The Root locus is define as locus of closed loop pole when system gain K is vary from zero to…

Q: Write factors that affecting the output power of wind turbine.

A: Most of human energy requirement is meet by generating electrical energy. Once electrical energy is…

Q: discuss the behavior of the efficiency output power curve?

A: The output power of the shunt motor varies with the efficiency due to certain parameters like…

Q: The Hellmann formula describes? (a) solar irradiance depending on the thickness of the cloud cover.…

A: The velocity of wind varies with the height above the ground.

Q: A generating plant containing three identical 40 MW generating units is connected to a constant 82…

A: SI No Unit Failure rate Repair time Frequency Duration Failure probability 1 40 MW 3…

Q: Power generation cost reduces as diversity factor decreases and load factor increases diversity…

Q: Draw the equivalent circuits of Class E chopper for the different quadrant operation and write its…

A: The following points should be remembered: 1. Positive Load Current = Current flows from source to…

Q: The figure attached to this question shows the 1 line diagram of a simple three bus power system…

A: Convert the line impedances into admittances, using Y=1/Z

Q: Design a hybrid powertrain which can be run both at series and parallel hybrid operation modes.…

A: A hybrid Powertrain, which can run both in series and parallel hybrid operation modes that includes…

Q: 2. Contribution of load flow studies to erect new power station?

A: A power system is modelled by an electric network and solved for steady state power and voltages at…

Q: 3. Refer to the graphics addendum (C). What is the phase voltage at the Load?

Q: 1- construct a block diagram representation of a typical bulk power generation- transmission…

Q: Optimization: A power line is needed to connect a power station on the shore of a river to an island…

A: Let a×b=50,⇒a=50b…

Q: Draw the circuit diagram of the chopper circuit which is designed by IGBT and used in quadrant 4…

Q: With necessary sketch, Explain the mode of operation of chopper which is turn off due to external…

A: The mode of operation of chopper circuit is turn off due to the external load circuit so it called…

Q: In a long term adequacy based reliability Evaluation for a generation system, if reliability index…

A: This question is from "POWER SYSTEM(GENERATION)".Under which we are going to study how to improve…

Q: Mention Factors determining the size and the direction of the generated emf

A: Factors determining the size and the direction of the generated emf are follows-

Q: What is the capacity factor?

A: Given data: Adam's Bay wind site Wind turbine G80-2000 Pout= 2000kw k=2.05 c=8.35 m/s h=10 m Site…

Q: A synchronous generator.connected to 1.0 per unit voltage infinite bus has 0.8 per unit reactance.…

Q: In ac analysis of transistor biasing circuits, coupling capacitors should be open circuit. True…

A: In DC analysis the coupling capacitors are replace by open circuit. And In AC analysis the coupling…

Q: For the cirouit shown below, draw the d.cA load line and defermine the oferading Point. 530 ka Ic

Q: A coaxial cable with a characteristic impedance of 50 Ohm is used to deliver mi- crowave signal to a…

Q: Suppose a power system consists of two isolated regions: a western region and an eastern region.…

A: When all the units are working properly, the system is complete and the storage area is workingtoo…

Q: (i) A Three phase inverter is connected from 210 V , DC supply and operated in 120 mode. Find the…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Q3: A synchronous generator with peak generated voltage Vg which is connected to a lighting arrester…

A: 1) Peak value of the generated voltage of the synchronous generator= Vg RMS value of the generated…

Q: Derive emf equation of the synchronous generator.

Q: Draw the circuit diagram of Two quadrant chopper which is having average load voltage might be…

A: CHOPPER:- A chopper circuit is any of numerous types of electronic switching devices and circuits…

Q: The expression of Q factor for Schering bridge is given by

A: The expression of the Q factor for schering bridge

Q: Name the component operating with ac power which best compares to the buck chopper.

A: A buck chopper is dc to dc converter which works as steps up and steps down voltage and current…

Q: What does a "matched load" mean?

A: According to guidelines we need to solve only the first question. According to the question we have…

Q: (b) Figure Q2(b) represents a single-line diagram of typical power system with the line impedances…

Q: Assume that, when there is no peak demand in the load curve for some time the load factor is the…

A: Load factor-It is the ratio of the average load to the maximum load in a given period. If the load…

Concept explainers

Electrical Power Generation

In an electric power generator, one type of energy is converted into electrical energy. Power-generating systems are simply a combination of potential or stored energy that is converted to provide kinetic energy, which, in turn, generates electrical energy for use in engines, lighting, heating, and other benefits of modern life.

Question

100%

Draw the circuit diagram of Two quadrant chopper which is having average load current might be positive or negative. Explain each quadrant operation with neat sketch

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Power Station and Its Characteristics

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

a. What is the ampere rating of the circuits that are provided for the small-appliance loads? _____ b. What is the minimum number of small-appliance circuits permitted by the Code? _____ c. How many small-appliance circuits are included in this residence? ____
Draw the circuit diagram of Two quadrant chopper which is having average load voltage might be positive or negative. Explain each quadrant operation with neat sketch.
Which of the following cannot be determined with the help of load flow analysis?a) frequency of busbar voltagesb) active and reactive forcesc) phase angle of busbar voltagesd) loss of strengthe) amplitude of busbar voltages
For type A chopper, dc source voltage = 250 V, load resistance = 10 Ω. Take a voltage excess of 2V across chopper when it is on. For a duty cycle of (0.004*Vs ), calculate (a) average and rms values of output voltage and (b) chopper efficiency.
What is load capacity? What is the load capacity of a typical residential area, a city? What precautions are practiced by electric companies in terms of loading capacity? When is distribution box needed in terms of electrical supply?
Define the harmonic frequency and interharmonic frequency used in power system quality.
• Zh = 100 ohm • Draw the pu reactance diagram by taking Ut(base) = 132kV, St(base) = 100MVA. If the 33 kV busbar voltage is kept constant at 30 kV and 0.8 inductive 50 MVA power is drawn from this bus, what is the voltage at the synchronous machine ends?
Discuss the importance of power delivery components like voltage regulators and capacitors on a motherboard and their impact on system stability and overclocking.
C.Comments on this statement: "PMUs can be used as a protective relays”. D. What is the ZIB and it role in OPP E Is there any effect of existence of HVDC transmission lines in OPP and state estimations? F. Discuss the challenges that might face application of PMUS/WAMs in any given power system.
a) Find the Y-bus power system in rectangular and polar coordinates.b) Specify the type of each bus, and the known/unknown values. c) What is the real and reactive power injections at buses 2 and 3?
What does matched load mean?What happens if the load is not matched?
-) The active and reactive power drawn by the mixer fed from a 230 Vrms, 50 Hz single phase AC network was measured as 600 W and 100 VAR, respectively. According to this information: a) Calculate the apparent power drawn from the network? b) Calculate the current drawn from the network? c) Calculate the cos(a).