(b) A car is travelling in a circular path of radius R with a velocity vo. Itstarts to break with a deceleration ofa = c1+k1 vwhere c1 and k1 are constants. Find|-Breaking time (tbr),(time taken to stop car)Il-Breaking distance (sbr),( distance travelled until car is stopped.III-Relation of normal acceleration with time.All result is to be found in terms of (vo,c1 and k1).

Velocity is the rate of change of displacement so Velocity is the derivative of position with…

Answered: (b) A car is travelling in a circular…

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.19P: Plot the earths gravitational acceleration g(m/s2) against the height h (km) above the surface of...

See similar textbooks

Similar questions

7. If the sports car in problem number 1 is approaching the exit tollgate with a velocity of 100 m/s and decelerates at 5 m/ss to a full stop, find the displacement of the car.
A particle, originally at rest and located at point (3 ft, 2 ft, 5 ft), is subjected to an acceleration a={6ti+12t2k}ft/s2 .
The A-T Curve For A Particle Having A Rectilinear Motion Is Shown In The Figure. At T=0, The Velocity Is 10ft Per Sec. draw v-t and s-t curves, specifying: v5, v8, v10, s5, s8, s10 and highest velocity
At time zero, a particle is at x = 4.0 m and y = 3.0 m and its velocity v is given in diagram H. The particle has a uniform acceleration a of given by the equation in diagram H. What is the object’s position at time t = 4.0 s? SEE ATTACHED DIAGAM WHICH ONE IS CORRECT? A. None of the other answers B. (20, -21) m C. (33, 18) m D. (44, -9.0) m
The motion of a particle is defined by the parametric equations ax =0.8t, ay =2–0.3t, az =5 where “a” is in m/s2 and t in seconds.The particle is at rest and is placed at the origin at t = 0. What is the acceleration of the particle after 10 seconds? What is the velocity of the particle after 10 seconds?
Q1. A driver enters a curved car at 72 km/h, slows down, causing the speed to drop at a steady rate of 4.5 km/h every second. If the radius of curvature is 16.7 m. Find the acceleration of the car after 4 seconds from the driver starting to slow down.
#22 only Find an absolute velocity and acceleration of Particle M at time t=t1 if relative motion of M and rotational motion of body D are given.
The horizontal motion of the plunger and shaft is arrested by the resistance of the attached disk which moves through the oil bath. The velocity of the plunger is v0 = 3.1 m/s in the position A where x = 0 and t = 0, and the deceleration is proportional to v so that a = -kv where k = 0.32 s-1. Find (a) the velocity when t = 2.9 s, (b) the position x when t = 2.9 s, (c) the velocity when x = 4.2 m.
Specifically a dynamics problem: A particle, originally at rest and located at point (3 ft, 2 ft, 5 ft), is subjugated to an acceleration of a = {6ti =12t2k} ft/s2. Determine the particle's position (x, y, z) at t = 1 s.
A projectile is launched at a rate of 4.4 m/s at an angle of 55 . State the projectiles position every 0.1 s starting at t=0 s. keep going until the height of the projectile goes negative. (The shot of Odysseues...)
A particle moves in a circle with a diameter of 120 cm. If its linear velocity is given by v = 4.5t where v is in mps and t is in s, find the radial, tangential and the resultant acceleration of the particle.
The elevator in an office building, starting from rest at the first floor, is accelerated 0.75 m/sec2 for 5 secs. It continues at constant velocity for 12 secs, more and is then stopped in 3 secs with constant deceleration. If the floors are 3.75 m apart, at what floor did the elevator stop?

SEE MORE QUESTIONS

Recommended textbooks for you

International Edition---engineering Mechanics: St…

Mechanical Engineering

ISBN:

9781305501607

Author:

Andrew Pytel And Jaan Kiusalaas

Publisher:

CENGAGE L