B/ Describe briefly the main component of the microcomputer.
Q: (a). F = y³ ax + xyay - zaz (b). F = x² ax + 2zay - yaz
A: Curl of two vector field is calculated by taking the cross products of the two vectors , curl is…
Q: Example plot the polar plot- G(s) = 100 (5+2) (5+4) (5+8)
A:
Q: 4. The open-loop transfer function of a system is given by, 10 (s+3) (s+5) (s-1) (s² + 4s+8) (a)…
A: Brief description : Here we need to calculate range of K for which system is stable. By using…
Q: A 3-ph balance express feeder has an impedance of (6+j20)/ph. At the UP load end, the line-to-line…
A: Given data, Impedance of per phase Zph=6+j20 Ω/ph Line voltage VL=13.8 KV Absorbed power P = 1200 KW…
Q: The load on a 120-V, 60 Hz supply is 5KW (resistive), 8 KVAR (inductive), and 2 KVAR (capacitive).…
A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…
Q: at D2. All W/L values are 2/1; K'n = 60 uA/V2,VT O = 0.7 V, y = 0.5 V1/2, and 20F = 0.6 V. Find i1…
A: Given: The following circuit is a memory cell with 0 V initially stored at D1 and 3 V at D2. All W/L…
Q: V 260° Load 1 Load 2 5. For the system of Fig. 19.44: a. Find PT. Qr. and ST. b. Find the power…
A:
Q: 4. What are types of SPIM.
A: SPIM stands for Single Phase Induction Motor. These are simple motors which operates on single phase…
Q: Consider an n*-poly-Si-gated n-MOSFET
A: MOSFET (Metal–oxide–semiconductor field-effect transistor)- It is a type if transistor which is…
Q: For an FM modulator
A: Frequency modulation- When modulation is done by taking frequency of information signal modulated…
Q: What is the largest number that can be represented using eight bits? a) In decimal system b) In…
A: 8-bits 8-bit is a computer information measurement that was commonly used to refer to hardware and…
Q: Q4) (a) Sketch the amplitude spectrum and the psd of the waveform shown in figure below Include at…
A: Signal component amplitude spectrum is defined as a function of component frequency. The phase…
Q: find the value of ZT. 8Ω -j12 Ω ΜΗ -j16Ω 4 20 Ω 10 Ω ww j15 Ω -j16 Ω ZT 10 Ω 10 Ω
A: To calculate equivalent impedance ZT
Q: What is the value of KR for a CMOS inverter in which (W/L) N =2(W/L) P?? Calculate the noise margins…
A: CMOS is an onboard, semiconductor chip that runs on batteries inside computers that store…
Q: Identify the given statement. FM and PM demodulators can actually reduce noise and increase the…
A: FM and is the frequency modulation and PM is the phase modulation In FM amplitude and phase remain…
Q: Q. The input for any circuit at lab experiments are O B. the switches OD. None of the above O C.…
A: While performing the experiments in Laboratory, the inputs is given at one terminal and switches and…
Q: Calculate the value of Zab in the network j6 Ω -j9 Ω α. -j9 Ω bo j6 Ω j6 Ω 20 Ω ww 20 Ω -j9 Ω 10 Ω
A:
Q: Q2) show that: X(0)8(f) a) Stx(t)dt → + x(f) 2π]f 2 b) if x(t) = x(-t) (even symmetery) then all the…
A: Given data, a). ∫-∞tX(t)dt = X(f)2πjf+X(0)δ(f)2. b). if X(t) = X(-t) (even symmetery)then all sin…
Q: Explain the steps that are required to use an ideal transformer in order to match a 500 ohn load…
A: Solution- Let, Where Vs = source voltage Zs = source impedance ZL = load…
Q: The ac bridge shown in Fig. 9.84 is known as a Maxwell bridge and is used for accurate measurement…
A:
Q: Calculate the average propagation delay of the reference inverter shown below, assuming Kn=100uA/V2,…
A: The given circuit diagram is shown below: It is given that: Kn=100 μA/V2VTN=0.6 V
Q: A shunt voltage regulator is shown below. Calculate the output voltage that the load will see. out…
A:
Q: For the circuit of fig: a. Find the total admittance Y₁ in polar form. b. Find the value of C in…
A: Solve first three sub-parts in a multiple sub-part question, unless the student has asked for…
Q: In the dc-dc buck converter shown in the figure, Vin= 100 V and L = 0.5 mH. The duty cycle of the…
A: Assume that the inductor current is continuous.When the inductor current is continuous,…
Q: 19. During short-circuit test, the iron loss of a transformer is negligible because (a) the entire…
A: As per bartleby guideline for more than three MCQ only first three are answered please upload the…
Q: 4) Draw a logic diagram of a divide-by-14 counter using IC 7493 and 2-input AND gate.
A: Circuit diagram of inside the IC 7493 is as shown below:
Q: Why is proper grounding important?
A: Ground potential: Ground potential has zero reference level used in a system to measure and apply…
Q: Example sketch polar plot for the System having G (S) H (₂) = 10 (5+2)(5+4)
A:
Q: = For E-MOSFET gives Ip(on)= 500mA (minimum) at VGS 10V and VGS(th) Determine the drain current for…
A:
Q: Q2. Discuss mathematically the force system and equilibrium system?
A: Force system : : A force system system is collection of different forces which acts at the same…
Q: 37. If the impedance triangles of two transformers operating in parallel are not identical in shape…
A: The Standard parallel operation of transformer can be done if the following conditions are…
Q: Q3) A rectangular waveguide has dimensions a = 6 cm and b = 4 cm. (a) Over what range of frequencies…
A: Consider the dimensions are. a=6 cm b=4 cm
Q: For a full wave controlled rectifier with pure resistive load (R=1002),the supply voltage is…
A: Given: A full wave controlled rectifier with, Pure resistive load, R=10 Ω Supply voltage, Vs=50 sin…
Q: Determine the width (in eV) of a forbidden energy band & also Determine the width of the forbidden…
A: Forbidden energy is the other name for bandgap ist the energy difference between the two-level of…
Q: The maximum peak frequency deviation divided by the maximum frequency gives the worst-case…
A: Frequency deviation is the worst case modulation index is equal to maximum peak frequency deviation…
Q: What is the effect of increasing the source resistance RS on the voltage gain of the ?amplifier…
A:
Q: A system that behaves like x[2n-2] at the output, when a signal is input input x[n], is shown on the…
A: The output will be sinx (T-t) if the system is sent through the time delay first, then via the…
Q: What is the purpose of a Ground Fault Circuit Interrupter (GFCI) ? Why is it important?
A: Ground Fault Circuit Interrupter is a circuit breaker which acts very quickly. For a ground fault it…
Q: a. Using Gauss' law, find an expression for the magnitude of the electric field E in the pipe as a…
A: The link between surface charge density and electric field strength is used to find an expression…
Q: b) A fault occurs at bus 4 of the network shown in Figure Q3. Pre-fault nodal voltages throughout…
A: POWER SYSTEM: A power system is a network of electrical components that provide, transmit, and…
Q: A 1-ph transformer 25kVA, 330 10V, 50Hz, Req2 = 0.04592 and Xeq2 = 0.06592 draw the Kapp regulation…
A: Single Phase Transformer: A single phase transformer is an electrical device that accepts…
Q: A PM transmitter produces a maximum
A: Phase modulation-When modulation is done by taking phase of information signal modulated and…
Q: 2) For the IC 7495 used in item two of this experiment, what is the difference in operation between…
A: Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: B. In a series of tests to determine the parameters of an eight pole, three-phase 3300 V, 50 Hz, 500…
A: As per Bartleby policy we can answer only three subparts at a time. So I am solving first three for…
Q: 31. The all-day efficiency of a transformer depends primarily on (a) its copper loss (b) the amount…
A: As per bartleby guideline for more than three mcq asked only first three are to be answered please…
Q: the electron and hole mobilities in silicon at 320 K are 0.13 and 0.029, and assuming hole and…
A:
Q: *10. A moving particle encounters an external electric field that de- creases its kinetic energy…
A: Work done (W) on a motional charge is equals to kinetic energy Change in KE is equals to work done…
Q: // For the circuit shown Plot curve between V and I When voltage variable Vin 0.1 0.2 0.3 0.7 0.8…
A:
Q: Vi Solve for VCB and VCE. 10 μF + '47 ΚΩ B 10 ΚΩ 18 V ' 2.4 ΚΩ C ΦΕ 10 με 16 + Vc β=120 1.1 ΚΩ Vo
A:
Q: OV- 15 V - 15 V 13V 15 V ---|---· - 15 V
A:
Step by step
Solved in 2 steps
- What is load-line analysis? How does it help? Explain.A DC bus connected to a three-phase inverter is rated at 800V and the output voltage produced by the inverter has an rms value of 240 V. What is the modulation index? ...Write a VHDL code for 4:1 multiplexer using conditional concurrent signal assignment
- Describe clearly the working of Super heterodyne receiver with a neat sketch and also write down the advantages of it.A PCM system is used to transmit base4 signal of 512 level, the input signal works in the range between (30 to 70) MHz. Find the bit rate and signal to noise ratio in dB? Note that: the step size is considered to be double of system levels? *How do VLSI (Very Large Scale Integration) techniques contribute to the development of more powerful microchips?
- What are the minimum and maximum code step widths as shown What are the differential and integral linearity errors for this ADC based on the dashed line in the figure?Write a short note on quadrature amplitude modulation(QAM) and briefly identify its advantages over other modulation scheme/methods?Consider two microprocessors having 8-bit and 16-bit wide external data buses, respectfully. The two processors are identical otherwise and their bus cycles are the same speed. Suppose all instructions and operands are two Bytes. By what factor do the maximum data transfer rates vary? Suppose all instructions and operands are one Byte. By what factor do the maximum data transfer rates vary? Discuss your answers.