b) Describe component X 6.0v heater i. 6 The heater is designed to work from a 3.6 V supply. It has a power rating of 4.5 W at this voltage. By considering the current in the heater, calculate the resistance of component X when there is the correct potential difference across the heater.

b) Describe component X 6.0v heater i. 6 The heater is designed to work from a 3.6 V supply. It has a power rating of 4.5 W at this voltage. By considering the current in the heater, calculate the resistance of component X when there is the correct potential difference across the heater.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: A three phase 6 pole 50 Hz induction motor is running at 5% slip. What is the speed of the motor?

A: Given, A 3-phase induction motor has, Number of pole, P = 6 Motor frequency, f = 50 Hz Slip, s = 5 %

Q: F25/A +0.372

A: In the following section the addition of F25/A and 0.372 have been performed.

Q: 5. Find the transfer function, H(z) in z-domain. x [n] – y[n] D + E X -1/2 2 X D 1/3 X

Q: 45. A circuit has an impedance of (1-i 2) Q. The Susceptance of circuit is (i) 0.1 S (ii) 0.2 S…

Q: These are the reason why there are so many navigational instruments and equipment onboard the…

A: Instruments used in aircraft Vertical speed indicator Altitude indicator Turn indicator Airspeed…

Q: For the JFET amplifier circuit of Fig. 18-7, determine the lower- and higher-cutoff frequencies and…

A: The frequency response of the amplifier circuit can be obtained by using DC and AC analysis.

Q: The resistance is proportional to length and inversely proportional to material given. of the O…

A: Considering the formula for resistance of wire, R=ρLA Where, R is resistance, ρ is the resistivity…

Q: 45. A circuit has an impedance of (1-i 2) Q. The Susceptance of circuit is (i) 0.1 S (ii) 0.2 S (ii)…

Q: You are given the following circuit. Assume that V1 = 5.4 V, V2 = 5.8 V, V3 = 5.2 v, V4 = 4.5 V, V5…

A: In this question, We need to determine the Voltage Vn ? We are solving this problem using the…

Q: Power amplifier delivers 3.6 W of power to a load. The input signal power was 200 mW. What is the…

A: Given: In a power amplifier Output power, P0=3.6 W Input power, Pin=200 mW

Q: A PI current control is developed for a de machine based on pole zero cancelation. The following…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 2. Determine the core area, the number of turns and pos the tapping point for a 500-kVA, 50-Hz,…

A: In this question auto transformer is given....We have to find out core area , no of turns and…

Q: Illustrate a state diagram for a counter that continuously counts from 0 to 5 and goes back to 0…

Q: 10 V 6V Find i Select one: O a. 0.333 A O b. 0.666 A O c. -2.666 A O d. -0.333 A O e. -0.666 A

A: Given,

Q: Design a multi range ammeter to give the following ranges 100mA, 1A, 5A, and 5OA. If d'Arsonval…

Q: Determine the voltage gain Gv = V2/V1 for the following circuit 因-图 10 2 V, = 1V

Q: Find the solution of the following operation for hexadecimal numbers F25/A +0.372 O None of them O…

A: Here we have to perform arithmetic operation of hexadecimal number and decimal number and then…

Q: Problem [8] Find the Thevenin impedance of the circuits at its output terminals. -j2 2 10 Ω + V.…

Q: If a current pass through an inductive, .magnetic energy will store in the coil True False

A: Inductors are used to store energy in form of magnetic field. When current is passed through the…

Q: motor takes a current of 10 A when supplied from a 250 V a.c. supply. Assuming a power factor of…

Q: (d) A non-liner load is connected to a 110 V, 50 Hz power supply. Determine whether the current of…

A: It is given that: V=110Vf=50Hzharmonic=3rd

Q: A 4.7 Micro-Farad capacitor is in series with a 470 K-Ohm resistor with a 12V power supply. How long…

Q: 3. Full Wave Center Tapped Rectifier a. Determine V, and the required PIV rating of each diode for…

Q: Current can not flow through an insulator because they have O a. free electrons O b. no free protons…

A: The electrons in the insulator's atoms are tightly bound, which means they don't have any free…

Q: Find Transfer function frequency response , magnitude, phase 1- y(n) = x(n) – 2x(n-1) + x(n-2)

A: Since you have posted multiple questions, we will solve the first question for you. If you require…

Q: Determine the transfer function, Xo(s) | Xi(s) for the mechanical system below: Dashpot Spring k1…

A: Fig: Given mechanical system Write the state space equation for given system at equilibrium…

Q: In a digital voltmeter, the oscillator frequency is 400 kHz. A ramp voltage to be measured by this…

A: It is given that: f=400 kHzTw=20 ms

Q: Q1: A) A 30, 3 wires T.L system work by 380 KV between lines to supply load with lagging power…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: 1. A 5-kVA, 110/110-V, single-phase, 50-Hz transformer has full-load efficiency of 95% and an iron…

A: Given:5 kVA, 110-110V, single phase, 50 Hz transformer,full load efficiency of 95%, Iron loss,…

Q: The only instrument among the followings that is normally not connected to the aircraft electrical…

A: Types of instruments in aircraft TCAS (Traffic collision avoidance system) GPS (Global Positioning…

Q: Full the following blank (1110)Gray + (11010000)2- (11001101)Ex-3 = ( )16 %| O -17 O +11 O +69 O -14…

A: In this question, We need to choose the correct options What is output of the given function?

Q: These instruments help aircraft avoid collision with other aircraft. * Magnetic compass ILS DME TCAS…

A: We need to answer which of the given instrument helps aircraft to avoid collision with other…

Q: z-transform of the sequence : y(n)=2.5u(n)-1.5u(n

A: In this question, we will find z transform of given sequence...

Q: From the given circuit, determine v, for all time interval when Vs = 30 [u(-t) + u(t - to)] V to =…

A: In this question, We need to determine the voltage across the capacitor as shown in the circuit VC…

Q: What value of input resistance is needed in the given circuit to produce the given output voltag R;…

Q: Find the current I, in this circuit. 3/0° A j8 Q

Q: RL: 2(3): ketch RL for the system below, and find the value of K that make the system table: K(s +…

A: In this question, We need to determine the sketch for the Routh locus. Find the value of K ?

Q: If an AC sine wave has a peak voltage of 338 V, what is the RMS and Average voltage of the signal? O…

A: Given data, An AC sine wave has a Peak voltage, Vm=338 V

Q: Why we need to use the split way in distribution panel boards?

A: The split way is used in the distribution panelboard in order to split the incoming supply into…

Q: A fault current limiter as shown in the figure, has L1 = 1 mH and a total impedance of j10 Q. If the…

A: The given circuit is as shown below,

Q: 5.47 The transistor in the circuit of Fig. P5.47 has k, = 0.4 mA/V², V, ation at the edge of…

A: We need to prove tha given equation for saturation region

Q: Two 3-phase 416ov,60 Hz alternator are operated in parallel. The total load of the system is 1050W…

Q: Consider the plant: 20 G(s) = (s +2)(s+10) What is the shortest 2% settling time that you can…

A: Given data, Transfer function of plant Gs=20s+2s+10

Q: -. Determine z- transform. Sketch pole-zero plot. Indicate ROC. x[n] = 2" u[-n] + (1/4)" u[n-1] %3D

Q: A semiconductor material has electron and hole mobilities ua and µ, respectively. When the…

A: We need to find out conductivity of given semiconductor

Q: Exercises: 1. For the common-drain (source-follower) configuration of Fig. 16-18, determine the…

Q: Calculate the daily efficiency of a single-phase transformer with an output capacity of 350 kVA at…

A: Given,Output=350 kVA full loadCopper loss=3.2 kW full loadCore loss=4.2 kW any loadNow core loss…

Q: 3. Find the equivalent resistor for the figure below. Write which one is in series or parallel. 20 2…

A: Given circuit:

Q: , the capacitive reactance value is and the When the frequency is inductive reactance value is O a)…

A: The capacitive reactance is XC=1jωC=1j2πfCXC∝1f The inductive reactance, XL=jωL=j2πfLXL∝f

Q: -8V R=D1.2k2 +12V R2= 2-5k2 Silicon diode रिह Construct the circuit in more eatay way and kindly…

A: In this question, We need to determine the diode current and voltage as shown in the circuit?

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

b)
Describe component X
6.0V
heator
i.
The heater is designed to work from a 3.6 V supply. It has a power rating of 4.5 W at this
voltage.
By considering the current in the heater, calculate the resistance of component X when there
is the correct potential difference across the heater.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A series circuit conducting of a 30-uf capacitor and a 0.155-henry inductor is connected to a 120-volt 60-cycle source. If a variable inductor is substitute instead, what should be its value if an equal current is to lag behind the voltage? Assume all other conditions remain unchanged
Using a simple series circuit with a capacitor of capacitance C and a resistor, R connected across a battery pack with total voltage V, derive the equation governing the capacitor's voltage response (charging cycle).
how to do the resizing of elements for the design of a PIEZOELECTRIC TILE PROTOTYPE FOR THE GENERATION OF ELECTRIC ENERGY THROUGH FOOTPASS TRAFFIC
It is required to grade a string having seven suspension insulators. If the pin to earth capacitance are all equal to C, determine the line to pin capacitance that would give the same voltage across each insulator (C1, C2, …….C6) of the string.
Describe the voltage across and the current through the inductor combination in both charging and discharging phases. Calculate the total capacitance and inductance of the circuits and verify your results by simulating the circuit.
If the same meter movement from no.1 is to be used in an Ayrton shunt arrangement, find the required resistances for 1 A, 500 mA and 100 mA ranges. (Given in no.1:A 500-Ω shunt resistance was connected to a 5-mA meter movement to form a 25-mA single range DC ammeter.)
A string of 8 suspension insulators is to be fitted with a grading ring. If the pin to earth capacitances are all equal to C, find the values of line to pin capacitances that would give a uniform voltage distribution over the string.
5. Discuss why d. It is necessary to use the geometric means radius in the formula for the inductance calculation whereas the formula for the capacitance calculation uses the actual radius.
A series circuit consisting of 10 ohm resistance and 40 µfarad capacitance is connected to a 220-volt, 60-hertz source. Determine the voltage drop across the capacitor.
Subject: Electronics Engineering Solve no 6
An inductive coil with resistance R and inductance L is connected in parallel with a 40-ohm resistance. The combination then is connected across a 50Hz source. If the currents in the coil and the 40-ohm resistor are 7∟-53 A and 5 A respectively. What is the inductance of the coil?
>Rank these 3 materials by increasing relative permittivity : Air, Glass, Hard Rubber. ____, ____, ____. >If capacitor has a code of 453D,the nominal value is ____. >The same capacitor has a tolerance of ____. >The time between when a capacitor is fully discharged to when it is fully charged is called the ____time. >Define pole ____and throw ____.