-b: Draw one line ladder diagram to construct 3 input OR gate.

Q: gate represents the Sum of a Half adder XOR O b. NAND С. NOR O d. XNOR

A: According to the question we have to discuss half adder.

Q: y= Ca XNOR b) using a two level नि as use inputs to the OR gates OR-AND ret wenk

A: To design the 2-level OR-AND logic circuit, convert the function in Product of Sum (POS) form. In…

Q: poles ying unit step input, gain of 34. IA hes has system yotem has of yce) and if at ー4 - b. the…

A:

Q: In SCR operation, internal regeneration between the transistor model is takes place on the following…

A: In SCR Operation, internal regeneration takes place when

Q: Convert the following number from Excess 3 code to binary code: 1100

A: Excess 3 code is a non-weighted binary code. It can be obtained by adding the binary equivalent of…

Q: Keep the Diagram neat. Thanks Build a 4*16 decoder using only 2*4 decoders

A: In the given questions we need to find that hiw many 2*4 decoder required to design 4*16 decoder.

Q: (B)- Identify the addressing mode for the following instructions then compute the physical address…

A: Given 1. LDS [FFH], SI 2. MOV [BP-11H], BL

Q: Duty: design a hand counter according to the following order from left to right 4, 5, 0, 1, 3, 7…

A: SEQUENTIAL LOGIC CIRCUITS: Sequential Logic circuits, unlike Combinational Logic circuits, have some…

Q: Draw circuit y=(a+b) (c+d) only using NOR gate

A:

Q: Part II. Write Verilog Code for 3 inputs. Verify your code using test bench A. OR gate B. AND gate…

A: // Code your design heremodule or_gate(A,B,Z);  input A,B;  output reg Z;  assign Z = A|B;endmodule…

Q: Please calculate each of the circuit parameters for the provided circuit

A:

Q: A B 0 0 C O D D 8 U X

A:

Q: (b) Compare and contrast Memory-mapped I/O and I/O mapped I/O.

A: Memory Mapped Input Output − A memory address should be assigned to an input/output…

Q: design monostable multivibrator using multisim by using 555 timer IC and also by using transistor

A:

Q: transistor works as an oscillator

A: 1) Transistor as an amplifier: A transistor acts as an amplifier by raising the strength of a weak…

Q: Q14. For the parallel adder in Figure 01, determine the complete sum by analysis of the logical…

A:

Q: For the given circuit of Si transistor, B=200, findVce- 5V 1KO 2K2

A: By looking into the transistor the transistor is NPN transistor since the transistor is not biased…

Q: Compute for Ib, Ic, Ie

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Q1:What's the type logical circuit shown in figure, and find the minimum B of transistor to verify…

A: Consider the any of the input voltage is applied to the ground, the diode corresponding to the input…

Q: 8:3 encoder using 4:2 encoder

A: Encoder  An encoder is a combinational circuit that produces a one-hot to binary converter., an…

Q: The question is to build 8:3 encoder using 2:1 encoder?

A:

Q: Not yet answered Question 4 Marked out of 4.00 Which gate has its output equal O if and only if both…

A: In AND gate output is zero except in case of both the inputs are 1.

Q: 1. What is a bridge circuit?

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: If a-current gain of a transistor is o.98. What is the value of B-current gain of the transistor? A…

A: Given: Current gain α=0.98

Q: Define Kirchoff’s Law in your own words with use of suitable equestion/s ans give one example of its…

A: Kirchhoff's Laws Kirchhoff's Current Law (KCL) It states that in any electrical network, the…

Q: Find all voltages and currents in the transistor in the given circuit V = --5.7V, V2= 5V, R = 10KN…

A: BJT(Bipolar Junction Transistor)- BJT has a three-terminal device emitter, base, and…

Q: b) Find IB, IC, IE, VB and V. in Figure 1 where ßdc is 50. Assume that the transistor is of silicon…

A:

Q: Vcc mine Avs, Ai, Z; and Zo if hie-1k2 and he=100 for the two transistors. 8k 31000 10k T2 Vs 5000

A:

Q: Write the output of each XNOR gate and determine the Sum and Carry output of parallel adder. AB C AB…

A: The symbol for XNOR gate is given as:-  The truth table for XNOR gate is given by  Here we can see…

Q: NOR gate is equivalent to a negative AND Select one: O True O False

A:

Q: true or false: transistors take up less space than tubes and they count faster.

A: Transistor: "A transistor is a device that functions as a switch or gate for electrical signals and…

Q: The minimum 4- bit Carry save Adders using to add 6- numbers (6- bit) are O 8 CSA 4 CSA O 6 CSA O…

A: To add n numbers of m bit using Carry save adder then required CSA are n-2

Q: Identify the addressing mode for the following instructions then compute the physical address for a…

A: Addressing mode is a method of defining a data to be utilized by an instruction. From the addressing…

Q: 4-input AND gate.

A:

Q: The rating of MCB used for socket circuit is O 30A O 15A O 20A O 6A

A:

Q: The parameters of the transistor shown in figure 3 are kn =0.5 mAV²/, VTN=1.2 V. The gate to source…

A:

Q: 5. (а) Explain what a d.c. bridge circuit is and why it is so useful in measurement systems.

A: Given: DC bridge circuit

Q: In string addressing mode, if the EA is stored in DI, then the PA will be calculated using the BA…

A:

Q: 2. Identify the correct combinational circuit in the following analogy. Consider a four-room…

A:

Q: Design a 4:1 Mux that will give high output for 2 and 4

A: to design a 4:1 Mux that will give high output for 2 and 4

Q: A JFET produces gate current of 1.5nA when gate is reverse biased with 6V. Calculate the value of…

A: JFET  Gate reverse current 1.5nA Gate Voltage = 6V Resistance?

Q: Which of the following gate will return a 1 only if both the inputs are same? O a. EX-NOR O b. AND…

A:

Q: c) Check the below statements and state whether these statements are true or False. Justify your…

A: JFET  is voltage or current control device?  Input Impedance of FET?  Gate current in FET?

Q: Interface an input port 74LS245 to read the status of switches SW1 to SW8. The switches when shorted…

A:

Q: Determine The branch current of ?? , Ia , and Ic

A:

Q: By Using de Morgan's law show the bubbling and changes that happen to convert the circuit (A•B•C)…

A:

Q: According to the following gate design, find value of (z). O z = (x)' O z =x O z = y' O z = x'

A: Given gate is a NOT gate. Which will complement the input.

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.