b) Each cylinder in a four-cylinder car engine has a bore diameter of 55.20 mm and the stroke for each piston is 127.50 mm. Calculate the cubic capacity of the engine in in cubic centimetres (cm³) and give your answer to two decimal places. c) For the engine mentioned in (b), the compression ratio, r, is 4.45 for the engine in, calculate the clearance volume per cylinder in in cubic centimetres (cm³) and give your answer to two decimal places.

b) Each cylinder in a four-cylinder car engine has a bore diameter of 55.20 mm and the stroke for each piston is 127.50 mm. Calculate the cubic capacity of the engine in in cubic centimetres (cm³) and give your answer to two decimal places. c) For the engine mentioned in (b), the compression ratio, r, is 4.45 for the engine in, calculate the clearance volume per cylinder in in cubic centimetres (cm³) and give your answer to two decimal places.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter1: Units And Measurement

Section: Chapter Questions

Problem 87AP: A car engine moves a piston with a circular cross-section of 73000.002cm in diameter a distance of...

See similar textbooks

Similar questions

The inside volume of a house is equivalent to that of a rectangular solid 13.0 m wide by 200 m long by 2.75 m high. The house is heated by a forced air gas heater. The main uptake air duct of heater is 0.300 m in diameter. What is the average speed of the duct if it carries a volume equal to that of the house’s interior every 15 minutes?
Verigy that the SI of hpg is N/m2.
A 75.0-kg floats in freshwater 3.00% of his volume above water when his are empty, and 5.00% of his volume above water when his lungs are full. Calculate the volume of air inhales—called his lung capacity—in liters. (b) Does lung volume seem reasonable?
An airtight dispenser for drinking water is 25 cm × 10 cm in horizontal dimensions and 20 cm tall. It has a tap of negligible volume that opens at the level of the bottom of the dispenser. Initially, it contains Water to a level 3.0 cm from the top and air at the ambient pressure, 1.00 atm, from there to the top. When the tap is opened, water will flow out until the gauge pressure at the bottom of dispenser, and thus at the opening of the tap, is 0. What volume of water flows out? Assume the temperature is constant, the dispenser is perfectly rigid, and the water has a constant density of 1000 kg/m3.
A fluid of a constant density flows through a reduction in a pipe. Find an equation for be change in pressure, in terms of v1, A2, A2, and the density.
Check Your Understanding Liquids and solids have densities on the order of 1000 greater than gases. Explain how this implies that the distances between molecules in gases are on the order of 10 times greater than the size of their molecules.
Assume that a raindrop has a volume of 0.05 cm^3 and you need an Avogadro's number of raindrops to fill up the cubic water tank. What is the length of the edge of the tank?
Derive the relation between the density of air at STP and the density of air in a laboratory: ρs= ρL (Ps/PL)(TL/TS)
A rocket engine shoots exhaust gas at 5.0 EH PA of gas pressure through a nozzle who's area is 0.3 M to what is the fourth pushing the rocket forward?
Assume patm = 1.00 atm....what is the gas pressure pgas? express answer in pascals to three sig figures...
An airplane has a mass of 1.7 x 106kg and the air flows past the lower surface of the wings at 95 m/s. If the wings have a surface area of 1200m2 how fast must the air flow over the upper surface of the wing if the plane is to stayin the air?
If a piston pushes on a cylinder of gas with a force of 2750 Newtons through a stroke of 4.00 cm, how much work did it do? Remember, the metric unit of work is a Joule.