B/ Explain with the aid of drawing and equations the method of square low device carrier recovery

Q: Problem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is…

A:

Q: rom the given circuit, take V₁ = 240, Z₁ = 20 - j3 ohms. Find the phase currents and line urrents.…

A: The given three phase system is balance. So we can analyse the circuit by per phase analysis.

Q: the following blanks (1101 1010) BCD(5211) = ( )BCD(3321)=( ( )16

A: Code convertors- These code converters are used for conversion of one type of binary code to…

Q: 3. Calculate the dc bias currents and voltages for the circuit of Fig. 5.89 to provide Vo at…

A: BJT: It is a three-terminal semiconductor device. it is used for switching and amplifying the gain…

Q: Q2) Determine the branch currents in the network bellow using Kirchhoff's voltage law. B D E 10 U

A:

Q: (2-b) Is the transistor in the active region? Explain thoroughly.

A:

Q: A three phase 69-KV short transmission line delivers 55 MVA at 0.82 lagging power factor at 64KV.…

A:

Q: Find Lx and Rx for the Maxwell Bridge circuit if that is balanced for R₁ = 50 kn, R₂ = 8.2 kn, R3 =…

A: In this question we need to find the value of Lx and Rx for the given Maxwell bridge circuit.

Q: force FR

A:

Q: A 2-pole, 50 Hz induction motor has an emf in the rotor the frequency of which is 2 Hz. Determine…

A: For induction motor rator frequency = slip × stator frequency.  From above , slip = rotor frequency/…

Q: Explain amplifier characteristics and how the practical characteristics differ from the ideal…

A: Two distinct questions are here.  In the first question, the ideal amplifier characteristics need to…

Q: Q3) Choose the correct answer 1) The value normally stated when referring to alternating currents…

A: AC current is nothin but alternating current which varies continously with time period it has…

Q: Q3/ Design a counter which count the following sequence 2, 3, 5, 7, 6, 4, 14, 0, 11, 15 using T…

A: The required counter can be designed by using four T flipflops and the design can be obtained by…

Q: For the network, determine: a. IB. b. Ic. c. VCE. d. Vc. - 16 V 9.1 ΚΩ 12 ΚΩ Vce c + VCE B = 80 15…

A: BJT is a current controlled Device in which base current control the mode of operation of BJT.  Mode…

Q: The slip-ring rotor resistance and standstill reactance per phase of a 3300 V, 24-pole, 50 Hz,…

A:

Q: (2-1) Assuming that the output is feeding a 20-k2 resistor, determine the total voltage gain and…

A: Given the circuit, as shown below: Assuming that the output is feeding a 20 kΩ, we need to…

Q: A 15-kVA 8000/230-V distribution transformer has an impedance referred to the prima of 80+ j3000.…

A: a. The turns ratio of the transformer is determined as a=8000230=34.78 The load impedance referred…

Q: Three identical capacitance, each of 150 microfarad, are connected in delta. The value of…

A: Given three identical capacitance, each of 150 microfarad, are connected in delta. here we have to…

Q: If the output of a differentiator op-amp is -cos(wt) then the input is a. -sin (wt) O b. cos (wt) c.…

A:

Q: Q1- The response of the control system subjected to unit step in t- domain is given by c(t)=1-9e…

A: Steady state error - The deviation of the output of control system from desired response during…

Q: The voltage at the node (between feedback resistance and in capacitor) of a differentaitor cir is O…

A: In this question we will write about differentiator opamp....

Q: power syste unit quantities instead of actual values. Give the advantages of using such a system.…

A: (a) Advantages Of Per-unit System- It gives a clear idea of relative magnitudes of various…

Q: Q6) Determine how much the Q-point for the circuit shown in figure (4) will change if Po increase…

A: The given circuit diagram is shown below:

Q: 1. Determine the output voltage Vout. 1542 www 552 www 10 V Hilt 25 V 80 2502 ww IDEAL Vout

A: For ideal opamp voltage at the inverting terminal is same as voltage at non inverting terminal and…

Q: ME. 1. A rectangular surface with dimensions 0.6x0.9 meters is oriented with its normal unit vector…

A:

Q: Activity 2: The amplifier circuit below has a single ac input and two ac outputs. Assuming…

A: For the above given question we need to calculate the value of Q point of the given transistor.

Q: Calculate the total gain of a cascaded conficguration 200, and -5. O a. 1000 O b. -100 O c. 100 O d.…

A:

Q: Example: consider the open-loop T.F GH(S) =1/S(S+2). Design PD - controller such that time constant…

A: Given open loop transfer function, GHs=1ss+2 Time constant, τ=0.5 s Damping ration, ζ'=0.707

Q: 4/ The Output of function F is:

A: The output of the multiplexer is based on the value of the selection line. The multiplexer uses 4…

Q: قلته S) r the circuit in Fig.4, find: a) equation of v(t) for t> 0 sec. als 200 b) Sketch v(t) for 0…

A:

Q: solution f= - look = ग्र 20J L Ceg Ceq = 25.35nf How did he get the value inside the circle - 271 -3…

A: For the given explanation : f=12πLCeq100 KHz=12π0.1×10-3CeqthenCeq=25.35 nF Here I have to explain…

Q: (a) Sketch the energy band diagram of the pn junction when a reverse-bias voltage is applied. [Hint:…

A: The energy band diagram in reverse bias condition is shown in the below steps along with the reason…

Q: Co 1(t) Lo 1(t) L L C C ~Vin(t) jºjº (2) Vin(t) R R 3R 3R Circuit A Circuit B Let us consider 2…

A: "According to the Company's policy, we will solve only for the first circuit". Given the circuit, as…

Q: Given a summing amplifier with the following parameters: R1=47 kOhms, R2=12 kOhms, Rf = 470kOhms,…

A:

Q: Design 2-bit synchronous sequential circuit that can-do counting for the following 2-bit input state…

A: Given data: Here a 2 bit counter needs to be designed where present states and next states are…

Q: ME. 2. A positive point charge q = 3μC is surrounded by a sphere with radius 0.2m centered on the…

A:

Q: 1.) Explain the basic operation of a solar cell including the short circuit current and the open…

A: 1. The basic operation of solar cell is shown below. Solar cells convert light energy into…

Q: 3D Problem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is…

A: For the above given question by drawing the cascade configuration of the operational amplifiers we…

Q: V (t) lo(t) 1 OHM 1 H 1ohm R M Vo(t)

A:

Q: A three-phase transposed line is composed of three conductor bundle. The conductors have a diameter…

A: Given A three phase transposed line with its parameters.we need to determine Geometrical mean…

Q: Q3) Choose the correct answer (answer only ten) 1) The value normally stated when referring to…

A: I am giving answer of first 4 questions as per answering guildlines.

Q: three-phase, 60 Hz transmission line has an inductance of 1.378 mH per Km per phase and a…

A: In this question , we will find phase constant , surge impedance and wavelength of lossless line...…

Q: (Α) 157 μΑ. (Β) 136 μΑ. (C) 0.147 mA. (D) 98.0 μA. (E) 0.176 mA. &₁ I₁ www R₁ R₂

A: In this question we need to find a current passing through R2 resistor.

Q: 1) The equivalent resistance when a resistor of 1/3 2 is connected in parallel with a 1/4 2…

A:

Q: 3G Problem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is…

A:

Q: Draw  and explain the schematic of a a DC power supply with 2 variable channels and 1 constant 5V…

A: An LM317 T is an three terminal device which can change the DC voltages to different levels. There…

Q: C/ Design 2-bit synchronous sequential circuit that can-do counting for the following 2-bit input…

A: Given data, A 2 bit counter T flip flops are used which changes the output when the input changes.

Q: A three-phase, 60-Hz, 69-kV transmission line has an inductance of 1.0531 mH/Km per phase and a…

A: In this question,  We need to choose the correct options What is the transmission line parameter A?…

Q: Q3: Region! (x0) is dielectric with & Find Eti, E1, E2, D2, D2, D2 3, region2 (x<0) is a perfect…

A:

Q: C/ Design 2-bit synchronous sequential circuit that can-do counting for the following 2-bit input…

A: Given data, A 2 bit counter A 'T' flip flop is used when output changes and input changes.

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.