b) G(?)=K [(S−1)(S−2) / (S+2)(S+3)] ; Construct nyquist curves for K=1, 5/3, 9 values. Write down the Nyquist stability criterion and explain whether the system is stable or not. c) Define the gain and phase margin, this time on the nyquist curve.

b) G(?)=K [(S−1)(S−2) / (S+2)(S+3)] ; Construct nyquist curves for K=1, 5/3, 9 values. Write down the Nyquist stability criterion and explain whether the system is stable or not. c) Define the gain and phase margin, this time on the nyquist curve.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.16P

See similar textbooks

Related questions

Q: The sinusoidal signal x(t} = 3 cos(200t + 7/6) is passed through a square-law device defined by the…

A: Need to find dc component and specify amplitude and fundamental frequency

Q: Q1. Using Thevenin's theorem, perform the conversion showed in the image below. Perform transient…

Q: For the circuit shown ,if the switch on at t=0, determine Vr, ir and vz as a function of time Ro

A: This circuit has a switch and is opened for a long time. It will close at time t=0. a) t=0, (t<0)…

Q: 8.16.2 For the RLC circuit shown in the image below, assume the circuit has long reached steady…

A: The solution is given below

Q: In the circuit shown below, R = 200.0 Q, L= 0.200 H, C = 0.100 mF and the AC source is given by ɛ =…

A: To calculate voltage across resistor

Q: 8.26 Draw the frequency-domain network and calculate v,(t) in the circuit shown in Fig. P8.26 if…

A: In this question, We need to draw the circuit in the frequency domain and also find the voltage vo…

Q: A series RLC circuit is constructed using component values R = 100 2 and L = 1.5 mH along with a…

A: Current: This is the time rate of the change of charges and its unit is ampere.

Q: A series RLC circuit is constructed employing component values R = 100 Sa and L = 1.5 mH along with…

A: In this we will find Capacitance C with help of data...And find impedance and current for series…

Q: Suppose that in the RLC circuit below, a voltage of Vin = 6 sin(5t) is applied at t = 0, when Vc(0)…

A: The current flowing through the capacitor can be written as: It=CdVCtdt Here, I represents the…

Q: Problem 2: in the RC circuit shown, the switch is closed on position 1 at t-0 and then moved to…

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: 3.7-1 Show that the energy of the Gaussian pulse 1 g(t) = from direct integration is 1/20 a. Verify…

Q: weite the equation of the Qc sine conditions Ye ミ220V, T = 20mg,=/2 ९१०० wave having the following…

A: given data: maximum value of voltage vp = 220 V Time period = 20 ms angle ϕ = π/2

Q: 7576 A time domain representation of a signal generally expresses how a signal changes with respect…

A: In this question we will write about time domain representation of signal...

Q: 8.47.1 For the RLC circuit shown in the image below, assume the circuit has long reached steady…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: For each of the following characteristic equations, a) Sketch the root locus plot for 0 < K< b) Find…

A: "Since you have posted a question with multiple sub parts we will solve first three subpart for you…

Q: Transient analysis: 1) Use Thevenin's theorem to convert the circuit of Figure 1 to the circuit of…

A: In this question, Find the current in the capacitor using the Thevenin and super position theorems.…

Q: For the circuit shown ,if the switch on at t=0 , determine Vr, ir and vz as a function of time Ro

Q: The sinusoidal signal x(t) = 3 cos(200t + a/6) is passed through a square-law device defined by the…

A: x(t) = 3cos(200t + pi/6) is passed through a square law device defined by the input- output…

Q: For the network shown in Figure (Q5), the switch (1) has been closed and switch (2) has been opened…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: The voltage applied to the circuit shown at t=0 is20 cos(800t+25∘) V. The circuit resistance is 80…

Q: d. The function exp(t)= Aexp(-t/t)=Ae“ is the (decaying) exponential function, where t=1/a is called…

A: Given: ejθ=cosθ+jsinθ ....1rt=5+10 cos3.14t-45° Put -θ instead of θ in above equation 1:…

Q: Evaluate the following :complex integral Inz dz, where closed curve is |z| = 1

A: Given Complex integral ∮lnzz-π42dzclosed curve is z=1

Q: 9. In the non-sinusoidal periodic current circuit shown in Fig. 9, R=20SN, L=20mH, 50 G = 50µF, C,…

A: Periodic Signal: A signal x(t) is said to be periodic if it repeats itself after finite amount of…

Q: The sinusoidal signal x(t) = 3 cos(200t + 7/6) is passed through a square-law device defined by the…

A: A sinusoidal signal is represented as x(t)=A sinωt+θ or A cosωt+θ Here there is no DC component. But…

Q: ) A current of 250mA flows through a perfect inductor, when it is connected to a 5V, 1kHz supply.…

A: Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If…

Q: From the circuit, find the voltage drop across the capacitor. Let v.(1) = 4 u(t) V and at time t=0…

A: The solution is given below

Q: In an RLC series circuit, the voltage amplitude and frequency of the source are 100 V and 500 Hz,…

A: According to guidelines we need to solve only the first three subparts. According to the question we…

Q: Electrical Engineering Gcopper = 5.813×10" (Nm)', µo=4xx107 H/m, o-8.85x1012 F/m a) Find the high…

A: Given: Consider the parameters: σcopper=5.813×107 Ωm-1μo=4π×10-7 H/mεo=8.85×10-12 F/m To find: (a)…

Q: Problem 10.9 For the circuit shown in Fig. 10.7, find the current at t> switch is closed at t = 0.…

Q: Example (1): A discrete time system has a unit sample response h(n) h(n) = 0.5 8(n) + d(n – 1) + 0.5…

A: Here the question has multiple sub-parts.we will answer only one part because you didnt mention…

Q: A periodic waveform with w0 = 10^5 rad/s is applied to a circuit as shown in Fig. P3.2.3. Determine…

A: Given the value of the angular frequency: Now the 50th harmonic is given as:

Q: In the following True or False and Multiple-Choice problems, circle the correct answer. 1. A stable…

A: 1. FALSE A system is said to be stable, if it produces bounded output for bounded input.

Q: abre em t-0 Rbat 20 Chave N.F. L 0,5 H Vbat 24 V V 0,02 F R the

Q: The sinusoidal signal x(t) = 3 cos(200t + a/6) is passed through a square-law device defined by the…

A: Given x(t) is x(t)=3cos(200t+π/6) When the signal x(t) is passed through the non-linear device the…

Q: A circuit is operated at its resonant frequency, which is designed to be 240 Hz. The circuit…

Q: For the circuit of Fig. 10.51, if i, = 5 cos 10r A, use a suitable complex source replacement to…

A: We will convert the above circuit into phasor domain. The source will be replaced as:…

Q: 9.31 a) For the circuit shown in Fig. P9.31, find the steady- state expression for v, if i̟ = 25 cos…

A: For the circuit shown above For i g =25cos50000t mA Steady state expression for v0 is calculated…

Q: Q2) The equation for FM wave is s(t) = 11 cos [559203492t + 166 cos 4078t] Find the following:…

Q: The sinusoidal current source in the circuit produces the current I= 8 cos 100000t A. a) Construct…

A: The inductive reactance of the inductor is: ωL=100000*60*10-6ωL=j6Ω The capacitive reactance of the…

Q: The terminal points determined by pi/2, pi, -pi/2, 2pi are __________, ________, ___________, and…

A: Given: The values are shown below:

Q: Questions ??-??. Consider an ideal RLC series circuit shown in the figure below. The current in the…

Q: a. Assuming that the circuit is balanced, that is, that Vab = 0, determine X4 in terms of the…

A: In a Wheatstone bridge, It contains four pure resistive branch R1, R2, R3 and R4. To identify the…

Q: Why is the following situation impossible? The LC circuit as shown has L = 30.0 μH and C = 50.0 μF.…

A: The energy stored in the capacitor is given by the expression as shown below: E=12CV2 The voltage…

Q: 8.16.2 For the RLC circuit shown in the image below, assume the circuit has long reached steady…

Q: 1) (G-). x1(t) = 2 cos and r2(t) = 2 – 4 sin %3D %3D do the following: (a) Find the fundamental…

Q: Consider the system shown in the Figure below: R(s) + Gc(s) K G(s) 1 s(s² + 2s + 5) imaginary axis.…

Q: The relaxation time of mica (G = 10-15 mho/m, ɛ, = 4) is %3D 7.36 hrs 2.456 hrs 4.912 hrs 9.82 hrs

Question

b) G(?)=K [(S−1)(S−2) / (S+2)(S+3)] ; Construct nyquist curves for K=1, 5/3, 9 values. Write down the Nyquist stability criterion and explain whether the system is stable or not.

c) Define the gain and phase margin, this time on the nyquist curve.

(s-1)(s-2)
G(s) = K-
K=1, 5/3, 9
(s+2)(s+3)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 6 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Recommended textbooks for you

Power System Analysis and Design (MindTap Course …

Electrical Engineering

ISBN:

9781305632134

Author:

J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:

Cengage Learning