Answered: (b) In which encoding scheme Nyquist…

(b) In which encoding scheme Nyquist theorem is used and Why? Explain complete procedure of that Encoding scheme with example with the advantages and Disadvantages of this theorem.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

ChapterS: Safety, Basic Electricity And Ohm's Law

Section: Chapter Questions

Problem 8RQ: What is an MSDS?

See similar textbooks

Related questions

Q: In PCM, assuming uniform quantization, what is the signal to noise ratio in dB for 12-bit code word?

A: Quantization is process in which the continuous amplitude signal is converted in to discrete…

Q: 288 For the Timing Waveform Diagrams shown below, which is the corect drawing for a NOR gate? A.…

Q: 2.Why do the absolute angular encoders utilize Gray code for encoding the angle? What would be the…

A: Absolute encoders are used to determine the true angular location. Incremental encoders, on the…

Q: Draw a block diagram of a typical digital communications system (both transmit and receive paths)…

A: Given We need to draw the block diagram of digital communications system and explain source encoder…

Q: B. Write a VHDL code for designing (2-to-1) 1-bit Multiplexer using an TI statement.

A: Let input to mux are i0,i1 Select line is s Output y

Q: (b) For a system transfer function H(z), why must there not be more finite zeros thar finite poles…

A: In this question we will write how causal system have more poles than zeros...

Q: b) Draw a block diagram of a typical digital communications system (both transmit and receive paths)…

A: Communication System: A communications system, often known as a communications network, is a…

Q: Design a 4-bit up/down gray counter?

Q: Data at a rate of 7 kbits/sec is to be transmitted over a leased line of bandwidth 4 kHz using…

A: Given Data Rate R=7K bits/sec Bandwidth B=4 KHz We have to calculate the value of roll‐off…

Q: 7.3-1 Data at a rate of 6 kbit/s is to be transmitted over a leased line of bandwidth 4 kHz by using…

A: The solution can be achieved as follows.

Q: Design don't-care conditions. an excess-3-to-binary decoder using the unused combinations of the…

A: Design an excess 3 to binary decoder using the unused combinations of the code as dont care…

Q: What is the ideal percentage of modulation for maxi- mum amplitude of information trans mission?

Q: What is load-line analysis? How does it help? Ex

A: From the circuit Apply KVL V-IDRL-VD=0V=IDRL+VDWhen VD=0V=IDRL+0ID=VRLwhen VD =0

Q: What is the difference between UTP and STP cables, show diagrams?

A: The differences between the UTP and STP cables are listed in the table shown below: UTP cables…

Q: Specifically describe in a real world application scenario how virtualization is different from…

A: Networking- In technological term A network is a collection of computers, servers and other devices…

Q: or Delta modulator, how many bits transmitted per sample?

A: In this case ,the number of bits transmitted per sample for a delta modulator is to be determined.

Q: a) (no +35), =(?), = (?), = (?),6 b) Calculate the following subtraction using 10's complement…

Q: (b) What are the noise considerations in PCM? Explain the TDM-PAM concept.

A: Basic problem on communication system. Look below for the solution once..

Q: Consider a CDMA system where transmitter A has the code 101010 and transmitter B has the code…

A: The given CDMA system transmitter A code is 101010. The given CDMA system receiver B code is 111001…

Q: Design an 8-to-1-line multiplexer using a 3-to-8 line decoder and external gates

A: A multiplexer is combinational circuit that select one of the inputs to the output. The select line…

Q: 5. A circuit-switch TDM-link uses 512-bit frames with 24 slots. a) How many circuits' are allocated…

Q: From the given circuit, derive the simplified NOR circuit and identify the TTL ICs in the design &…

A: The circuit is as shown below, We need to derive the simplified NOR circuit and identify the TTL…

Q: In a digital communication,explain all the methods/mechanism used or the minimization of Bit error…

A: The MCJD in 'M' part of radio wires are utilized to diminish the Bit Error Rate (BER) and MC-CDMA…

Q: Choose the VHDL architecture that describes the correct corresponding function by completing the…

A: Architecture 1 is as shown below,

Q: What is the probability of error with a PSK system with a bit rate of 20kpbs, BW of 50 kHz, Noise…

A: The solution is given below

Q: On the diagram below, depict how the bit stream '01100011 would be represented using Bipolar NRZ…

A: According to the question, we need to draw Bipolar NRZ for the given stream 01100011.

Q: What is a bipolar line coding technique with phase encoding, and explain why it is named as phase…

A: In the bipolar line coding technique with phase encoding, there are three levels of the voltage…

Q: a) Draw the neat labeled diagram of four pair 10BaseT cable? b) Write any four disadvantages of the…

A: 10 baseT was a type of standard for implementing ethernet network using unshielded twisted pair…

Q: This elementary problem begins to explore propagation delay and transmission delay, two central…

Q: Construct a 4-to-16-line decoder with five 2-to-4-line decoders with enable. Use block diagrams.

Q: In a digital communication, explain all the methods/mechanism used for the minimization of Bit Error…

A: The methods which are used for minimisation of Bit Error rate is as follows: WDFE beneficiaries got…

Q: Q4. Consider the QPSK digital modulation scheme (a) What does the abbreviation QPSK stand for? (b)…

Q: Explain the block diagram of super heterodyne of SSB receiver?

Q: Design an 8-to-1-line multiplexer using a 3-to-8 line decoder and external gates.

Q: What are some disadvantages of designing a global communication system with a LEO constellation that…

A: The disadvantages of designing a global communication system with an LEO constellation that requires…

Q: What are the functions of encoder, Decoder, multiplexers explain with truth table and give…

A: FUNCTION OF ENCODER: It is a circuit that is used to convert the given data from one format to…

Q: equations for the kmap table below

A: In this question, Write the equations for the K-Map. f(A, B, C, D)?

Q: Done El + @ Estimate the percentage change of power for a DSB-SC AM system when the value of the…

A: Given information: For a DSB-SC AM system, the modulation index changes from 0.6 to 0.9. The…

Q: How many states the PN sequence generator of DB20 have? • What is the length of PN sequence…

A: To find the states and length of the PN sequence generator of DB20

Q: 2. What is the minimum B. Wrequired to nodulate the voice signal by using AM-DSB -SC? 3. Why we used…

Q: QUESTION 3 For a two channel Maximal Ratio Combining system, the outage occurs when signal-to-noise…

Q: a. The below mentioned diagram refers to the differential Manchester encoding scheme. Please…

Q: What is the biggest disadvantage of the ASK scheme?

Q: Sketch the Bipolar RZ Voltage encoding on a classic Ethernet for the bit stream 0001110101.

A: RZ (Return to Zero) is a line coding system used wherein the signal returns to zero between each…

Q: 1.What is predecoding in decoders? how to implement predecoding with NAND and NOR gates?

A: Bartleby has policy to solve only first question. Reupload the question

Q: explain the aliasing in the PAM Signal?

A: The analog pulse modulation techniques are classified into three types, which are mentioned as…

Q: Suppose that a voice signal-has x(t)[ma=2V and average pov- -quals to 0.25W. Calculate the value of…

A: DSB-SC only has side bands so power of DSB is nothing but the power of side bands(PSB) . Hence…

Question

(b) In which encoding scheme Nyquist theorem is used and Why? Explain complete procedure of that Encoding scheme with example with the advantages and Disadvantages of this theorem.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

explain what is meant by VSB transmission. What are the advantages and usage.
In which encoding scheme Nyquist theorem is used and Why?
Using Verilog continuous assignment statements or VHDL signal assignment statements, write a description of the circuit shown in
What is the difference between UTP and STP cables, show diagrams?
Define the decoders and the encoders, and what functional differences exist between them?
Every DT signal can be described by a linear combination of scaled and shifted unit samples. True or false? Explain.
Assume that a voice channel occupies a bandwidth of 4 kHz. We need to combine three voice channels into a link with a bandwidth of 12 kHz, from 20 to 32 kHz. Show the configuration, using the frequency domain. Assume there are no guard bands in computer communication and network?
5) What are the functions of encoder, Decoder, multiplexers explain with truth table and give applications of each?
What is the best-case rising delay a standard size three-input NAND gate that does not have an external load, written in terms of RC (numerical result only)?
This is a practice question (not a graded assignment) from my Digital Systems lab course. The first part was to create a schematic from 2:4 decoder truth table using only NAND gates. This was done, as you can see, and is correct. Now, we're supposed to write the VHDL code for a module named "2x4_Decoder" that implements the NAND gate schematic using gate terminology and the labels from the schematic, as well as a test bench for it. I'm completely lost. All we've done so far is simple individual gates, nothing with multiple gates or connections (it's our second week in VHDL). If I could see a complete, working example for this, I could probably figure out other implementation configurations. Thank you for your assistance.
On our MCS, which chip is used for uni-directional bus buffering? 74LS
2.Why do the absolute angular encoders utilize Gray code for encoding the angle? What would be the angular error in the encoder with an 8-bit Gray code?